light Peugeot RCZ 2015 Owner's Guide

68
RCZ_en_Chap03_confort_ed01-2015
SUN VISOR
Component which protects against sunlight from the front or the side,
also equipped with an illuminated vanity mirror.
F With
the ignition on, raise the concealing flap; the mirror is
illuminated automatically

.
This
sun visor is also equipped with a ticket holder.
ILLUMINATEd ANd COOLE d GLOVE BOX
This has areas for storing a bottle of water, the vehicle's handbook pack...
Its lid has areas for storing a pen, a pair of spectacles, tokens, cards\
,
a
can...
F

T
o open the glove box, raise the handle.
The glove box is illuminated when the lid is opened.
It houses an air vent, which can be opened or closed.

This distributes
the same conditioned air as the vents in the passenger compartment.

70
RCZ_en_Chap03_confort_ed01-2015
FRONT ARMREST
Comfort and storage for the driver and front passenger.
The height and length of the armrest cover can be adjusted.
F Raise the cover to the required position (low, intermediate or high).
F

If you raise the cover slightly beyond the high position, guide it
when lowering it to the low position.
Longitudinal adjustment
F Slide the cover fully forwards or rearwards.
Storage
F Raise the lever .
F
Raise the cover fully
.
Height adjustment

74
RCZ_en_Chap03_confort_ed01-2015
The duration of lighting varies, depending on the context:
-
when the ignition is of
f, approximately ten minutes,
-

in energy economy mode, approximately thirty seconds,
-


when the engine is running, no limit.
STORAGE BOX
This has areas for storing a box of spare bulbs, a first aid kit, the temporary puncture repair kit, a warning triangle, the removable ball
of the towbar system...
BOOT LAMPS
Your vehicle is fitted with two boot lamps; one in the right-hand boot side trim and a second in the centre under the rear shelf.
They come on automatically when the boot is opened and switch of f
automatically when the boot is closed.
They cannot be deactivated manually.
A second warning triangle can be stored in the boot lid trim.
For access to it:
F raise

the

floor

using

the

strap,
F

secure it in the vertical position behind the stops, located on
the sides of the boot.

75
RCZ_en_Chap04_visibilite_ed01-2015
ExTERIOR LIGHTING CONTROLS
Control stalk for the selection and control of the various front and rea\
r
lamps providing the vehicle's lighting.
MAIN LIGHTING
The various front and rear lamps of the vehicle are designed to adapt
the driver's visibility progressively in relation to the climatic condit\
ions:
-
sidelamps, to be seen,
-


dipped beam headlamps to see without dazzling other drivers,
-


main beam headlamps to see clearly when the road is clear
.
AddITIONAL LIGHTING
Other lamps are fitted to fulfil the requirements of particular driving conditions:
-

a rear foglamp to be seen from a distance,
-


directional headlamps for improved visibility when cornering,
-


daytime running lamps to be seen during the day
.
SETTINGS
Various automatic lighting control modes are also available depending
on options:
-
daytime running lamps,
-


automatic illumination of headlamps,
-


directional lighting,
-


guide-me-home lighting.
In some weather conditions (e.g. low temperature or humidity),
the presence of misting on the internal surface of the glass of the
headlamps and rear lamps is normal; it disappears after the lamps
have been on for a few minutes.
4/
VISIBILITY

76
RCZ_en_Chap04_visibilite_ed01-2015
Model without AUTO lightingModel with AUTO lighting
MANUAL CONTROLS
The lighting is controlled directly by the driver by means of the ring A
and the stalk B.
A.

Main lighting mode selection ring: turn it to position the symbol
required

facing the mark.
Lighting off / daytime running lamps.
Automatic illumination of headlamps.
B.

Stalk for switching headlamps: pull it to switch between dipped
headlamps / main beam headlamps.
In the lamps of

f and sidelamps modes, the driver can switch on the
main
beam headlamps temporarily ("headlamp flash") by maintaining a
pull on the stalk.Sidelamps only

.
Dipped or main beam headlamps.
dISPLAYS
Lighting of the corresponding indicator lamp on the instrument panel
confirms the switching on of the lighting selected.
The instrument panel has permanent back-lighting, both day and night.
In this case, illumination of the instrument panel is not linked to the \
exterior lighting.

