RENAULT KANGOO 2013 X61 / 2.G Engine Immobiliser User Guide

82A-11V1 MR-376-X76-82A000$050.mif
82A
SVT
Vdiag No.: 04
To remove and refit the computer, consult the Repair Manual for the vehicle concerned:
– LOGAN and SANDERO: MR 388, Mechanical, 82A, Immobiliser, Tracking unit: Removal - Refitting.
– DUSTER: MR 451, Mechanical, 82A, Immobiliser, Tracking unit: Removal - Refitting.
– MEGANE II: MR 364, Mechanical, 82A, Immobiliser, Tracking unit: Removal - Refitting.
– SCENIC II: MR 370, Mechanical, 82A, Immobiliser, Tracking unit: Removal - Refitting.
– MASTER II ph2 and ph3: MR 377, Mechanical, 82A, Immobiliser, Tracking unit: Removal - Refitting.
– THALIA 2/SYMBOL 2: MR 423, Mechanical, 82A, Immobiliser, Tracking unit: Removal - Refitting.
– Clio II F6: MR 430, Mechanical, 82A, Immobiliser, Tracking unit: Removal - Refitting.
– KANGOO VLL: MR 374, Mechanical, 82A, Immobiliser, Tracking unit: Removal - Refitting.
Procedure to be applied before repair:
– With the approval of the Techline, read the fault code to determine whether the fault is detected before replacing
the computer.
– Switch off the ignition and remove the computer.
Before replacing the computer, switch off the ignition and wait 1 minute for the system to shut down completely.
Note the current configuration of the computer by reading the configuration LC001 External GPS aerial.
Procedure to be applied after repair:
After replacing the computer, apply the programming command VP001 Enter VIN, check the computer configuration
using LC001 External GPS aerial, LC002 Timed + battery feed and LC003 Alarm and configure the new
computer if necessary using CF001 CONFIGURE SVT.
ENGINE IMMOBILISER
Fault finding – Replacement of components

82A-12V1 MR-376-X76-82A000$060.mif
82A
SVT
Vdiag No.: 04
Tool faultAssociated
DTCDiagnostic tool title
DF0019A01External GPS aerial
DF0029A02GPS internal error
DF0039A03GSM internal error
DF004 9A05Battery internal fault
DF0059A09SVT internal fault
DF0069A04SVT system internal fault
DF0079A00Configuration
ENGINE IMMOBILISER
Fault finding – Fault summary table

82A-13
AFTER REPAIRDeal with any faults displayed by the diagnostic tool.
Clear the faults from the computer memory using command RZ001 Fault memory.
V1 MR-376-X76-82A000$070.mif
82A
SVT
Vdiag No.: 04
DF001
PRESENT
OR
STOREDEXTERNAL GPS AERIAL
NOTESSwitch on the vehicle + after ignition feed.
Check the configuration of the anti-theft tracking unit by reading configuration LC001 External GPS aerial.
If the check is not correct, use command CF001 CONFIGURE SVT.
Check the condition of the aerial visually and by hand.
Disconnect then reconnect the aerial.
If the fault is still present, contact the Techline.
SVT_V04_DF001
ENGINE IMMOBILISER
Fault finding – Interpretation of faults

82A-14
AFTER REPAIRAfter replacing the computer, consult the Replacement of components section.
Deal with any faults displayed by the diagnostic tool.
Clear the faults from the computer memory using command RZ001 Fault memory.
V1 MR-376-X76-82A000$070.mif
ENGINE IMMOBILISER
Fault finding – Interpretation of faults82A
SVT
Vdiag No.: 04
DF002
PRESENT
OR
STOREDGPS INTERNAL ERROR
NOTESSwitch on the vehicle + after ignition feed.
Replace the anti-theft tracking unit (see MR 388, 451, 364, 370, 377, 423, 430, 374, Mechanical, 82A,
Immobiliser, Tracking unit: Removal - Refitting).
If the fault is still present, contact the Techline.
SVT_V04_DF002

82A-15
AFTER REPAIRAfter replacing the computer, consult the Replacement of components section.
Deal with any faults displayed by the diagnostic tool.
Clear the faults from the computer memory using command RZ001 Fault memory.
V1 MR-376-X76-82A000$070.mif
ENGINE IMMOBILISER
Fault finding – Interpretation of faults82A
SVT
Vdiag No.: 04
DF003
PRESENT
OR
STOREDGSM INTERNAL ERROR
NOTESSwitch on the vehicle + after ignition feed.
Replace the anti-theft tracking unit (see MR 388, 451, 364, 370, 377, 423, 430, 374, Mechanical, 82A,
Immobiliser, Tracking unit: Removal - Refitting).
If the fault is still present, contact the Techline.
SVT_V04_DF003

