boot Peugeot RCZ 2011 User Guide
[x] Cancel search | Manufacturer: PEUGEOT, Model Year: 2011, Model line: RCZ, Model: Peugeot RCZ 2011Pages: 276, PDF Size: 51.24 MB
Page 58 of 276
56
OPERATING FAULT
AUTOMATIC ACTIVATION *
LOCKING THE VEHICLE WITHOUT ACTIVATING
THE ALARM
)
Lock or deadlock the vehicle using the key in the driver's door lock.
When the ignition is switched on, fi xed illumination of the indicator lamp
in the button indicates a fault with the system.
Have it checked by a PEUGEOT dealer or a qualifi ed workshop.
2 minutes after the last door or the boot is closed, the system is
activated automatically.
)
To avoid triggering the alarm on entering the vehicle, fi rst press the
unlocking button on the remote control.
* According to country.
FAILURE OF THE REMOTE CONTROL
To deactivate the monitoring functions:
)
Unlock the vehicle using the key in the driver's door lock.
)
Open the door; the alarm is triggered.
)
Switch on the ignition; the alarm stops. The indicator lamp in the
button goes off.
TRIGGERING OF THE ALARM
The monitoring functions remain active until the alarm has been
triggered eleven times in succession.
When the vehicle is unlocked using the remote control, rapid
fl ashing of the indicator lamp in the button informs you that the
alarm was triggered during your absence. When the ignition is
switched on, this fl ashing stops immediately.
This is indicated by sounding of the siren and fl ashing of the direction
indicators for thirty seconds.
Page 61 of 276
2/
ACCESS
DOORS
OPENING
From outside
)
After unlocking the vehicle completely using the remote control or
the key, take hold of the door handle then pull it.
The window lowers automatically by a few millimetres to permit
opening of the door.
In freezing conditions, the presence of ice may hinder the automatic
partial opening of the window; remove the ice which may have
formed along the lower seal, located at the base of the window.
When the selective unlocking is activated, the fi rst press of the
remote control unlocking button permits unlocking of the driver's
door only.
From inside
)
Pull the door control to open the door; this unlocks this vehicle
completely.
The window lowers automatically by a few millimetres to permit
opening of the door.
With the selective unlocking activated:
- the driver's door control unlocks the driver's door and the fuel
fi ller fl ap only.
- the passenger's door control unlocks the passenger's door
and the boot.
The interior door controls do not operate when the vehicle is
deadlocked. If you leave the door open for more than one minute, the window
rises again.
Pull the handle again to reactivate the system.
Page 62 of 276
60
CLOSING
The window rises automatically after a few seconds and adjusts to
provide perfect sealing when closed.
- when the engine is running
, this warning lamp comes on,
accompanied by a message in the screen for a few seconds,
CENTRAL LOCKING CONTROL
This control permits simultaneous locking or unlocking of the doors,
boot lid and fuel fi ller fl ap from inside the vehicle.
Locking
)
Press this button to lock the vehicle.
The red indicator lamp on the button comes on.
If one of the doors or the boot lid is open, the central locking from
the inside does not take place.
Unlocking
)
Press this button again to unlock the vehicle.
The red indicator lamp on the button goes off.
Locking/deadlocking from the outside
When the vehicle is locked or deadlocked from the outside, the
red indicator lamp fl ashes and the button is inactive.
)
With normal locking, pull on the interior door control lever to
unlock the vehicle.
)
With deadlocking, you have to use the remote control or the
key to unlock the vehicle.
When washing your vehicle:
- fi rst lock the vehicle using the remote control or the key,
- avoid spraying the upper part of the windows,
- keep the end of the high pressure nozzle at least 1 metre from
the windows and door seals.
When a door is not closed correctly: Be aware of the risk of pinching when the window rises
automatically on closing the door.
- when the vehicle is moving
(speed higher than 6 mph (10 km/h)),
this warning lamp comes on, accompanied by an audible signal and
a message in the screen for a few seconds.
Page 63 of 276
2/
ACCESS
Pressing the central locking control unlocks the vehicle.
Opening a door from the inside, when stationary, also unlocks the
vehicle, but the vehicle will be locked again when the speed exceeds
6 mph (10 km/h).
