engine Peugeot RCZ 2014 Owner's Guide

5/
SAFETY
RCZ_EN_CHAP05_SECURITE_ED02-2013
REAR SEAT BELTS
The rear seats are each fi tted with a three-point inertia reel seat belt
with force limiter.
Fastening
1. Pull the strap and insert the tongue F in the black buckle F , in the
centre of the bench seat.
2. Insert the tongue G in the outer red buckle G .
3. Check that each buckle is fastened correctly by pulling the strap.
Unfastening
1. Press the red button on the buckle G , then the black button on the
buckle F .
2. Guide the strap as it reels in and bring the tongue G , then the
tongue F to the corresponding securing point on the backrest.
Seat belt unfastened warning lamps display
A. Rear seat belts unfastened warning lamp.
D. Rear right seat belt warning lamp.
E. Rear left seat belt warning lamp.
The warning lamp A comes on, either on in the seat belt and
passenger's front airbag warning lamps display, when one or more rear
passengers unfasten their seat belt.
From approximately 12 mph (20 km/h), this warning lamp fl ashes for
two minutes accompanied by an audible signal of increasing volume.
Once these two minutes have elapsed, this warning lamp remains on
until the one or more rear passengers fasten their seat belt.
When the ignition is switched on, with the engine running or the vehicle\

moving at a speed below approximately 12 mph (20 km/h),
the corresponding warning lamps D and E come on in red for
approximately 30 seconds, if the seat belt is not fastened.
When the vehicle is moving at a speed of more than approximately
12 mph (20 km/h), the corresponding warning lamp D or E comes on in
red, accompanied by an audible signal and a message in the screen,
if a rear passenger has unfastened their seat belt.
Unfastening is detected on both buckles of the seat belt. The
corresponding warning lamp comes on when at least one of the
two buckles is unfastened.

6/
DRIVING
IGNITION SWITCH
ELECTRONIC ENGINE IMMOBILISER
STARTING THE VEHICLE
 Insert the key in the ignition switch.
The system recognises the starting code.
 Turn the key fully towards the dashboard to position 3 (Starting) .
 When the engine starts, release the key.
SWITCHING THE VEHICLE OFF
 Immobilise the vehicle.
 Turn the key fully towards you to position 1 (Stop) .
 Remove the key from the ignition switch.
Key left in the "Ignition on" position
On opening the driver's door, an alert message is displayed,
accompanied by an audible signal, to remind you that the key is
still in the ignition switch at position 1 (Stop) .
If the key has been left in the ignition switch at position 2 (Ignition
on) , the ignition will be switched off automatically after one hour.
To switch the ignition back on, turn the key to position 1 (Stop) ,
then back to position 2 (Ignition on) .
The key contains an electronic chip which has a special code. When
the ignition is switched on, this code must be recognised in order for
starting to be possible.
A few minutes after the ignition is switched off, this electronic engine
immobiliser locks the engine management system and prevents starting
of the engine by anyone who does not have the key.
In the event of a malfunction, you are informed by lighting of this
warning lamp, an audible signal and a message on the screen.
In this case, your vehicle does not start; contact a PEUGEOT
dealer as soon as possible.
Switching off the engine leads to a loss of braking assistance.

6/
DRIVING
HILL START ASSIST
System which keeps your vehicle immobilised temporarily
(approximately 2 seconds) when starting on a gradient, the time it tak\
es
to move your foot from the brake pedal to the accelerator pedal.
OPERATION
This function is only active when:
- the vehicle is completely stationary, with your foot on the brake pedal,
- certain conditions of slope are met,
- with the driver’s door closed.
The hill start assist system cannot be deactivated.
Do not exit the vehicle while it is being held in the hill start assist \
phase.
OPERATING FAULT
On an ascending slope, with the vehicle stationary, the vehicle is
held for a brief moment when you release the brake pedal:
- provided you are in fi rst gear or neutral on a manual gearbox,
- provided you are in position D or M on an automatic gearbox. On a descending slope, with the vehicle stationary and reverse
gear engaged, the vehicle is held for a brief moment when you
release the brake pedal.
If you need to exit the vehicle with the engine running,
apply the parking brake and then check that the
corresponding warning lamp in the instrument panel is on.
If a malfunction of the system occurs, these warning lamps come on.
Have it checked by a PEUGEOT dealer or a qualifi ed workshop.

