stop start RENAULT KANGOO 2013 X61 / 2.G ABS Bosch 8.1 Workshop Manual

38C-40
AFTER REPAIRClear the computer memory using command RZ001 Fault memory.
Carry out a road test followed by another check with the diagnostic tool.
V1 MR-376-X76-38C000$150.mif
ANTI-LOCK BRAKING SYSTEM
Fault finding – Interpretation of commands38C
ABS BOSCH 8.1
Vdiag No.: 18
AC013WHEEL SPEED SENSOR SUPPLY TEST
NOTESConditions of use of the command:
Ignition on, engine stopped and vehicle speed zero.
Before running the command, check that the battery is properly charged (see 80A,
Battery, Battery: Customer complaints).
You must use command AC013 once only.
This command is used to check that voltage pulses of approximately 12 V are detected on the faulty sensor by a
multimeter on the connector terminals on the computer side, component codes 150, 151, 152, and 153.
Select the command AC013.
Note:
To restart an AC013 command, restart then stop the vehicle engine and ensure that the battery is properly
charged.
ABS8.1X76_V18_AC013