fuse RENAULT SCENIC 2010 J95 / 3.G Engine Compartment Connection Unit Owner's Manual

87G - 55
ENGINE COMPARTMENT CONNECTION UNIT
Fault finding - Fault Finding Chart (ALP)
87G
V6 MR-372-J84-87G000$924_eng.mif
UPC
Vdiag No.: 44
ALP 2 The starter does not work
NOTESCheck for any faults in the multiplex network by running the network test.
Refer to the Starting function to check that the starting conditions are met.
Check that status ET010 Conditions for starting the engine satisfied is YES after a
press of the start button, if not refer to the relevant status interpretation procedure.
Check:
–the condition and connection of fuse F3.
Replace it if necessary.
Check the starter cabling (terminal tightness, continuity).
Check the condition and connection of starter power supply fuse.
Replace it if necessary.
Check the condition and connection of connector PPM1 in the Protection and Switching Unit and the control
terminal on the starter motor.
Repair if necessary.
If everything is correct, check, by running the starter, for a +12 V supply on the control terminal on the starter.
If correct, carry out a fault finding procedure on the starter.
Check that the insulation against earth and continuity of the connection:
UPC connector PPM1 track 3 The control terminal on the starter.
Repair if necessary.
If the fault is still present, contact the Techline.
AFTER REPAIRDeal with any other possible faults.
Switch off the ignition and carry out a road test followed by a test with the diagnostic
tool.