key PORSCHE 911 TURBO 2014 6.G Owner's Manual

Air Conditioning 55
Automatically Controlled 2-zone
Air Conditioning
The temperature can be set individually for the driver’s and passenger’s side.
In automatic mode the air conditioning system exercises full control over the air temperature, air distribution, and air quantity. A number of factors (such as ambient air temperature, amount of sunlight, etc...) are used by the system to determine the optimum settings for the current situation.
Automatic mode is deactivated as soon as the settings are adjusted manually. In this case, automatic climate control still regulates the air-conditioning functions that have not been modified manually.
Interior temperature sensor
Sensors
To avoid impairing the function of the air conditioning system, the interior temperature sensor for the air-conditioning system must not be covered or taped over.
Information
Additional air conditioning settings can be made on the multi-function display on the instrument panel:fPlease see the chapter “SETTING AIR CONDITIONING” on page 123.
All air-conditioning system settings are stored on the respective car key when the vehicle is locked, on vehicles with memory.
Information on air-conditioning compressor
The air-conditioning compressor – Can switch off briefly to ensure sufficient engine cooling if the engine is operating under extreme load.– Switches off automatically at temperatures below approx. 36 °F (2 °C) and cannot be switched on, even manually.– Operates most effectively with the windows closed.If the vehicle has been in the sun for a long time, it is a good idea to ventilate the interior briefly with the windows open.– Depending on the outside temperature and humidity, condensation can drip from the evaporator and form a pool under the vehicle.This is normal and not a sign of leakage.
Information on automatic load switch-off
If the charging condition of the battery is critical, the following air-conditioning or heating functions are restricted initially and then switched off:– Seat heating– Seat ventilation– Heated rear window/Exterior mirror heating– Fresh-air blower– Air-conditioning compressor
14_991_Turbo_21.book Seite 55 Mittwoch, 9. April 2014 2:19 14

62 Windows, Sunroof and Cabriolet
Power Windows
When opening or closing the windows, particularly in one-touch mode, parts of the body may get trapped between the moving window and fixed vehicle parts.fTake care to ensure that nobody can be injured when the windows open or close.fAlways remove the ignition key when leaving the vehicle or switch ignition off on vehicles with Porsche Entry & Drive. Always take the ignition key with you when leaving the vehicle. Uninformed persons could injure themselves by operating the power windows.fDo not leave children in the vehicle unattended.
Readiness for operation of power windows
The power windows are ready for operation:– With ignition switched on.– After the ignition is switched off and before the driver’s or passenger’s door is first opened, but for a maximum of 10 minutes.One-touch operation for closing the door windows is available only when the ignition is switched on.
Cabriolet
When the convertible top is open, the rear side windows can only be closed if the door windows are closed.
A - Power window, driver’s side B - Power window, passenger’s side C - Cabriolet: LED indicator for switching between front/ rear power windowsD - Cabriolet: Switch for front/rear power windows
Opening/closing windows
On the Cabriolet, select front or rear power windows with switch D.
The LED C in switch D indicates that the rear windows are selected.
Opening window with the switch
fPress the relevant switch until the window has reached the desired position.
Closing window with the switch
fPull the relevant switch until the window has reached the desired position.
Information
The switches have a two-stage function. Both detent positions can be felt clearly when you actuate the switch.
– First setting – manual operation If the relevant switch is moved to the first position, the window is opened or closed manually.The window stops when the switch is released.– Second setting – one-touch operation If the relevant switch is moved fully to the second position, the window is opened or closed automatically.Actuate the switch again to stop the window at the desired position.
Information
If a door window is blocked during closing, it will stop and open again by several centimeter.If the window is blocked a second time within approximately 10 seconds, one-touch operation is disabled for this window.
The window can be closed manually. The window then closes with its full closing force.
One-touch operation is enabled again once the window has been closed completely using the manual closing function.
Opening and closing the windowsWARNINGh
14_991_Turbo_21.book Seite 62 Mittwoch, 9. April 2014 2:19 14

