lock Ram ProMaster 2015 Diesel Supplement

•At low speeds you may hear mechanical noises similar
to a manual transmission as the transmission changes
gears. These noises are normal and will not damage
the transmission.
• Very aggressive driving may result in some clutch
odor. A warning message will display in the EVIC if
cool down actions are needed.
• Before and after the engine is started, you may hear a
hydraulic pump for a short period of time. This noise
is normal and will not damage the transmission.
• During extremely cold temperatures, the transmission
will not operate if the oil temperature is -22°F (-30°C)
or below. When transmission actuation oil temperature
is lower than -22°F (-30°C), engine start will not be
allowed by PCM. For this reason the block heater is
recommended below -17°F (-27°C). Normal operation
will resume once the transmission temperature has
risen to a suitable level.Manual (M) (Manual Mode)
In the MANUAL (M) position the driver is responsible
for choosing the best gear ratio to engage, depending on
driving conditions.
NOTE: Do not press the brake and accelerator pedals at
the same time. Use only one foot to operate the brake and
accelerator.
To operate in MANUAL (M) mode:
• Press and hold the brake pedal.
• Move the shift lever to the MANUAL (M) position.
The current gear will be displayed in the EVIC.
• To drive, release the brake pedal and press the accel-
erator pedal.
• Tap the shift lever towards the (+) to engage a higher
gear.
5
STARTING AND OPERATING 51

MESSAGEDESCRIPTION
Press Brake Pedal / Startup Delayed This messages appears when the key is first turned ON, if the brake pedal is
not depressed and/or the shift lever is not in NEUTRAL (N). The shift lever
must be in the NEUTRAL (N) position, and the brake pedal must be pressed,
to allow engine cranking. Place the shift lever in NEUTRAL (N) and apply the brake pedal BEFORE turning the key to the START/AVV position; otherwise,the engine will not crank and the key must be cycled OFF, then back on, be- fore cranking is allowed.
Gear Unavailable This message appears, along with a warning buzzer:
•When it is not possible to change gear due to a fault in the system.
• When, due a fault in the system, it is only possible to engage 1st (1), 2nd
(2), 3rd (3) or REVERSE (R).
Contact your authorized dealer if the message continues to appear.
Shift Not Allowed This message may appear when starting the engine at low temperature. In this case the Automated Manual transmission isn’t able to engage first gear, in thissituation either use the engine block/transmission heater or allow the engine to idle in NEUTRAL (N) until the transmission has warmed.
58 STARTING AND OPERATING

Perform the maintenance listed in the “Maintenance
Schedule.” Refer to “Maintenance Schedule” for the
proper maintenance intervals. When towing a trailer,
never exceed the GAWR or GCWR ratings.
WARNING!
Improper towing can lead to a collision. Follow these
guidelines to make your trailer towing as safe as
possible:
•Make certain that the load is secured in the trailer
and will not shift during travel. When trailering
cargo that is not fully secured, dynamic load shifts
can occur that may be difficult for the driver to
control. You could lose control of your vehicle and
have a collision.
• When hauling cargo or towing a trailer, do not
overload your vehicle or trailer. Overloading can
(Continued)
WARNING! (Continued)
cause a loss of control, poor performance or dam-
age to brakes, axle, engine, transmission, steering,
suspension, chassis structure or tires.
• Safety chains must always be used between your
vehicle and trailer. Always connect the chains to
the hook retainers of the vehicle hitch. Cross the
chains under the trailer tongue and allow enough
slack for turning corners.
• Vehicles with trailers should not be parked on a
grade. When parking, apply the parking brake on
the tow vehicle. For four-wheel drive vehicles,
make sure the transfer case is not in NEUTRAL.
Always, block or chockthe trailer wheels.
• GCWR must not be exceeded.
(Continued)
5
STARTING AND OPERATING 79