77
RCZ_en_Chap04_visibilite_ed01-2015
C. Foglamp selection ring.
The foglamp operates with the dipped and main beam headlamps.
Rear foglamp.
F

T
urn the ring C forwards and release to switch on the rear foglamp.
When the lighting is switched off automatically (with AUTO model)
or when the dipped beam headlamps are switched off manually, the
foglamp and the sidelamps will remain on.
F

T
urn the ring C rearwards and release to switch off all the lamps. In good or rainy weather, both day and night, use of the rear
foglamp is prohibited. In these situations, the power of its beam
may dazzle other drivers. It should only be used in fog or snow.
In these weather conditions, it is your responsibility to switch
on the foglamp and dipped beam headlamps manually as the
sunshine
sensor may detect sufficient light.
Do not forget to switch off the rear foglamp when it is no longer
needed.
Switching off the lamps when the ignition is switched off
On switching off the ignition, all of the lamps turn off immediately,
except for dipped beam if guide-me-home lighting is activated.
Switching on the lamps after the ignition is switched off
To reactivate the lighting control, rotate ring A to the "0" position -
lamps off, then to the desired position.
On opening the driver's door a temporary audible signal warns the
driver that the lighting is on.
The lamps, with the exception of the sidelamps, switch off
automatically after a maximum duration of thirty minutes to
prevent discharging of the battery.
4/
VISIBILITY

78
RCZ_en_Chap04_visibilite_ed01-2015
dAYTIME RUNNING LAMPS
Daytime lighting, compulsory in certain countries, which comes on
automatically when the engine is started providing better visibility of \
the
vehicle by other road users.
In countries in which it is imposed by regulations:
-

by default, this function is activated and cannot be deactivated,
-


the dipped beam headlamps come on, associated with the
sidelamps and the number plate lamps.
For other countries where the vehicle is sold, this function is assured \

by

specific lamps.
The
lighting control stalk should be in position
"0"

or "AUTO".
This function can be activated or deactivated via the vehicle
configuration
menu.
Deactivation of the daytime running lamps is effective after
operation of the lighting control stalk or after the next engine
start; activation is immediate.
LEd LAMPS
They come on when the engine is started.
Depending on the destination country, they are used for:
-

daytime running lamps* in day mode and sidelamps in night mode
(they are brighter when daytime running lamps),


or
-

sidelamps in day and night mode.
Where

LED lamps are fitted, the filament bulbs for the daytime running
lamps / sidelamps in the front lamp units are not used.
*

function that can be set in the vehicle configuration menu.

79
RCZ_en_Chap04_visibilite_ed01-2015
AUTOMATIC ILLUMINATION OF HEA d LAMPS
When a low level of ambient light is detected by a sunshine sensor, the
number plate lamps,
sidelamps and dipped beam headlamps are switched
on automatically, without any action on the part of the driver. They can also
come on if rain is detected, at the same time as automatic operation of \
the
windscreen wipers.
As
soon as the brightness returns to a sufficient level or after the windscreen
wipers are switched of

f, the lamps are switched off automatically.
Activation
F Turn the ring to the "AUTO" position. The activation of the function is accompanied by the display of a message in the screen.
deactivation
F Turn the ring to another position. Deactivation of the function is accompanied by the display of a message in the screen.
MANUAL GUI d E - ME - HOME LIGHTING
The temporary illumination of the dipped beam headlamps after the
vehicle's ignition has been switched off makes the driver's exit easier
when the light is poor.
Switching on
F With the ignition off, "flash" the headlamps using the lighting stalk.
F A

further "headlamp flash" switches the function off.
Switching off
The manual guide-me-home lighting switches off automatically after a
set time.
4/
VISIBILITY

80
RCZ_en_Chap04_visibilite_ed01-2015
AUTOMATIC GUId E - ME - HOME
LIGHTING
Operating fault
In the event of a malfunction of the sunshine sensor, the
lighting comes on, this warning lamp is displayed in the
instrument panel and/or a message appears in the screen,
accompanied by an audible signal.
Contact

a

PEUGEOT

dealer or a qualified workshop.
In

fog

or snow, the sunshine sensor may detect sufficient light. In
this case, the lighting will not come on automatically

.
Do not cover the sunshine sensor, coupled with the rain sensor
and located in the centre of the windscreen behind the rear view
mirror; the associated functions would no longer be controlled. When the automatic illumination of headlamps function is activated
(lighting control stalk in the "
AUTO" position), under low ambient light
the dipped beams headlamps come on automatically when the ignition
is switched off.
Programming
Activation or deactivation, as well as the duration of the guide-me-home\

lighting, is set in the vehicle configuration menu.

82
RCZ_en_Chap04_visibilite_ed01-2015
DIRECTIONAL LIGHTING
When the dipped or main beam headlamps are on, this function enables
the light beams to provide improved lighting of the side of the road when
cornering.
The use of this function, from approximately 12 mph (20 km/h) and
associated with the xenon headlamps only, considerably improves the
quality
of your lighting when cornering.
with directional lighting
without directional lighting
PROGRAMMING
O
PERATING
F
AULT
When stationary or moving at very low speed or when reverse
gear is engaged, the function is inactive.
The status of the function remains in the memory when the
ignition is switched off.If
a fault occurs, this warning lamp flashes in the instrument
panel, accompanied by a message in the screen.
Contact

a PEUGEOT

dealer or a qualified workshop.
The function is activated or deactivated via the vehicle
configuration menu.