85A-29V1 MR-376-X76-85A000$140.mif
WIPERS - WASHERS
Fault finding – Fault Finding Chart85A
UCH
Vdiag No.: 0F
AFTER REPAIRCarry out another fault finding check on the system.
Deal with any other faults.
Clear the stored faults.
ALP 11No windscreen wiping after an action on the windscreen washer
control
NOTESOnly consult this customer complaint after a complete check with the diagnostic
tool.
There must be no present or stored faults.
Special Note:
Use Wiring Diagrams Technical Note for Kangoo VLL.
Check that the wiper mechanism or motor are not jammed.
Check that the blades are correctly fitted to the blade holders and that each mounting nut is correctly tightened.
Check that the motor is in good condition.
Check that nothing is interfering with the windscreen wiper mechanism operation.
Check that the mechanism between the motor and the blades is correctly fitted.
Check the connection and condition of the combined wiper-washer connectors, component code 145 and the
passenger compartment electronic control unit connectors, component code 645.
If the connector or connectors are faulty and there is a repair procedure (see Technical Note 6015A, Electrical
wiring repair, Wiring: Precautions for repair), repair the connector, otherwise replace the wiring.
Check the continuity and insulation to earth and + 12 V on the following connections:
•16A between components 145 and 645,
•14E between components 145 and 645,
•14A between components 145 and 212.
If the connection or connections are faulty and there is a repair procedure (see Technical Note 6015A, Electrical
wiring repair, Wiring: Precautions for repair), repair the wiring, otherwise replace it.
If the fault is still present, contact the techline.
UCH_V0F_ALP11