Windows, Sunroof and Cabriolet 63
If one-touch operation is disabled after the window is blocked, the window will close with its full closing force when the manual closing function is used.fEnsure that nobody can be injured, pinched or crushed when the windows close.
Storing end position of the windows after connecting the vehicle battery
The end positions of the windows are lost when the battery is disconnected and reconnected. One-touch operation of the windows is disabled.
Perform these steps for all windows: 1. Close window completely once by pulling the rocker switch.2. If the window is completely closed, briefly pull the rocker switch again 3 times. 3. Open the window completely once by pressing the rocker switch.
Sunroof
The electric sunroof and the roll-up sunblind can be operated using the buttons in the center console.
When opening or closing the roof or sunblind, particularly when using one-touch operation, parts of the body may become trapped between moving and fixed vehicle parts.fEnsure that nobody is injured when operating the roof or roll-up sunblind.fAlways remove the ignition key when leaving the vehicle or switch ignition off on vehicles with Porsche Entry & Drive. Always take the ignition key with you when leaving the vehicle. Uninformed persons (e.g. children) could injure themselves when operating the sunroof or roll-up sunblind.fIn case of danger, press the sliding roof or sunblind button immediately.
Damage to the roof, if the roof is opened or lifted when a roof transport system is fitted and the roof collides with the carrier/load.fDo not open or lift the roof when a roof transport system is fitted.
Operational readiness of the sunroof and roll-up sunblind
The sunroof and roll-up sunblind are ready for operation:
– With ignition switched on.
Information
The roof and sunblind have a force limiter. If the roof or sunblind are obstructed during the closing operation, they will open again immediately.
At speeds above 120 mph (200 km/h) and at temperatures below --22 °F (–30 °C), the roof can only be closed. The opening function is disabled.
Closing the windows manuallyWARNINGh
Opening and closing the sunroof and roll-up sunblind
WARNINGh
NOTICE
14_991_Turbo_21.book Seite 63 Mittwoch, 9. April 2014 2:19 14

Windows, Sunroof and Cabriolet 65
Closing the roof
First setting – manual operationfPull and hold button C in the first setting until the desired position is reached.
Second setting – one-touch operationfBriefly pull button C to the second setting. The roof closes automatically.
The process can be interrupted by pulling button C again.
Opening the roll-up sunblind
First setting – manual operationfPull and hold button A in the first setting until the desired position is reached.
Second setting – one-touch operationfBriefly pull button A to the second setting. The sunblind opens automatically to the end position.
The process can be interrupted by pressing button A again.
Closing the roll-up sunblind
First setting – manual operationfPress and hold button A in the first setting until the desired position is reached.
Second setting – one-touch operationfBriefly press button A to the second setting. The sunblind closes automatically to the end position.
The process can be interrupted by pressing button A again.
Information
If the sunroof is partly or fully open, the sunblind can only be closed as far as the front edge of the sunroof.
If the sunblind is closed, it will be opened (pulled along) automatically when the sunroof is opened.
Warning message on multi-function display
If there is a fault in the sunroof the warning “ Close sunroof completely” appears on the multi- function display.fClose sunroof with button C. Have the fault corrected by an authorized Porsche dealer at the next opportunity.
Emergency closing of sunroof
Emergency closing after repeated intervention from the force limiter
If the closing operation of the roof is impeded by an obstruction, it can be closed manually with increased force.
To perform emergency closing: 1. Remove the obstruction. 2. Pull and hold button C in the first setting until the roof closes and stops in the closed position.Repeat closing operation if necessary
Emergency operation if roof drive mechanism fails
If the roof drive mechanism is defective, it can be closed manually using the hexagon key from the tool kit.fBefore using emergency operation, check that the fuse is intact.
For information on changing fuses:fPlease see the chapter “CHANGING FUSES” on page 267.
14_991_Turbo_21.book Seite 65 Mittwoch, 9. April 2014 2:19 14

66 Windows, Sunroof and Cabriolet
1.Carefully lever off the cap from the roof liner using a screwdriver, for example.2. Take the hexagon key out of the tool kit in the luggage compartment.
For information on the tool kit:fPlease see the chapter “TOOLS” on page 198.
3. Insert the hexagon key all the way into the opening.4. Applying continuous upward pressure, turn the key clockwise until the roof is fully closed.5. Remove the key. 6. Refit the cap. 7. Stow the key in the tool kit.fHave the fault corrected at an authorized Porsche dealer.
Storing end position of the sunroof
The end positions of the roof are lost after disconnection/connection of the vehicle battery, if the vehicle battery is exhausted or after jump lead starting, after emergency operation or after changing the fuse for the roof.
The roof closes with its full closing force when storing the end position.fEnsure that nobody is injured when closing the roof.
The vehicle must be stationary in order to store the end position of the roof.1. Switch on ignition. 2. Pull and hold button C in the first setting until the roof closes and stops in the closed position.The process for storing the end position begins after approximately 10 seconds. The roof now opens and closes once automatically. Storage is now complete.If this process is not executed, please perform the following procedure:Pull and hold button C in the first setting until the roof closes fully and stops. If necessary, repeat the closing operation until the roof has stopped moving completely.The process takes a maximum of 15 seconds.Start the storing process again if the button is released before the roof has stopped moving completely.
Storing the end positionWARNINGh
14_991_Turbo_21.book Seite 66 Mittwoch, 9. April 2014 2:19 14

