light RENAULT TWINGO 2009 2.G Chasiss ESP Owner's Guide

38C-91
AFTER REPAIRClear the computer fault memory.
Carry out a road test followed by another check with the diagnostic tool.
V3 MR-413-X44-38C050$180.mif
ANTI-LOCK BRAKING SYSTEM
Fault finding – Fault finding chart38C
Bosch 8.1 ESP
Vdiag No.: 05
ALP5Unexpected ABS operation at low speed and with slight pedal
pressure
NOTESOnly address this customer complaint after a complete check with the diagnostic tool.
Important: ABS regulation is sensitive on slippery surfaces (ice, wet cobbled
streets, etc.).
Brake pedal vibrations associated with the reactions of the system may be felt in
particular circumstances, such as:
–Crossing speed bumps.
–Tight cornering with lifting of the inside rear wheel.
These vibrations also may be linked merely to activation of the Braking distributor
function, when the pressure on the rear axle is limited.
Check the conformity of the mechanical components (see MR 411, Mechanical,
30A, General information, Brake, Specifications).
If the fault is not one of the situations indicated above, check the correct connection of the wheel speed sensors,
the air gap between these sensors and the magnetic targets.
Refer to the interpretation of fault DF063 Wheel speed consistency.
ESP_V05_ALP5

38C-99
AFTER REPAIRClear the computer fault memory.
Carry out a road test followed by another check with the diagnostic tool.
V3 MR-413-X44-38C050$180.mif
ANTI-LOCK BRAKING SYSTEM
Fault finding – Fault finding chart38C
Bosch 8.1 ESP
Vdiag No.: 05
ALP 13 Faulty brake light illumination
NOTESOnly address this customer complaint after a complete check with the diagnostic tool.
Using the diagnostic tool, check the consistent status ET017 "Brake pedal" for pedal pressed and pedal
released.
If inconsistent, apply the fault finding procedure for status ET017 Brake pedal.
If the lights come on continuously, check the operation of component 1281 using command AC187 Brake light
activation relay. The brake lights must light only when the command is run.
Otherwise, with component 1281 removed, check the continuity between connections 65A and 65G of
component 1281.
If continuity is not guaranteed, replace component 1281.
ESP_V05_ALP13

38C-101
AFTER REPAIRClear the computer fault memory.
Carry out a road test followed by another check with the diagnostic tool.
V3 MR-413-X44-38C050$180.mif
ANTI-LOCK BRAKING SYSTEM
Fault finding – Fault finding chart38C
Bosch 8.1 ESP
Vdiag No.: 05
ALP15Intermittent illumination of brake, ESP, ABS, SERVICE and STOP
warning lights and the message "brake failure" on the instrument
panel with no fault codes in the computer
NOTESSpecial notes:
Only address this customer complaint after a complete check with the diagnostic tool.
Problem with external supply to the computer:
The computer is intermittently without supply because of bad contacts in the electrical
supply circuit.
Refer to the interpretation of fault DF001 Computer supply.
ESP_V05_ALP15