run flat RENAULT SCENIC 2006 J84 / 2.G Tyre Pressure Monitoring Workshop Manual

TYRE PRESSURE MONITOR
Fault finding - Introduction
35B
35B-2
UCH
Program no.: 350 and higher
Vdiag No: 48-4C-4D-4F-50
135BTYRE PRESSURE MONITOR
Fault finding - Introduction
1. SCOPE OF THE DOCUMENT
This document presents the fault finding procedure applicable to all computers with the following specifications:
2. PREREQUISITES FOR FAULT FINDING
Documentation type
Fault finding procedures (this document):
–Assisted fault finding (integrated into the diagnostic tool), Dialogys.
Wiring diagrams:
–Visu-Schéma (CD-ROM).
Diagnostic tools type:
–CLIP
Special tooling required:
3. REMINDERS
Procedure
To run fault finding on the vehicle's computers, switch on the ignition in fault finding mode (forced + after ignition
feed).
Proceed as follows:
–vehicle card in reader,
–Press and hold start button (longer than 5 seconds) with start-up conditions not fulfilled,
–Then connect the diagnostic tool and perform the desired operations. Vehicle(s): SCENIC II
Function concerned: Tyre Pressure MonitorName of computer: UCH
Program no.: 0350 and higher
Vdiag No: 48, 4C, 4D, 4F, 50
Special tooling required
Multimeter
Elé. 1681Universal bornier
Ms. 1607Valve exciter
Pressure gauge
Tyre inflation system
SSPP_V48_PRELI /SSPP_V4C_PRELI/SSPP_V4D_PRELI/SSPP_V4F_PRELI/SSPP_V50_PRELI
Edition 4