132
6-SPEED MANUAL GEARBOX
ENGAGING 5 TH OR 6 TH GEAR
 Move the lever fully to the right to engage 5 th or 6 th gear.
ENGAGING REVERSE GEAR
 Raise the ring under the knob and move the gear lever to the left then forwards.
Only engage reverse gear when the vehicle is stationary with the engine
at idle.
As a safety precaution and to facilitate starting of the engine:
- always select neutral,
- press the clutch pedal.

6/
DRIVING
"PORSCHE TIPTRONIC SYSTEM"
AUTOMATIC GEARBOX
GEAR SELECTION GATE
1. Gear lever.
2. Button " S " (sport) .
3. Button "  " (snow) .
GEAR LEVER POSITIONS
P. Park.
- Immobilisation of the vehicle, parking brake on or off.
- Starting the engine.
R. Reverse.
- Reversing manoeuvres, vehicle stationary, engine at idle.
N. Neutral.
- Immobilisation of the vehicle, parking brake on.
- Starting the engine.
D. Automatic operation.
M. + / - Manual operation with sequential changing of the six gears.
 Press forwards to change up through the gears.
or
 Press rearwards to change down through the gears.
Six speed automatic gearbox which offers a choice between the comfort
of fully automatic operation, enhanced by sport and snow programmes,
or manual gear changing.
There are two driving modes:
- automatic operation for electronic management of the gears by
the gearbox, with the sport programme for a more dynamic driving
style or the snow programme to facilitate driving when grip is poor.
- manual operation for sequential changing of the gears by the driver.

3
3
134
DISPLAYS IN THE INSTRUMENT PANEL
When you move the lever in the gate to select a position, the
corresponding symbol is displayed in the instrument panel.
P. Park
R. Reverse
N. Neutral
D1... D6. Drive (Automatic driving)
S. Sport programme
 . Snow programme
M1... M6. Manual (Sequential driving)
-. Invalid value during manual operation
MOVING OFF
 Apply the parking brake.
 Select position P or N .
 Start the engine.
If this procedure is not followed, there is an audible signal, accompanied
by a message in the screen.
 With the engine running, press the brake pedal.
 Release the parking brake.
 Select position R , D or M ,
 Gradually release the brake pedal.
The vehicle then moves off.
If position N is engaged inadvertently while driving, allow the
engine to return to idle then engage position D to accelerate.
When the engine is running at idle, with the brakes released, if
position R , D or M is selected, the vehicle moves even without the
accelerator being pressed.
When the engine is running, never leave children in the vehicle
without supervision.
When carrying out maintenance with the engine running, apply the
parking brake and select position P .
A message is displayed if you try to move the gear lever from
position
P without pressing the brake pedal.

6/
3
3
DRIVING
AUTOMATIC OPERATION
 Select position D for automatic changing of the six gears.
Never select position N while the vehicle is moving.
Never select positions P or R unless the vehicle is completely
stationary.
The gearbox then operates in auto-adaptive mode, without any
intervention on the part of the driver. It continuously selects the most
suitable gear according to the style of driving, the profi le of the road and
the load in the vehicle.
D and the gears selected automatically appear in succession in the
instrument panel.
For maximum acceleration without touching the lever, press the
accelerator pedal down fully (kick down). The gearbox changes down
automatically or maintains the gear selected until the maximum engine
speed is reached.
On braking, the gearbox changes down automatically to provide
effi cient engine braking.
If you release the accelerator sharply, the gearbox will not change to a
higher gear for safety reasons.
SPORT AND SNOW PROGRAMMES
These two special programmes supplement the automatic operation in
very specifi c conditions of use.
Sport programme "S"
 Press button
"S" , after starting the engine.
The gearbox automatically favours a dynamic style of driving.
S appears in the instrument panel.
Snow programme "  "
 Press button "  ", after starting the engine.
The gearbox adapts to driving on slippery roads.
This programme improves starting and drive when traction is poor.
 appears in the instrument panel.
RETURN TO AUTOMATIC OPERATION
 At any time, press the button selected again to quit the programme engaged and return to auto-adaptive mode.
MANUAL OPERATION
 Select position M for sequential changing of the six gears.
 Push the lever towards the + sign to change up a gear.
 Pull the lever towards the - sign to change down a gear.