Activation/Deactivation
You can activate or deactivate this function.
)
With the ignition on, press the button for more than two seconds.
A confi rmation message appears in the screen.
In the event of a serious impact with triggering of an airbag, the
vehicle's doors unlock automatically to allow the occupants to exit.
EMERGENCY LOCKING
To lock or unlock the doors mechanically in the event of a central
locking system failure or fl at battery.
Locking the driver's door
)
Insert the key in the lock, then turn it to the right.
Unlocking the driver's door
)
Insert the key in the lock, then turn it to the left.
Locking the passenger door
)
Using the key, remove the black cap on the edge of the door.
)
Insert the key in the cavity without forcing, then without turning it,
move the the latch sideways towards the interior of the door.
)
Remove the key and refi t the cap.
Unlocking the passenger door
)
Pull the interior door opening control.
ANTI-ATTACK SECURITY
This function permits automatic and simultaneous locking of the doors,
boot lid and fuel fi ller fl ap as soon as the vehicle speed exceeds 6 mph
(10 km/h).
Operation
If one of the doors is open, the automatic central locking does not take
place.
If the boot lid is open, the automatic central locking of the doors is
active.
Page 64 of 276
62
BOOT
OPENING
)
Press this button for more than two seconds to unlock
the boot lid. The boot lid opens slightly.
)
Lift the boot lid.
This action also unlocks the doors and the fuel fi ller fl ap.
Using the manual control; vehicle unlocked
)
Press the opening control above the number plate.
)
Lift the boot lid.
CLOSING
)
Lower the boot lid using one of the interior grab handles.
)
If necessary, press the top of the boot lid to close it fully.
If the boot lid is not closed correctly:
- when the engine is running
, this warning lamp comes on,
accompanied by a message in the screen for a few seconds,
When the selective unlocking is activated, the boot can be opened
at the second press of the unlocking button on the remote control.
Using the remote control
Emergency locking
If the central locking system fails (fl at battery), you are advised to
disconnect the battery.
- when the vehicle is moving
(speed above 6 mph (10 km/h)), this
warning lamp comes on, accompanied by an audible signal and a
message in the screen for a few seconds.
Page 73 of 276
3/
EASE OF USE AND COMFORT
ACCESS TO THE REAR SEATS
REAR SEATS
Two-seat bench with one-piece fi xed seat cushion and one-piece folding
backrest.
The rear headrests are fi xed.
FOLDING DOWN THE REAR BACKREST
RETURNING THE REAR BACKREST TO THE UPRIGHT POSITION
When returning the backrest to the upright position, ensure that it is
locked securely to assure your safety.
)
Open the boot.
)
Pull the backrest release handle, located under the shelf.
When transporting long objects, do not place a load of more
than 30 kg on the rear of the backrest.
Do not place rough objects on the rear of the backrest which
could damage it.
)
Check that the front seat has been moved forward suffi ciently.
)
Pull the control upwards to tilt the backrest.
When the seat is put back in place, the backrest returns to its initial position.
The backrest can be folded down to increase the boot storage space.
The backrest release control is located in the boot.
)
Check that the front seats have been moved forward suffi ciently.
)
Check that nothing has been left on the rear seats.
)
Store the seat belt buckles on their respective securing points
located between the headrests.
)
Fold the backrest down onto the seat cushion.
Page 75 of 276
3/
EASE OF USE AND COMFORT
In order for these systems to be fully effective, follow the operation
and maintenance guidelines below:
)
To obtain an even air distribution, take care not to obstruct
the exterior air intake grilles located at the base of the
windscreen, the nozzles, the vents and the air outlets, as well
as the air extractor located in the boot.
)
Do not cover the sunshine sensor, located on the dashboard;
this is used for regulation of the air conditioning system.
)
Operate the air conditioning system for at least 5 to 10 minutes,
once or twice a month to keep it in good working order.
)
Ensure that the passenger compartment fi lter is in good
condition and have the fi lter elements replaced regularly (refer
to the "Checks" section).
We recommend the use of a combined passenger
compartment fi lter. Thanks to its special active additive,
it contributes to the purifi cation of the air breathed by the
occupants and the cleanliness of the passenger compartment
(reduction of allergic symptoms, bad odours and greasy
deposits).
