tyre pressure RENAULT KANGOO 2013 X61 / 2.G ABS Bosch 8.1 Workshop Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 2013, Model line: KANGOO, Model: RENAULT KANGOO 2013 X61 / 2.GPages: 57, PDF Size: 1.44 MB
Page 49 of 57
38C-49
AFTER REPAIRClear the computer memory using command RZ001 Fault memory.
Carry out a road test followed by another check with the diagnostic tool.
V1 MR-376-X76-38C000$170.mif
ANTI-LOCK BRAKING SYSTEM
Fault finding – Fault Finding Chart38C
ABS BOSCH 8.1
Vdiag No.: 18
ALP3 Pull
NOTESOnly address this customer complaint after a complete check with the diagnostic
tool.
Disconnect one wheel speed sensor.
Start the engine and ensure that only the ABS fault warning light comes on. Do not drive the vehicle if the brake
fault warning light is also illuminated because the "braking compensator" function is no longer guaranteed.
Carry out a road test with the ABS thus out of order.
Is the fault still present under these conditions?
Raise the vehicle so that you can rotate the wheels and check:
– whether the speed sensors have been incorrectly
connected,
– whether the pipes on the hydraulic unit have been inverted.
For these two tests, consult and apply the procedures defined
in ALP2 Locking of one or several wheels.
Check the condition and conformity of the ABS targets.
If the fault is still present, contact the techline.If the brake pedal travel is relatively long,
bleed the brake circuit.
If the travel is normal, check the tyre
pressures, the front axle, or for any leaks in
the circuit.
NOYES
ABS8.1X76_V18_ALP3
Page 50 of 57
38C-50
AFTER REPAIRClear the computer memory using command RZ001 Fault memory.
Carry out a road test followed by another check with the diagnostic tool.
V1 MR-376-X76-38C000$170.mif
ANTI-LOCK BRAKING SYSTEM
Fault finding – Fault Finding Chart38C
ABS BOSCH 8.1
Vdiag No.: 18
ALP4 Drift
NOTESOnly address this customer complaint after a complete check with the diagnostic
tool.
Disconnect one wheel speed sensor.
Start the engine and ensure that only the ABS fault warning light comes on. Do not drive the vehicle if the brake
fault warning light is also illuminated because the "braking compensator" function is no longer guaranteed.
Carry out a road test with the ABS thus out of order.
Is the fault still present under these conditions?
Normal behaviour linked to the system operation during
the regulation phase, mainly on surfaces with uneven
grip or which are poorly laid.Road holding fault not related to the ABS.
Check the condition of the brake linings and that
they are to specification and check the tyre
pressures, the front axle, etc.
NOYES
ABS8.1X76_V18_ALP4