trip RENAULT TWINGO 2009 2.G Mechanism And Accessories Owner's Manual

56A-12
EXTERIOR EQUIPMENT
Side decorative strips: Removal - Refitting
56A
aStick down the side decorative strip to the two edges
using the plastic spatula.
aSmooth edge with a movement from the rear to the
front ensuring that the side decorative strip is pro-
perly bonded on the run channel side.
aFold back edge gradually over its entire length with
the plastic spatula and finish the application with
your thumb along the interior of the upright.
III - FINAL OPERATION.
aRefit:
-the front door channel (see Front side door win-
dow run channel: Removal - Refitting) ,
-the front door exterior weatherstrip (see Front side
door exterior weatherstrip: Removal - Refitting)
.
120790

56A-14
EXTERIOR EQUIPMENT
Sill panel extension: Removal - Refitting
C44, and EQUIPMENT LEVEL SPORT
56A
aDrill out rivets (5) .
aRemove the sill panel extender mountings.
REFITTING
I - REFITTING PREPARATION OPERATION
aCheck the condition of the clips and replace them if
necessary.aApply a strip of masking tape at (6) to protect the
rear wing extender.
a
Inject WAX FOR HOLLOW SECTIONS into the sill
panel to protect the rivets (see Anti-corrosion pro-
tection product: Description) (04E, Paint).
II - REFITTING OPERATION FOR PART
CONCERNED
aRefit the sill panel extender mountings.
aRefit the sill panel extender.
aClip the sill panel extender (2) .
aRefit clips (1) .
III - FINAL OPERATION.
aRefit the front sill panel trim (see Front door sill
lining: Removal - Refitting) (71A, Body internal
trim).
131790
WARNING
To avoid any risk of corrosion after the localised
stripping of the panel, reapply the protective coa-
ting (see Technical Note 0592A).
131790
Note:
It is not necessar y to inject WAX FOR HOLLOW
SECTIONS except when removing and refitting
the sill panel extender mountings.