70 Windows, Sunroof and Cabriolet
Raising/lowering the wind deflector
Conditions for operating the wind deflector
– The ignition must be switched on (engine running or switched off).– Maximum speed up to approx.: 75 mph (120 km/h) for lowering and124 mph (200 km/h) for raising.If these speeds are exceeded, raising/lowering of the wind deflector is not possible.fPress and hold the switch until the end position of the wind deflector is reached and the message on the multi-function display goes out.
Emergency Operation of
Convertible Top and
Wind Deflector
fAlways carry out emergency operation with the greatest care.fDo not activate the convertible top and wind deflector during emergency operation.
There is a risk of damage to the convertible top and convertible-top mechanism.fDo not activate the convertible top during emergency operation.
Risk of damage to convertible top and convertible- top mechanism.fAfter emergency operation, do not operate the convertible top.fDrive slowly to an authorized Porsche dealer.
Before emergency operation
Before carrying out emergency operation, please check:1. Was the ignition switched on during operation of the wind deflector and convertible top with the switch?2. Are the fuses defective? Please see the chapter “CHANGING FUSES” on page 267.3. Remove the ignition key so that the wind deflector and convertible top are not activated unintentionally.
Removing the rear wall trim panel
1. Fold the rear seat backrests forward ( illustration). 2. Carefully lever the rear wall trim panel out of the clip points using the screwdriver (from the tool kit) and fold it forward or pull off the rear wall trim panel using the two loops (depending on vehicle equipment) and fold it forward ( illustration).
Moving convertible top parts during emergency operation
WARNINGh
NOTICE
NOTICE
14_991_Turbo_21.book Seite 70 Mittwoch, 9. April 2014 2:19 14

Windows, Sunroof and Cabriolet 71
3.Remove the emergency operation key A from the rear wall trim panel.Emergency operation of wind deflector
1. Remove plastic attachment B from the emergency operation key A. Swivel the metal insert approx. 90° up out of the plastic attachment B and pull out forwards.
2. Fold both roll-over protection covers C forward and unclip them by pulling them up.
14_991_Turbo_21.book Seite 71 Mittwoch, 9. April 2014 2:19 14

72 Windows, Sunroof and Cabriolet
3.Unscrew both screws D on the roll-over protection cover using the screwdriver.4. Release roll-over protection cover E out of the clip points by pulling them upwards.
5. Unscrew screws F on the wind deflector motor using the metal insert A (TORX®) of the emergency operation key.6. Pull retaining bracket G forward (lever it out using the screwdriver if necessary) until the gears no longer engage. Remove retaining bracket.7. Retract the wind deflector manually.
Releasing convertible-top drive
fUsing the hexagon on the plastic attachment B, turn the emergency hand screw H approx. 180° anti-clockwise.
fOnly loosen emergency hand screw H, do not unscrew it completely.
NOTICE
14_991_Turbo_21.book Seite 72 Mittwoch, 9. April 2014 2:19 14

Windows, Sunroof and Cabriolet 73
Opening the convertible-top compartment lid
1. Reassemble plastic attachment B and metal insert A. 2. Insert the metal end of the emergency operation key between the convertible-top compartment lid and convertible top.Ensure that the bend of the plastic attachment B is pointing towards the rear of the vehicle.3. Guide the emergency operation key forward along the plastic trim until it slides into opening K up to marking 1 on the plastic attachment B.
4. Turn the emergency operation key approx. 90° in the direction of travel so that the plastic attachment B is pointing upwards.
5. Insert the emergency operation key up to marking 2 on the plastic attachment B and turn a further 90° in the direction of travel until a noticeable resistance is overcome.6. Turn the emergency operation key approx. 90° against the direction of travel and remove it.7. Repeat the procedure (steps 2 to 6) on the opposite side.
14_991_Turbo_21.book Seite 73 Mittwoch, 9. April 2014 2:19 14

74 Windows, Sunroof and Cabriolet
8.Using both hands on the driver’s and passenger’s side, firmly pull the convertible-top compartment lid upwards.9. Grasp the convertible-top compartment lid in the center from the rear and set to the upright position.
Emergency operation of rear side trim panel flaps
1. Disconnect both connectors L.
2. Loosen both screws M on the motor/gear unit using the metal insert A (TORX®) of the emergency operation key.3. Pull motor/gear unit N forward (lever it out using the screwdriver if necessary) until the gears no longer engage.
14_991_Turbo_21.book Seite 74 Mittwoch, 9. April 2014 2:19 14