)
To ensure correct operation of the air conditioning system, you
are also advised to refer to the Warranty and Maintenance
Record for information on when it should be checked.
)
If the system does not produce cold air, switch it off and
contact a PEUGEOT dealer or a qualifi ed workshop.
When towing the maximum load on a steep gradient in high
temperatures, switching off the air conditioning increases the
available engine power and so improves towing performance.
The condensation created by the air conditioning results in a
discharge of water under the vehicle which is perfectly normal.
If after an extended stop in sunshine, the interior temperature is
very high, fi rst ventilate the cabin for a few moments.
Put the air fl ow control at a setting high enough to quickly change
the air in the cabin.
The air conditioning system does not contain chlorine and does
not present any danger to the ozone layer.
RECOMMENDATIONS FOR VENTILATION AND AIR CONDITIONING
Page 88 of 276
86
BOOT FITTINGS
1.
Stowing rings
2.
Storage net
3.
Storage box
(see details on following page)
Page 89 of 276
3/
EASE OF USE AND COMFORT
The duration of lighting varies, depending on the context:
- when the ignition is off, approximately ten minutes,
- in energy economy mode, approximately thirty seconds,
- when the engine is running, no limit.
STORAGE BOX
This has areas for storing a box of spare bulbs, a fi rst aid kit, the
temporary puncture repair kit, a warning triangle, the removable ball of
the towbar system...
BOOT LAMPS
Your vehicle is fi tted with two boot lamps; one in the right-hand boot
side trim and a second in the centre under the rear shelf.
They come on automatically when the boot is opened and switch off
automatically when the boot is closed.
They cannot be deactivated manually.
A second warning triangle can be stored in the boot lid trim. For access to it:
)
raise the fl oor using the strap,
)
secure it in the vertical position behind the stops, located on the
sides of the boot.
Page 109 of 276
5/
SAFETY
Before operating the spoiler, ensure that no one is in the proximity
of the moving parts to avoid any risk of injury.
Nevertheless, in the event of pinching, you must reverse the
movement of the spoiler. To do this, release the control button
then press it again to raise the spoiler.
MAINTENANCE
To maintain the spoiler, with the vehicle stationary, ignition on:
)
raise the spoiler to the maximum position B
by pressing the button
briefl y,
)
once the cleaning is complete, retract the spoiler: press and hold
the button until the end of the manoeuvre.
The keep this system in good working order, check the spoiler and its
housing periodically preventing the unwanted accumulation of leaves,
ice or snow.
OPERATING FAULT
If the control system fails, the indicator lamp in the control button
fl ashes, accompanied by an audible signal and a message in the
screen. As a safety precaution, the spoiler rises to the maximum
position, regardless of the speed of the vehicle.
If the problem persists and you wish to retract the spoiler:
)
stop where it is safe to do so,
)
switch off the ignition,
)
switch the ignition on again.
If the indicator lamp no longer fl ashes, the failure was temporary, the
system has resumed normal operation. To retract the spoiler, refer to
the paragraph "To exit from manual mode".
If the indicator lamp fl ashes again and the spoiler is still raised, the
system is still faulty.
Have it checked by a PEUGEOT dealer or a qualifi ed workshop.
In the event of a system operating fault (e.g. jamming of the spoiler), the
indicator lamp in the control button fl ashes, accompanied by an audible
signal and a message in the screen. For safety reasons, do not exceed
a speed of 85 mph (140 km/h).
Have it checked by a PEUGEOT dealer or a qualifi ed workshop.
Before washing the vehicle, always retract the spoiler into its
housing.
Keep the end of the high-pressure nozzle at least 1 metre from the
spoiler housing.
Never press on the spoiler to close the boot or push the vehicle as
this may damage it.
The installation of load-carrying accessories on the vehicle limits
the effectiveness of the spoiler.
Do not install load carrying accessories which are not
recommended by PEUGEOT.
To exit from manual mode:
)
press the button briefl y: the indicator lamp on the button goes off
(return to automatic mode).
At speeds below 6 mph (10 km/h), the spoiler stays in the open
position. It retracts automatically as soon as the vehicle exceeds
this speed threshold.