light PONTIAC FIREBIRD 1995 User Guide
[x] Cancel search | Manufacturer: PONTIAC, Model Year: 1995, Model line: FIREBIRD, Model: PONTIAC FIREBIRD 1995Pages: 386, PDF Size: 19.66 MB
Page 79 of 386

Limited-Slip Rear Axle
If you have this feature, your rear axle can give you
additional traction on snow, mud, ice, sand or gravel. It
works like a standard axle most
of the time, but when
one of the rear wheels has no traction and the other does,
the limited-slip feature
will allow the wheel with
traction to move the vehicle.
Parking Brake
The parking brake uses the brakes on the rear wheels.
To set the parking brake:
Hold the brake pedal down and pull up on the parking
brake lever.
If the ignition is on, the brake system
warning light
will come on.
ProCarManuals.com
Page 89 of 386

A green arrow on the instrument panel will flash in the
direction of the turn or lane change.
To signal a lane change, just raise or lower the lever
until the green arrow starts to flash. Hold it there until
you complete your lane change. The lever will return by
itself when you release it.
As you signal a turn or a lane change, if the arrows don’t
flash but just stay on, a signal bulb may be burned out
and other drivers won’t see your turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the green arrows don’t go on at all when you
signal a turn, check the fuse (see“Fuses” in the Index).
Headlamp High/Low Beam
To change the headlamps from low beam to high or high
to low,
pull the turn signal lever all the way toward you.
Then release
it. When the high beams are on, this blue
light on the instrument panel also
will be on.
2-42
ProCarManuals.com
Page 90 of 386

Windshield Wipers
1
You control the windshield wipers by turning the band
with the wiper symbol on it.
For a single wiping cycle, turn the band to MIST. Hold
it there until the wipers start, then let
go. The wipers will
stop after one cycle.
If you want more cycles, hold the
band on MIST longer.
You can set the wiper speed for a long or short delay
between wipes. This can be very useful in light rain
or
snow. Turn the band to choose the delay time. The
closer to
LO, the shorter the delay.
For steady wiping at low speed, turn the band away
from you to the
LO position. For high speed wiping,
turn the band' further, to'H1. To stop the wipers, move
the band to
OFF.
Damaged wiper blades may prevent you from seeing
well enough to drive safely. To avoid damage, be sure to
I
clear ice and snow from the wipers blades before using *
them. If they're frozen to the windshield, carefully
loosen or thaw them. If your blades do become
damaged, get new blades or blade inserts.
Heavy snow or ice can overload your wipers. A circuit
breaker will stop them until the motor cools. Clear away
snow or ice to prevent an overload.
2-43
ProCarManuals.com
Page 95 of 386

To Reduce Speed While Using Cruise
Control
There are two ways to reduce your speed while using
cruise control:
1. Push the button at the end of the lever until you
reach the lower speed you want, then release it.
2. To slow down in very small amounts, push the
button for less than half a second. Each time you do
this, you’ll go about
1 mph (1.6 km/h) slower.
Passing Another Vehicle While Using
Cruise Control
Use the accelerator pedal to increase your speed. When
you take your foot
off the pedal, your vehicle will slow
down to the cruise control speed you set earlier.
Using Cruise Control on Hills
How well your cruise control will work on hills depends
upon your speed, load, and the steepness of
the hills.
When going up steep hills, you may have to step on the
accelerator
pedal to maintain your speed. When going
downhill, you may have to brake or
shift to a lower gear to
keep your speed down. Of course, applying the brake takes you out of cruise control. Many drivers find
this to be too
much trouble and don’t use cruise control on steep
hills.
To Get Out of Cruise Control
There are several ways to turn off the cruise control:
1. Step lightly on the brake pedal or clutch pedal, if you
have a manual transmission; or
2. Move the cruise switch to OW.
2-48
ProCarManuals.com
Page 96 of 386

To Erase Speed Memory
When you turn off the cruise control or the ignition,
your cniise control set speed memory
is erased.
Main Lamp Control
L-’
-7
The main lamp control is a knob that works these lamps:
Headlamps
Taillamps
0 Parking lamps
License lamps
Sidemarker lamps
Instrument panel lights
’ I ’ This setting turns on your headlamps afid dther
operating lamps.
Pg This setting turns on your parking lamps without
your headlamps.
Turn the
knob to OFF to turn off the lamps.
-‘pJ-
Brightness Control
)t/.I This switch controls the brightness af YOU
instrument panel lights. Turn the switch to brighten or
dim the lights. If you turn the switch all the way up your
courtesy lamps will come on.
2-49
ProCarManuals.com
Page 97 of 386

