remove seats Peugeot 607 Dag 2002.5 Owner's Manual
[x] Cancel search | Manufacturer: PEUGEOT, Model Year: 2002.5, Model line: 607 Dag, Model: Peugeot 607 Dag 2002.5Pages: 171, PDF Size: 2.22 MB
Page 91 of 171
15-07-2002
YOUR 607 IN DETAIL93
THE SEATS Manual front seats
1 - Forwards-backwards adjustment
Lift the lever and slide the seat forwards or backwards.
2 - Seat cushion angle adjustment *
Raise the catch while pressing on or easing off the seat back to obtain the required height.
3 - Driver's seat height adjustment* Raise the catch to obtain the required height.
4 - Seat back angle adjustment Raise the catch to obtain the required angle.
5 - Lumbar adjustment *
Raise or lower the lever to obtain the correct position.
6 - Head restraint height adjustment The head restraint has a frame with notches whichprevent the head restraint dropping down (safety
device in the event of an impact).
To raise the head restraint, push it upwards.
The setting is correct when the upper edge of the head restraint is level with the top of the head.
To lower the head restraint, it is necessary to pushsimultaneously : Ð
the button located on the base of the head restraint frame,
Ð the head restraint downwards.The head restraint angle is also adjustable.
To remove the head restraint, lift it out by pressing the lug.
Warning : never drive with the head restraints removed; they
must be in place and correctly adjusted.
* Driver's seat only.
Page 92 of 171
15-07-2002
YOUR 607 IN DETAIL
94
Electric front seats
A - Forwards-backwards adjustment
Push the control forwards or backwards to slide the seat.
B - Seat cushion angle adjustment Tilt the front of the control upwards or downwards toobtain the required angle.
C - Seat height adjustment Tilt the rear part of the control upwards or downwardsto obtain the required height.
D - Seat back angle adjustment Tilt the control to the front or the rear to obtain the cor-rect angle.
E - Lumbar adjustment (mechanical adjustment) Raise or lower the lever to obtain the correct position.
F - Head restraint height adjustment Tilt the control upwards or push it downwards to obtainthe correct height.
The setting is correct when the upper edge ofthe head restraint is level with the top of thehead.
The head restraint angle is also adjustable manually.
To remove the head restraint, tilt the seat back to 45¡ and place the head restraint in the high position, thenpull with both hands.
Note: the electrical functions of the driver's seat are inoper-
ative three minutes after the ignition has been switched off.
Page 94 of 171
15-07-2002
YOUR 607 IN DETAIL
94
Electric front seats
A - Forwards-backwards adjustment
Push the control forwards or backwards to slide the seat.
B - Seat cushion angle adjustment Tilt the front of the control upwards or downwards toobtain the required angle.
C - Seat height adjustment Tilt the rear part of the control upwards or downwardsto obtain the required height.
D - Seat back angle adjustment Tilt the control to the front or the rear to obtain the cor-rect angle.
E - Lumbar adjustment (mechanical adjustment) Raise or lower the lever to obtain the correct position.
F - Head restraint height adjustment Tilt the control upwards or push it downwards to obtainthe correct height.
The setting is correct when the upper edge ofthe head restraint is level with the top of thehead.
The head restraint angle is also adjustable manually.
To remove the head restraint, tilt the seat back to 45¡ and place the head restraint in the high position, thenpull with both hands.
Note: the electrical functions of the driver's seat are inoper-
ative three minutes after the ignition has been switched off.
Page 137 of 171
15-07-2002
YOUR 607 IN DETAIL
132
For the air bags to be fully effective, observe the following safety precautions:
¥ Wear a correctly adjusted seat belt.
¥ Sit in a normal, upright position.
¥ Do not leave any accessories, objects or pets between the occupants and the air bags. This could hinder the operation of the air bags or injure the occupants.
¥ All work on the air bag system is strictly prohibited unless it is carried out by an approved PEUGEOT dealer.
¥ After an accident or if the vehicle has been stolen or broken into, have the air bag systems checked.
¥ The air bag systems have been designed to be fully operational for 10 years from the date of vehicle registration.
For added safety, have them checked by a PEUGEOT dealer within 10 years of purchase of the vehicle.
Front air bags ¥ Do not drive holding the steering wheel by its spokes or with your hands on the centre pad of the steering wheel.
¥ Never remove or pierce the steering wheel or hit it violently.
¥ Refrain from smoking as much as possible; deployment of the air bag can cause burns or the risk of injury from a cigarette or a pipe.
Side air bags ¥ Do not fasten or glue anything to the backs of the front seats; this could cause injury to the chest or arms when theside air bag inflates.
¥ Do not sit with the upper part of the body any nearer to the door than is necessary.
