emergency towing RENAULT MEGANE HATCHBACK 2016 X95 / 3.G Owners Manual

tyre pressure......................................... (up to the end of the DU)
tyre pressures ....................................... (up to the end of the DU)
tyres ...................................................... (up to the end of the DU)
4.10
ENG_UD6333_1
Pression de gonflage des pneumatiques (X95 - B95 - D95 - Renault)
ENG_NU_837-8_BDK95_Renault_4
Tyre Pressure
tyRe pReSSURe
The tyre pressure is indicated on
label A
affixed to the edge of the driv-
er’s door. Open the door to read it.
B : dimension of the tyres fitted to the
vehicle.
C : tyre pressures for the front wheels
(non-motorway).
D : tyre pressures for the rear wheels
(non-motorway).
E : tyre pressures for the front wheels
(motorway). F
: tyre pressures for the rear wheels
(motorway).
G : tyre pressure for the emergency
spare wheel.
H: emergency spare wheel tyre dimen-
sion if different to the four tyres fitted to
the vehicle.
tyre safety and use of snow
chains
Refer to the information on “Tyres”
in Section 5 for the servicing con-
ditions and, depending on the ver-
sion, the use of chains.
Special note
For vehicles used fully laden
( m a x i m u m p e r m i s s i b l e a l l - u p
weight) and towing a trailer. The
maximum speed must be limited
to 60 mph (100 km/h) and the tyre
pressure increased by 0.2 bar.
Refer to the information on “Weights”
in Section 6.
CD
Fe
g
A
H
AB
When they need to be replaced, only tyres of the same make, size, type
and profile should be used.
tyres

fitted to the vehicle should either be identical to those fitted
originally or conform to those recommended by your approved
dealer.

tool kit ................................................... (up to the end of the DU)
hubcap tool ........................................... (up to the end of the DU)
jack ....................................................... (up to the end of the DU)
puncture................................................ (up to the end of the DU)
wheelbrace ........................................... (up to the end of the DU)
trims ...................................................... (up to the end of the DU)
emergency spare wheel ....................... (up to the end of the DU)
wheelbrace ............................................................ (current page)
5.6
ENG_UD18915_3
Bloc-outils (X95 - B95 - D95 - Renault)
ENG_NU_837-8_BDK95_Renault_5
Tool kit (jack, wheelbrace, etc.)
Hubcap
tOO l KI t / wheel tr I m – wheel
The tool kit is located in the luggage
compartment: lift the carpet.
The tools included in the tool kit depend
on the vehicle.
wheelbrace 1
Jack 2
When replacing the jack, fold it cor-
rectly and position the wheelbrace cor-
rectly before replacing it in its position.
h

ubcap tool
3
T

his tool is used to remove the wheel
trims.
w

heel bolt guide
4
T

o finish loosening or starting to tighten
the wheel bolts.
towing hitch


5
Refer

to the information on “Towing” in
Section 5.
Do not leave the tools unsecured inside the vehicle as they may come
loose under braking. After use, check that all the tools are correctly
clipped into the tool kit, then position it correctly in its housing: there is a
risk of injury.
If wheel bolts are supplied in the tool kit, only use these bolts for the emergency
spare wheel: refer to the label affixed to the emergency spare wheel.
The jack is designed for wheel changing purposes only. Under no circumstances
should it be used for carrying out repairs underneath the vehicle or to gain access
to the underside of the vehicle.
2
1
3
5
wheel trim
Remove it using the hubcap tool 3 by
connecting the hook in the recess pro-
vided next to the valve
6 (to attach the
metal clip).
To refit wheel trim, align it with valve
6.
Push the retaining hooks in fully, start-
ing with side
B near the valve, followed
by
C and D, finishing at E opposite the
valve.
no

te: if you are using anti-theft bolts,
refer to the information on “Changing a
wheel”.
6
B
cD
e
4