Adding Engine Coolant (Antifreeze).............99
Adding Fuel ..............................66
Air bag Light .............................17
Air Cleaner, Engine (Engine Air Cleaner Filter) .....92
Antifreeze (Engine Coolant) ...............98, 105
Disposal ............................. .101
Anti-Lock Warning Light .....................17
Automated Manual Transmission Fluid Type ........................... .109
Battery .................................96
Brake Fluid ............................ .109
Brake System ........................... .103
Fluid Check .......................... .103
Master Cylinder ....................... .103
Warning Light ..........................17
Capacities, Fluid ......................... .105Caps, Filler
Oil (Engine) ............................91
Radiator (Coolant Pressure) ................101
Check Engine Light (Malfunction Indicator Light) . . .17
Coolant Pressure Cap (Radiator Cap) ...........101
Cooling System ...........................97
Adding Coolant (Antifreeze) ................99
Coolant Capacity ...................... .105
Coolant Level ...........................97
Disposal of Used Coolant .................101
Drain, Flush, and Refill ....................98
Points to Remember .....................102
Pressure Cap ......................... .101
Radiator Cap ......................... .101
Selection of Coolant (Antifreeze) .......98, 105, 106
Cruise Light ..............................17
Diesel Exhaust Fluid (DEF) ..................106
Diesel Fuel .......................... .60, 106
122 INDEX

Diesel Fuel Requirements.................60, 106
Bulk Storage of .........................67
Diesel Fuel System, Re-Priming ................94
Disposal Antifreeze (Engine Coolant) ................101
Draining Fuel/Water Separator Filter ............93
Electronic Speed Control (Cruise Control) .........12
Electronic Vehicle Information Center (EVIC) ......30
Engine ..................................88
Air Cleaner ............................92
Block Heater ...........................45
Break-In Recommendations ..................8
Compartment ...........................88
Coolant (Antifreeze) .....................106
Fuel Requirements ..................... .105
Identification ...........................88
Idling ................................43
Oil........................... .90, 105, 106Oil Filler Cap
...........................91
Oil Selection .......................... .105
Filters Air Cleaner ............................92
Engine Fuel ............................93
Engine Oil ......................... .92, 106
Engine Oil Disposal ......................92
Flashers Turn Signal ............................17
Fluid Capacities ......................... .105
Fluid Level Checks Brake ............................... .103
Fluids, Lubricants and Genuine Parts ...........106
Fog Lights ...............................17
Fuel ................................ .60, 66
Adding ...............................66
Diesel ......................... .60, 66, 106
Filter ............................ .93, 106
8
INDEX 123

Gauge................................17
Light .................................17
Requirements ...................... .60, 105
Specifications ...........................62
Tank Capacity ......................... .105
Gauges Fuel .................................17
Odometer .............................17
Speedometer ...........................17
Tachometer ............................17
Gear Ranges ..............................48
General Maintenance .......................17
Gross Axle Weight Rating ....................73
Gross Vehicle Weight Rating ..................72
Hitches Trailer Towing ..........................76 Information Center, Vehicle
...................30
Instrument Cluster ...................... .16, 17
Intervention Regeneration Strategy ..............96
Lights Airbag ................................17
Anti-Lock .............................17
Brake Warning ..........................17
Check Engine (Malfunction Indicator) ..........17
Cruise ................................17
Engine Temperature Warning ................17
Fog ..................................17
High Beam ............................17
High Beam Indicator ......................17
Instrument Cluster .......................17
Low Fuel ..............................17
Oil Pressure ............................17
Seat Belt Reminder .......................17
Tire Pressure Monitoring (TPMS) .............17
124 INDEX

Wait to Start............................17
Warning (Instrument Cluster Description) .......17
Maintenance, General .......................17
Maintenance Procedures .....................89
Maintenance Schedule ......................112
New Vehicle Break-In Period ...................8
Odometer ...............................17
Trip..................................17
Oil, Engine .......................... .90, 106
Capacity ............................ .105
Change Interval .........................91
Dipstick ...............................90
Disposal ..............................92
Filter ............................ .92, 106
Filter Disposal ..........................92
Materials Added to .......................92 Recommendation
.....................90, 105
Viscosity .......................... .91, 105
Power Steering Fluid ...................... .109
Radiator Cap (Coolant Pressure Cap) .........98, 101
Schedule, Maintenance .....................112
Seat Belts Reminder ..............................17
Selection of Coolant (Antifreeze) ...............106
Service Reminder Indicator ...................17
Signals, Turn .............................17
Speed Control (Cruise Control) ................12
Speedometer .............................17
Starting .................................37
Engine Block Heater ......................45
Starting Procedures .........................37
8
INDEX 125