wheel PEUGEOT BOXER 2002 Owner's Manual

16-09-2002
Removing the wheel ☞Place a chock under the wheel diagonally opposite to the one tobe changed.
☞ Remove the trim, using thewheelbrace 4, pulling at the valve
passage hole.
☞ Loosen the wheel bolts using thewheelbrace 4.
☞ Place the jack 1in contact with
one of the four locating points E
on the sub-frame, (the one whichis closest to the wheel to bechanged).
☞ Extend the jack 1using the rat-
chet spanner 2until its base is in
contact with the ground. Ensurethat the centre line of the base ofthe jack is straight above thelocating point E. ☞
Raise the vehicle.
☞ Unscrew the bolts and removethe wheel.
Fitting a wheel ☞ Position the wheel.
☞ Tighten the bolts by hand.
☞ Partly tighten the bolts using the wheelbrace 4.
☞ Fold the jack 1and remove it.
☞ Fully tighten the bolts using thewheelbrace 4.
☞ Replace the wheel trim, startingby placing the wheel trim notchopposite the valve, and press iton using the palm of the hand.
☞ Put the tools and the wheel backin the boot. For your safety, always change the wheel: - on level, stable, non-slip- pery ground,
- with the handbrake on and the ignition switched off,
- with first or reverse gear enga- ged (position Pfor the automatic
gearbox),
- with the vehicle chocked. Never go underneath a vehicle that is supported only by a jack(use a ramp) After changing the wheel: - have the tightening of the bolts and the tyre pressure checkedby a PEUGEOT dealer as soonas possible,
- have the punctured tyre repai- red and refit it to the vehicle assoon as possible.
PRACTICAL INFORMATION
146

16-09-2002
Fuse no. Rating Functions
8 30 AWash-wipe pump.
9 15 AHeadlamps and fog lamps.
10 15 A Horn - Steering wheel lever control.
11 15 AEngine management control unit (secondary).
14 10 A Right dipped headlamp.
15 10 A Left dipped headlamp.
16 7,5 A Engine management control unit supply - Transponder.
17 10 A Engine management control unit (primary).
18 7,5 A Engine management control unit - Transponder.
19 7,5 A Air conditioning compressor.
20 30 A PTC.
21 15 A Fuel pump.
22 20 A Engine management control unit (primary).
23 10 A Automatic gearbox.
24 15 A Automatic gearbox.
30 15 A Left and right main beam headlamps.
PRACTICAL INFORMATION
154

16-09-2002
TOWING YOUR VEHICLE
W ithout lifting (4 wheels on the ground)
Y ou must always use a tow bar.
The towing eyes are located at the front and the rear under the vehicle's bumpers. Lifting (2 wheels only on the ground) It is preferable to raise the vehicle with a professional lifting device. Special features of the automatic gearbox When towing with four wheels on the ground, the following rules must beobeyed: -
lever in position N,
- tow the vehicle at less than
50 km/h over a maximum distanceof 50 km,
- do not add oil to the gearbox.
PRACTICAL INFORMATION 157
When towing with the engine switched off, thereis no braking or steeringassistance.

16-09-2002
PRACTICAL INFORMATION159
ACCESSORIES FOR YOUR BOXER
For your PEUGEOT only use accessories and original parts approved by the manufacturer.
These accessories and parts are all adapted to your PEUGEOT, after being tested and approved for reliability and safe-
ty, which PEUGEOT cannot guarantee for other products. A
wide choice of original accessories, approved by PEUGEOT, is available through the dealer network. They all carry
the PEUGEOT guarantee: – Safety : Fog lamps, driver/rear doors separation grilles, anti-theft alarms, window engraving, wheel locks, window protection film, first aid kit, warning triangle, ...
– Comfort : Covers with and without air bags, mats, luggage net, door deflectors, CD storage, sidewindows, thermoformed protectors, wood or metal fittings, mud flaps, ...
– Communication : Audio systems, telephone, hands-free kit, speakers, CD changer, navigation sys-tems,...
– Leisure : Tow bars, snow chains, roof bars with sill plate, ladder, loading roller, ...
– Maintenance products : Screenwash, interior and exterior maintenance and cleaning products, ...
Before installing any electrical accessory on your vehicle, contact a PEUGEOT dealer.

16-09-2002
TECHNICAL DATA
180
THE IDENTIFICATION FEATURES OF YOUR BOXER
A. Manufacturer's plate.Plate Ais located to the left of the bonnet release system.
B. Serial number (located on the left, at the passenger door sill).
C. Tyres The label Con the passenger door pillar indicates:
Ð the wheel and tyre sizes,
Ð the tyre pressures (the tyre pressure must be checked when the tyre is cold, at least once a month) .
D. Paint colour reference. The label Dis located under the bonnet at the bottom left.