Daytime Running Lamps (Canada)
Daytime Running Lamps (DRL) make it easier to see
the front
of your vehicle during the day. DIU can be
helpful when it’s raining and in the short periods after
dawn and before sunset. Several countries, including
Canada, require DRL.
A light sensor on top of the instrument panel makes the
DRL work,
so be sure it isn’t covered.
The DRL system.wil1 make your front turn signal lamps
come on when:
The ignition is on
0 The headlamp switch is off, and
The parking brake is released.
When the DRL are on, only your front turn signal lamps
will be on. The taillamps, sidemarker and other lamps
won’t be on. Your instrument panel won’t
be lit up either.
When it’s dark enough outside, your front turn signal
lamps will go out and your headlamps will come on.
The other lamps that come on with your headlamps will
also come on.
When it’s bright enough outside, the regular lamps will
go off, and your front turn signal lamps come on.
As with any vehicle, you should turn on the regular
headlamp system any time you need it.
Lamps On Reminder
If you turn the ignition OFF and leave the lamps on, you
will hear a chime when you open the driver’s door.
2-50
ProCarManuals.com
Page 99 of 386

Fog Lamps (Option)
Use your fog lamps for better vision in foggy or misty
conditions. Your parking lamps must be on or your fog
lamps won’t work.
a$ To turn the fog lamps on, push the right side of the
fog lamp switch. Push the left side to
turn the fog lamps
off. A light on the switch will come on when the fog
lamps
are on.
Fog lamps will go off whenever your high beams come
on. When the high beams go
off, the fog lamps will
come on again.
Interior Lamps
Courtesy Lamps
When any door is opened, several interior lamps go on.
These lamps are courtesy lamps. They make it easier for
you to enter and leave your vehicle.
Courtesy lamps include the dome lamp and other lamps
throughout the interior of your vehicle.
Front Map Lamps 1
c
Your inside rearview mirror includes two map lamps.
Each lamp has its own switch. Use the switch closest to
the lamp to
turn it on. The lamps will also go on when a
door is opened.
2-52
ProCarManuals.com
Page 109 of 386

Sun Visors
To block out glare, you can swing down the visors. You
can also swing them to the side. The elastic bands on
your visor provide extra storage for maps or papers.
Covered Visor Vanity Mirror I
Pull down the sun visor and lift the cover to expose the
vanity mirror.
Ashtray and Lighter
Front Ashtray
Lift up the cover to open the ashtray. To remove it, lift
up on either side
of the ashtray. If you have an automatic
transmission, the ashtray is near the front of your
console. If you have
a manual transmission, tfie ashtray
is near your cupholder.
ProCarManuals.com
Page 110 of 386

NOTICE:
Don’t put papers and other things that burn into
your ashtray.
If you do, cigarettes or other
smoking materials could set them on fire, causing
damage.
Cigarette Lighter
I
To use the lighter, push it in all the way and let go.
When it’s ready, it will pop back by itself.
I
NOTICE:
Don’t hold a cigarette lighter in with your hand
while
it is heating. If you do, it won’t be able to
back away from the heating element when it’s
ready. That can make it overheat, damaging the
lighter and the heating element.
If you plug accessories into your cigarette lighter, such
as heating devices
or air compressors, these accessories
should have a rated current of less than
15 amps.
Exceeding this limit will result in a blown fuse.
2-63
ProCarManuals.com
Page 112 of 386

1. Fog Lamp Switch (if equipped)
2. Main Lamp Control
3. Side Upper Air Vent
4. Instrument Cluster
5. Horn
6. Center Upper Air Vent
7. Audio System
8. Glove Box
9. Comfort Controls
10. Cigarette Lighter
11. Parking Brake Lever
12. Cupholder
13. Storage Console and Cassette TapeKompact Disc
14. Transmission Mode Switch (Automatic
Storage (as equipped)
Transmission)
15. Shift Lever
16. Ashtray (Automatic Transmission)
17. Rear Window Defogger Switch
18. Steering Wheel Controls
19. Remote Hatch Release
20. Convertible
Top Switch (if equipped)
21. Traction Control System Switch (if equipped)
2-65
ProCarManuals.com