Jack Ram 1500 2016 Service Manual

Ram 1500 2016 Service Manual 1500 2016 Ram Ram https://www.carmanualsonline.info/img/34/12536/w960_12536-0.png Ram 1500 2016 Service Manual

Page 752 of 916

Ram 1500 2016 Service Manual Removal Of Jack And Tools (2500, 3500 Series)
To access the jack and jack tools you must remove the
plastic access cover, located on the side of the front
passengers seat. To remove the cover, pull th

Page 753 of 916

Ram 1500 2016 Service Manual Remove the jack and tools by turning the wing bolt
counterclockwise, remove the wing bolt and then slide
the assembly out from under the seat.Remove the jack and tools from the bracket assembly.
Turn

Page 755 of 916

Ram 1500 2016 Service Manual Assembled For Jack OperationWARNING!
After using the jack and tools, always reinstall them
in the original carrier and location. While driving
you may experience abrupt stopping, rapid accelera-
tion

Page 756 of 916

Ram 1500 2016 Service Manual 2. Rotate the wheel wrench handle counterclockwise
until the spare tire is on the ground with enough cable
slack to allow you to pull it out from under the vehicle.
Inserting The Jack Extension Tube I

Page 758 of 916

Ram 1500 2016 Service Manual NOTE:The winch mechanism is designed for use with
the jack extension tube only. Use of an air wrench or other
power tools is not recommended and can damage the
winch.
Preparations
1. Park the vehicle

Page 759 of 916

Ram 1500 2016 Service Manual Block both the front and rear of the wheel diagonally
opposite the jacking position. For example, if the right
front wheel is being changed, block the left rear wheel.
NOTE:Passengers should not remai

Page 760 of 916

Ram 1500 2016 Service Manual WARNING!(Continued)
•If working on or near a roadway, be extremely
careful of motor traffic.
•To assure that spare tires, flat or inflated, are
securely stowed, spares must be stowed with the
valv

Page 761 of 916

Ram 1500 2016 Service Manual CAUTION!
Do not attempt to raise the vehicle by jacking on
locations other than those indicated in the Jacking
Instructions for this vehicle.
1. Remove the spare wheel, jack, and tools from storage.
2

Page 762 of 916

Ram 1500 2016 Service Manual 3. Placement of the jack:
Front Jacking Location
When changing the front wheel, assemble the jack drive
tube to the jack and connect the drive tube to the
extension tube. Place the jack under the axle

Page 763 of 916

Ram 1500 2016 Service Manual extension tube. Place the jack under the axle between the
spring and the shock absorber with the drive tubes
extending to the rear.
Connect the jack tube extension and wheel wrench.CAUTION!
Before rai
Page:   < prev 1-10 ... 11-20 21-30 31-40 41-50 51-60 next >