RENAULT CLIO 2012 X85 / 3.G Owners Manual

Downloaded from www.Manualslib.com manuals search engine JauneNoirNoir texte
3.27
ENG_UD19788_2
Rangements / Aménagements habitacle (X85 - B85 - C85 - S85 - K85 - Renault)
ENG_NU_853-7_BCSK85_Renault_3
Grab handle 11
This offers support and can be held
when the vehicle is being driven. Do
not use it for getting into or out of the
vehicle.
Front seat storage
compartments 10
PassenGer COMP artMent stOraGe/FittinGs (4/4)
10
11

Downloaded from www.Manualslib.com manuals search engine cigar lighter ........................................... (up to the end of the DU)
ashtray .................................................. (up to the end of the DU)
accessories socket ............................... (up to the end of the DU)
3.28
ENG_UD12581_2
Cendriers - Allume-cigares (X85 - B85 - C85 - S85 - K85 - Renault)
ENG_NU_853-7_BCSK85_Renault_3
Ashtray/cigar lighter
Cigar lighter 3
With the ignition on, push in the cigar
lighter 3.
It will spring back with a click when it is
ready. Pull it out to use. After use, re -
place it without pushing it all the way in.
ashtray 1
It can be housed in either position 2
or 4.
asHtra Y/CiGar LiGHter
1
2
4
3
C o n n e c t a c c e s s o r i e s
with a maximum power of
120 Watts only.
Fire hazard.
If your vehicle is not fitted with a cigar lighter and an ashtray, these can be ob-
tained from an approved Dealer.

Downloaded from www.Manualslib.com manuals search engine headrest................................................ (up to the end of the DU)
adjusting your driving position .............. (up to the end of the DU)
3.29
ENG_UD19815_2
Appuis-tête arrière (X85 - B85 - C85 - S85 - K85 - Renault)
ENG_NU_853-7_BCSK85_Renault_3
The headrest is a safety
component; check that it is
fitted and in the correct po-
sition. The top of the head -
rest should be as close as possible
to the top of the head.
t o remove the headrest
Press button A of lock 1 and remove
the headrest.
t o refit the headrest
Insert the rods into the holes, press the
tabs on both rods and lower the head -
rest.
Positions for use
While pressing button A of lock 1, lift
the headrest fully to use it in the top po-
sition. Lower it until it locks to use it in
the bottom position.
storage position
Press button A and lower the headrest
completely.
When the headrest is set at the
lowest position, this is for storage
only . It should not be in this position
when a seat is occupied.
rear HeaD rests
1
a

Downloaded from www.Manualslib.com manuals search engine rear bench seat..................................... (up to the end of the DU)
rear seats functions ......................................... (up to the end of the DU)
3.30
ENG_UD25199_4
Banquette arrière : fonctionnalités (X85 - B85 - C85 - S85 - K85 \
- Renault)
ENG_NU_853-7_BCSK85_Renault_3
Jaune NoirNoir texte
Then lift up the rear section of cushion
1 and tilt the seat base so that it is next
to the front seats. t
o fold down the seatback
remove the rear headrests (if fitted).
Ensure that the front seats are far
enough forward.
Place the seat belts in their guides B.
Press button 2 and lower the seat -
back C.
Rear bench seat: functions
Before moving the seatback, put
the seat belt in belt guide B to avoid
damaging it.
For safety reasons, carry
out any adjustments when
the vehicle is not being
driven.
The configuration of the two seat
bench with the small seatback C
pulled down, does not allow the
central seat to be used as it would
be impossible to buckle the seat belt
(belt buckles inaccessible).
The seat base and the seatback may
be folded down (one or both sections)
to allow bulky objects to be carried.
Start by folding down the seat base,
then the seatback.
t o fold away the seat base (sport
tourer version)
Lift up the front of the seat cushion A
until it reaches the stop.
Where the bench seat is in one section,
check that the two sides of the seat
base are correctly locked.
rear BenCH seat : functions (1/2)
a
1
C
B
2

Downloaded from www.Manualslib.com manuals search engine JauneNoirNoir texte
3.31
ENG_UD25199_4
Banquette arrière : fonctionnalités (X85 - B85 - C85 - S85 - K85 \
- Renault)
ENG_NU_853-7_BCSK85_Renault_3
t o replace the seat base, proceed in
the reverse order to removal.
Lift up the rear bench seat cushion in
such a way so as to position the rear
section of the seat base 1 under the
seatback.
Then push the front 3 of the cushion A
in order to lock the seat base.
sport tourer version
t
o replace the seatback, proceed in
the reverse order to removal.
Refit the seatback and click it back into
place.
rear BenCH seat : functions (2/2)
1
3
aWhen moving the rear
seats, ensure that nothing
obstructs the anchorage
points (passenger’s arm or
leg, a pet, gravel, cloth, toys, etc.).
When refitting the seat -
back , make sure it is cor -
rectly locked in place.
i f seat covers are fitted ,
make sure these do not prevent the
seatback latch from locking in.
Make sure that the seat belts are
positioned correctly.
Reposition the headrests.