136
It is only possible to change from one gear to another if the vehicle
speed and engine speed permit; otherwise, the gearbox will operate
temporarily in automatic mode. M and the gears engaged manually appear in succession in
the instrument panel.
If the engine speed is too low or too high, the gear selected
fl ashes for a few seconds, then the actual gear engaged is
displayed.
It is possible to change from position D (automatic) to position M
(manual) at any time.
When the vehicle is stationary or moving very slowly, the gearbox
selects gear M1 automatically.
The sport and snow programmes do not operate in manual mode.
Invalid value during manual operation
This symbol is displayed if a gear is not engaged correctly
(selector between two positions).
STOPPING THE VEHICLE
Before switching off the engine, you can engage position P or N to
place the gearbox in neutral.
In both cases, apply the parking brake to immobilise the vehicle. If the lever is not in position
P , when the driver's door is opened or
approximately 45 seconds after the ignition is switched off, there is
an audible signal is heard accompanied by a message.
 Return the lever to position P ; the audible signal stops and the
message disappears.
OPERATING FAULT
When the ignition is on, the illumination of this warning lamp,
accompanied by an audible signal and a message in the
screen, indicates a gearbox malfunction.
In this case, the gearbox switches to emergency mode and is locked in
3rd gear. You may feel a substantial knock when changing from P to R
and from N to R . This will not cause any damage to the gearbox.
Do not exceed a speed of 60 mph (100 km/h), local speed restrictions
permitting.
Have it checked by a PEUGEOT dealer or a qualifi ed workshop.
This warning lamp may also come on if a door is opened.
There is a risk of damage to the gearbox:
- if you press the accelerator and brake pedals at the same time,
- if you force the lever from position P to another position when
the battery is fl at.
To reduce fuel consumption during a long period stationary with
the engine running (traffi c jam, etc.), place the gear lever in
position N and apply the parking brake.

7/
CHECKS
PEUGEOT & TOTAL
PARTNERS IN PERFORMANCE
AND PROTECTION OF
THE ENVIRONMENT
Innovation at the service of performance
The TOTAL Research and Development teams
develop lubricants for PEUGEOT which satisfy the
requirements of the latest technical innovations
incorporated in PEUGEOT vehicles.
This ensures that you obtain the best performance
and the maximum engine life.
Reduced exhaust emissions
TOTAL lubricants are formulated to optimise the
effi ciency of engines and the protection of the
emissions post-treatment systems. It is crucial to
observe the servicing recommendations made by
PEUGEOT to ensure correct operation.
RECOMMENDS

150
FUEL TANK
Fuel tank capacity: approximately 55 litres.
LOW FUEL LEVEL
FILLING
When the fuel tank minimum level is reached this warning
lamp comes on on the instrument panel, accompanied by an
audible signal and an alert message. When it fi rst comes on
there remains approximately 5 litres of fuel in the tank.
Until suffi cient fuel is added, this warning lamp appears every time
the ignition is switched on, accompanied by an audible signal and a
message. When driving, this audible signal and display of the alert
message are repeated with increasing frequency as the fuel level drops
towards "0" .
Refuel as soon as possible to avoid running out of fuel.
If you run out of fuel (Diesel), refer also to the "Running out of fue\
l
(Diesel)" section.
A label affi xed to the inside of the fl ap reminds you of the type of fuel to
be used depending on your engine.
Additions of fuel must be of at least 5 litres, in order to be registere\
d by
the fuel gauge. To fi ll the tank in complete safety:
 the engine must be switched off,

 press the rear part of the fl ap, then raise it to open it,
 turn the cap to the left,
 remove the cap and hook it onto the clip located on the inside of the fl ap,
 fi ll the tank, but do not continue after the 3rd cut-off of the
pump ; this could cause malfunctions.
Opening the fi ller cap may create a noise a caused by an inrush
of air. This vacuum is entirely normal, resulting from the sealing of
the fuel system.