TYRE PRESSURE MONITOR
Fault finding - Conformity check
35B
UCH
Program no.: 350 and higher
Vdiag No: 48-4C-4D-4F-50TYRE PRESSURE MONITOR
Fault finding - Conformity check
NOTESOnly check conformity after a complete check using the diagnostic tool.
Test conditions: Engine switched off, after ignition feed on, tyres inflated to correct
pressure.
Order Sub-functionParameter or Status
checked or ActionDisplay and notes Fault finding
1Tyre receiverET040:Tyre pressure
monitoring
systemACTIVE– In the event that
status ET040 is
INOPERATIVE, refer to
the interpretation of
status ET040.
ET037:Tyre pressure
appropriate for
speedYES, if the pressure is
appropriate for the
vehicle speed.– If status ET037 is NO,
consult the
interpretation of status
ET037.
PR008:Vehicle speedX = 0 (in km/h)If the vehicle speed signal
is incorrect, carry out fault
finding on the ABS.
ET036:Wheel
pressure
imbalanceNONE, if the pressures of
the two front-axle and two
rear-axle tyres are
balanced.
(pressure difference
between the two tyres on
the same axle < 0.5 bar)
⇒ Readjust the pressure.
– FRONT, if the
pressures of the two
front tyres are not
balanced.
– REAR, if the
pressures of the two
rear tyres are not
balanced.
– FRONT/REAR, if the
pressures of the two
front-axle and two rear-
axle tyres are not
balanced.
⇒ See the interpretation of
status ET036.
ET045:Radiofrequency
signal receivedNO– Status ET045
becomes YES when the
receiver integrated into
the UCH receives a
signal.
To check whether the
receiver is functioning
normally, carry out a door
locking request with the
card and check that the
status switches to YES.
SSPP_V48_CCONF/SSPP_V4C_CCONF/ SSPP_V4D_CCONF/SSPP_V4F_CCONF/SSPP_V50_CCONF
Edition 4
35B-18