Downloaded from www.Manualslib.com manuals search engine rear parcel shelf .................................... (up to the end of the DU)
rear parcel shelf .................................... (up to the end of the DU)
tailgate .................................................. (up to the end of the DU)
3.32
ENG_UD25585_2
Coffre à bagages / tablette arrière (X85 - B85 - C85 - S85 - K85 - R\
enault)
ENG_NU_853-7_BCSK85_Renault_3
Boot
Rear parcel shelf
Do not place any objects,
especially heavy or hard
objects, on the parcel shelf.
These may pose a risk to
the vehicle occupants if the driver
has to brake suddenly or if the vehi-
cle is involved in an accident.
rear parcel shelf
To remove:
– unhook both straps 2;
– unhook sun visor 3 (depending on
vehicle);
– detach the flexible section attached
to the rear bench seatback (depend-
ing on vehicle);
– lift the parcel shelf then unclip it up-
wards.
To refit, proceed in the reverse order to
removal.
BOOt/rear P arCeL sHeLF
3
Maximum weight on rear parcel
shelf: 25 kg, evenly distributed.
to open
Press button 1 and lift the tailgate.
t o close
Lower the boot lid.
2
1

Downloaded from www.Manualslib.com manuals search engine 3.33
ENG_UD12582_2
Cache-bagages (X85 - B85 - C85 - S85 - K85 - Renault)
ENG_NU_853-7_BCSK85_Renault_3
Luggage cover
LUGGaGe COMP artMent COver: sport tourer versions
removing the luggage
compartment cover 1
Press button 3 and lift the right-hand
side of the roller at the same time.
Then lift the left-hand side of the roller
and remove it.
To refit the luggage cover, carry out this
procedure in reverse.
t o remove the flexible
section A of the luggage
compartment cover 1
Using the handle 2, pull the flexible part
gently A to release the pins from their
mounting points located either side of
the luggage compartment.
Guide the luggage cover onto the roller.
Luggage compartment cover
storage 1
Lift the mobile floor B.
Store the luggage compartment cover
by inserting it, one side at a time.
Replace the mobile floor.
1
a
3
B
Do not place any objects, especially heavy or solid objects on the lug-
gage compartment cover. These may pose a risk to the vehicle occu -
pants if the driver has to brake suddenly or if the vehicle is involved in
an accident.
2

Downloaded from www.Manualslib.com manuals search engine 3.34
ENG_UD12582_2
Cache-bagages (X85 - B85 - C85 - S85 - K85 - Renault)
ENG_NU_853-7_BCSK85_Renault_3
The luggage compartment cover con -
sists of a rigid section A and a folding
section B.
the luggage cover is in the unfolded
position . t
he luggage compartment cover is
removed.
To remove it: with the cover in the folded
position and holding it horizontally:
– pull one side of the luggage compart-
ment cover towards you, pivoting it
slightly;
– then pull the other side of the lug -
gage compartment cover to com -
pletely detach it from its housing.
LUGGaGe COMP artMent COver: utility versions
Do not place any objects,
especially heavy or solid
objects on the luggage
compartment cover. These
may pose a risk to the vehicle occu-
pants if the driver has to brake sud-
denly or if the vehicle is involved in
an accident.
t he luggage compartment cover is
in the folded position .
To fold it:
– lift shelf A slightly and pull it towards
you to remove;
– then fold section B back on itself.
a
B

Downloaded from www.Manualslib.com manuals search engine towing rings .......................................... (up to the end of the DU)
tailgate .................................................. (up to the end of the DU)
3.35
ENG_UD10842_1
Aménagements coffre à bagages (X85 - B85 - C85 - S85 - K85 - Renault)
ENG_NU_853-7_BCSK85_Renault_3
Luggage compartment storage
Locations for anchorage
rings 1
Useful for securing objects transported
in the luggage compartment. See the
information on “Transporting objects in
the luggage compartment”.
Depending on the vehicle, a net for re-
taining luggage on the floor, located
in the storage compartment under the
passenger seat, may be attached to
these hooks.
LUGGaGe COMP artMent stOraGe (1/2)
sport tourer versions
On equipped vehicles, remove the
mobile floor to access the rings (refer to
the information on “mobile floor”).
11
1
Always position objects being trans-
ported so that the heaviest items
are resting against the back of the
rear bench seat.

Downloaded from www.Manualslib.com manuals search engine 3.36
ENG_UD10842_1
Aménagements coffre à bagages (X85 - B85 - C85 - S85 - K85 - Renault)
ENG_NU_853-7_BCSK85_Renault_3
Mobile floor
When fitted to the vehicle, it can be
used to make loading easier.
The mobile floor can be stored in two
ways. First storage
–
Lift section 3 and fold it against sec-
tion 2;
– lift the assembly and position it
against the rear bench seat ;
– push catch 4 to lock the mobile floor
in the folded position.
note: open flap 5 to access the ISOFIX
ring and the net ring at the back of the
luggage compartment. second storage
–
Lift section 3 and fold it against sec-
tion 2;
– remove the assembly ;
– position it in the luggage compart -
ment, using the runners 6 as guides.
3
2
4
6
5
LUGGaGe COMP artMent stOraGe (2/2)
Maximum weight for the mobile
floor: 100 kg evenly distributed.