82A-16
AFTER REPAIRAfter replacing the computer, consult the Replacement of components section.
Deal with any faults displayed by the diagnostic tool.
Clear the faults from the computer memory using command RZ001 Fault memory.
V1 MR-376-X76-82A000$070.mif
ENGINE IMMOBILISER
Fault finding – Interpretation of faults82A
SVT
Vdiag No.: 04
DF004
PRESENT
OR
STOREDBATTERY INTERNAL FAULT
NOTESSwitch on the vehicle + after ignition feed.
Conditions for applying the fault finding procedure to stored faults:
The fault is declared present if the battery voltage is X < 3.5 V after 5 voltage checks.
Check the voltage and the battery connections, component code 107.
Repair if necessary.
If the fault is still present and the internal battery is currently charging, wait for approximately 2 hours so that the
internal battery voltage is X > 3.5 V.
If the fault is still present, replace the anti-theft tracking unit, component code 2186 (see MR 388, 451, 364, 370,
377, 423, 430 or 374, Mechanical, 82A, Immobiliser, Tracking unit: Removal - Refitting).
If the fault is still present, contact the Techline.
SVT_V04_DF004

82A-17
AFTER REPAIRAfter replacing the computer, consult the Replacement of components section.
Deal with any faults displayed by the diagnostic tool.
Clear the faults from the computer memory using command RZ001 Fault memory.
V1 MR-376-X76-82A000$070.mif
ENGINE IMMOBILISER
Fault finding – Interpretation of faults82A
SVT
Vdiag No.: 04
DF005
PRESENT
OR
STOREDSVT INTERNAL FAULT
NOTESSwitch on the vehicle + after ignition feed.
Replace the anti-theft tracking unit (see MR 388, 451, 364, 370, 377, 423, 430 or 374, Mechanical, 82A,
Immobiliser, Tracking unit: Removal - Refitting).
If the fault is still present, contact the Techline.
SVT_V04_DF005

82A-18
AFTER REPAIRAfter replacing the computer, consult the Replacement of components section.
Deal with any faults displayed by the diagnostic tool.
Clear the faults from the computer memory using command RZ001 Fault memory.
V1 MR-376-X76-82A000$070.mif
ENGINE IMMOBILISER
Fault finding – Interpretation of faults82A
SVT
Vdiag No.: 04
DF006
PRESENT
OR
STOREDSVT SYSTEM INTERNAL FAULT
NOTESSwitch on the vehicle + after ignition feed.
Replace the anti-theft tracking unit (see MR 388, 451, 364, 370, 377, 423, 430 or 374, Mechanical, 82A,
Immobiliser, Tracking unit: Removal - Refitting).
If the fault is still present, contact the Techline.
SVT_V04_DF006

82A-19
AFTER REPAIRDeal with any faults displayed by the diagnostic tool.
Clear the faults from the computer memory using command RZ001 Fault memory.
V1 MR-376-X76-82A000$070.mif
ENGINE IMMOBILISER
Fault finding – Interpretation of faults82A
SVT
Vdiag No.: 04
DF007
PRESENTCONFIGURATION
NOTESSwitch on the vehicle + after ignition feed.
Configure the system (see Configuration and programming).
Note:
After configuring, switch off the ignition, wait 2 minutes then switch on the ignition again to allow the configuration
to register.
Check the computer configuration by reading configuration LC001 External GPS aerial.
SVT_V04_DF007P

82A-20V1 MR-376-X76-82A000$075.mif
82A
SVT
Vdiag No.: 04
MAIN SCREEN or SUB-FUNCTION: STARTING
NOTESOnly check conformity after a full check with the diagnostic tool.
FunctionStatus or parameter checked
or actionNotes Fault finding
ACCESS/
SAFETYET001:SVT operational noneRefer to the
interpretation of ET001
ET002:System activation
requestnoneRefer to the
interpretation of ET002
ET003:Internal battery noneRefer to the
interpretation of ET003
ET004:Locating system
activenoneRefer to the
interpretation of ET004
ET005:Tracker active noneRefer to the
interpretation of ET005
ET006:SIM card noneRefer to the
interpretation of ET006
PR001Battery charge noneIn the event of a fault,
apply the interpretation
of fault DF004 Battery
internal fault.
SVT_V04_CCONF
ENGINE IMMOBILISER
Fault finding – Conformity check