handbrake RENAULT MEGANE SCENIC 1995 Service Repair Manual

CLUTCH
Fault finding
20
The clutch is slipping :
- when stopped, handbrake on, at 2000 to
3000 rpm, impossible to stall the engine
when letting the clutch in,
- with 4th or 5th gear engaged, the engine
seems to race.
Check the travel of
the fork (1)
INCORRECT
KEY
Fault found
Check
Operations to be
carried out
(*)Depending on version
(1)See "Removal - Refitting" chapter(2)Grommet placed on the end of the clutch
cable on the gearbox end Check the
clearance
INCORRECTCORRECT
CORRECTINCORRECT
CORRECT
Check the
condition of the
pins and support
points
INCORRECT
Replace the
faulty partsCheck the condition
of the pedal and the
assistance spring (*)
Replace the
faulty parts
Replace the
fork
OILYWORN
Check the condition
of the clutch
Replace the
clutchReplace the clutch and
repair the leak
INCORRECT
Repair the
automatic
adjustment
device
INCORRECTCORRECT
CORRECT
Check the
automatic
adjustment device
CORRECT
Check the condition
of the cable and the
anti-noise rubber
washer (2)
Check the
condition of the
fork
20-5

37
MECHANICAL ELEMENT CONTROLS
Handbrake control lever

37
MECHANICAL ELEMENT CONTROLS
Handbrake control lever

37
MECHANICAL ELEMENT CONTROLS
Handbrake control lever

37
MECHANICAL ELEMENT CONTROLS
Handbrake

37
MECHANICAL ELEMENT CONTROLS
Handbrake

MECHANISMS OF OPENINGS OTHER THAN SIDE DOORS
Hydraulic system reservoir
52
PRE5205
RR R R
EE E E
MM M M
OO O O
VV V V
AA A A
LL L L
RR R R
EE E E
FF F F
II I I
TT T T
TT T T
II I I
NN N N
GG G G
Coat the O-ring with hydraulic oil.
Fit the seal in the oil reservoir groove.
Position the reservoir on the pump.
Tighten the bolts (2) to a torque of 7 N.m.
II I I
MM M M
PP P P
OO O O
RR R R
TT T T
AA A A
NN N N
TT T T
:: : :
the hood must be closed when the
hydraulic system is filled.
Fill the reservoir with
EE E E
SS S S
SS S S
OO O O

UU U U
NN N N
II I I
VV V V
II I I
SS S S

JJ J J
22 2 2
66 6 6 oil (capaci-
ty 0.75 l).
The oil level must be between the MINIMUM and
MAXIMUM marks.
The hydraulic system is of the "AUTOMATIC
BLEED" type. The oil level
MM M M
UU U U
SS S S
TT T T
be checked with
the hood open, hood cover closed.
Check the oil level and top up if necessary.
Switch on the ignition, apply the handbrake.
Operate the hood switch.
Open and close the hood several times.
The bleeding process is completed when move-
ment is regular and without jolts with a constant
level of pump noise. Remove:
- the filler bolt (1) and drain,
- the reservoir mounting bolts (2).
12297-1R
52-16