¥ Only put approved covers on the seats. Contact your PEUGEOT dealer.
Curtain air bags ¥ Do not fasten or glue anything to the door pillars or to the roof as this could cause head injuries when the curtain airbag inflates.
Page 139 of 171
15-07-2002
YOUR 607 IN DETAIL
132
For the air bags to be fully effective, observe the following safety precautions:
¥ Wear a correctly adjusted seat belt.
¥ Sit in a normal, upright position.
¥ Do not leave any accessories, objects or pets between the occupants and the air bags. This could hinder the operation of the air bags or injure the occupants.
¥ All work on the air bag system is strictly prohibited unless it is carried out by an approved PEUGEOT dealer.
¥ After an accident or if the vehicle has been stolen or broken into, have the air bag systems checked.
¥ The air bag systems have been designed to be fully operational for 10 years from the date of vehicle registration.
For added safety, have them checked by a PEUGEOT dealer within 10 years of purchase of the vehicle.
Front air bags ¥ Do not drive holding the steering wheel by its spokes or with your hands on the centre pad of the steering wheel.
¥ Never remove or pierce the steering wheel or hit it violently.
¥ Refrain from smoking as much as possible; deployment of the air bag can cause burns or the risk of injury from a cigarette or a pipe.
Side air bags ¥ Do not fasten or glue anything to the backs of the front seats; this could cause injury to the chest or arms when theside air bag inflates.
¥ Do not sit with the upper part of the body any nearer to the door than is necessary.
¥ Only put approved covers on the seats. Contact your PEUGEOT dealer.
Curtain air bags ¥ Do not fasten or glue anything to the door pillars or to the roof as this could cause head injuries when the curtain airbag inflates.
Page 156 of 171
15-07-2002
The electrical system of your vehicle is designedto operate with standardor optional equipment. Before installing other
electrical equipment or acces- sories on your vehicle, contact a
PEUGEOT dealer. PEUGEOT will not accept respon- sibility for the cost incurred inrepairing your vehicle or for rectify-ing the malfunctions resulting fromthe installation of accessories notsupplied and not recommended byPEUGEOT and not installed inaccordance with its instructions, inparticular where the equipment in question consumes more than10 milliamperes. *Maxi fuses provide additional protection for electrical systems.All work must be carried out by
your PEUGEOT dealer.
PRACTICAL INFORMATION 149
Engine compartment fuses Fuse box
To access the fuses located in the engine compartment (next to the bat-tery) :
remove the style cover and unclip
the cover.
After carrying out the work, close the cover very carefully and
replace the style cover.
Fuse N¡ Rating Functions 1* 70 A Built-in systems interface ( heated rear screen - heated exterior mirrors - windscreen wiper -screenwash - headlamp wash).
2* 50 A Fan.
3* 50/60 A ESP pump motor / ABS hydraulic unit.
4* 40 A Air conditioning blower.
5 20 A Horn - Horn control relay.
6 20 A Left front and rear heated seats.
7 20 A Right front and rear heated seats.
8* 70 A Built-in systems interface.
9* 30 A Passenger electric seat.
Page 160 of 171
15-07-2002
PRACTICAL INFORMATION151
CHANGING A WINDSCREEN WIPER BLADE Placing the wiper blades in the maintenance position Less than one minute after switch-
ing off the ignition, activate thewindscreen wiper stalk to positionthe blades in the centre of thewindscreen (maintenance posi-tion).
Replacing a blade Lift the arm, then unclip the bladeand remove it.
Fit the new blade and fold downthe arm.
To park the blades, switch on theignition and operate the wind-screen wiper stalk.
REMOVING A MAT When removing a mat on the driver's or passenger's side, push back theseat as far as possible and removethe clips.
To remove a rear mat, push the cor- responding front seat forward andremove the clip. On refitting, position the mat and press firmly to refit the securing clips.
LOAD REDUCTION When driving, certain functions (heated rear screen, heating systemfor passenger compartment of diesel
vehicles, etc.) may be switched off
temporarily, depending on the levelof battery charge. Reactivation of the functions on standby is automatic, as soon as thebattery permits.
A flat battery prevents the engine from starting.
ECONOMY MODE FUNCTION After the engine has stopped, certain
functions (windscreen wiper, electricwindows, sunroof, rear electric blind,electric seats, audio equipment, tele-phone etc) can only be used for thir-ty minutes, to prevent discharging
the battery.
Once the thirty minutes are over, the message
"Economy mode active"
appears on the multiÐfunction dis-play and the active functions are put
on standby. These functions are automaticallyreactivated next time the vehicle isdriven. Note:
if the telephone is being used
when economy mode starts, it will still be possible to finish the call.