AUX RENAULT TWINGO 2012 2.G Owners Manual

additional systems to the seat belts.......................(current page)
seat belt pretensioners .......................................... (current page)
1.23
ENG_UD16831_2
Dispositifs complémentaires aux ceintures arrière (X44 - Renault)\
ENG_NU_952-4_X44_Renault_1
METhODs OF REsTRAINT IN ADDITION TO ThE REAR sEAT BELTs
Force limiter
Above a certain severity of impact, this
mechanism is used to limit the force of
the belt against the body so that it is at
an acceptable level.
– Have the entire restraint
system checked following
an accident.
– No operation whatsoever
is permitted on any part of the
system (air bags, electronic con-
trol units, wiring) and the system
components must not be reused
on any other vehicle, even if iden -
tical.
– To avoid incorrect triggering of
the system which may cause
injury, only qualified RENAULT
Network personnel may work
on the pretensioner and air bag
system.

headlight beam adjustment ................................... (current page)
electric beam height adjustment ............................ (current page)
1.61
ENG_UD26566_4
Réglages électriques de la hauteur des faisceaux (X44 - Renault)\
ENG_NU_952-4_X44_Renault_1
Examples of positions for adjusting
control A according to the load
All versions except
commercial vehicles Commercial vehicles
Driver only 0_
Driver alone or with front
passenger 0
_
Driver with one front
passenger and two rear
passengers 1
–
Driver with three
passengers with luggage 2
–
Driver with luggage or load
reaching the maximum
authorised load weight 3
3
Headlight beam adjustment
ELECTRIC BEAM hEIGhT ADJUsTMENT
On vehicles fitted with this function,
control A allows you to adjust the height
of the beams according to the load.
Turn control A downwards to lower the
headlights and upwards to raise them.
A
If driving on the left in a left-hand
drive vehicle (or vice versa), drivers
must have the lights adjusted by an
authorised dealer for the duration of
the trip.

engine oil level ...................................... (up to the end of the DU)
engine oil .............................................. (up to the end of the DU)
brake fluid .............................................................. (current page)
4.7
ENG_UD24738_5
Niveaux / Filtres (X44 - Renault)
ENG_NU_952-4_X44_Renault_4
Levels:
Brake fluid
Topping up
After any operation on the hydraulic cir-
cuit, a specialist must replace the fluid.
Only use fluids approved by our
Technical Department (and taken from
a sealed container).
Replacement intervals:
Refer to the Maintenance Document for
your vehicle.
Brake fluid
The level should be read with the engine
switched off and on level ground.
This should be checked frequently,
and immediately if you notice even the
slightest loss in braking efficiency. Level
It is normal for the level to drop as the
brake shoes become worn, but it must
never drop lower than the
“MIN” warn-
ing line on the reservoir 1.
If you wish to check the disc and drum
wear yourself, you should obtain the
document explaining the checking pro-
cedure from our network or from the
manufacturer’s web site.
LEVELS (1/3)
When working in the engine
compartment, ensure that
the windscreen wiper stalk
is in the park position.
Risk of injury.The engine may be hot
when carrying out opera -
tions in close proximity. In
addition, the engine cooling
fan can come on at any moment.
Risk of injury.
1

coolant ................................................................... (current page)
4.8
ENG_UD24738_5
Niveaux / Filtres (X44 - Renault)
ENG_NU_952-4_X44_Renault_4
Jaune NoirNoir texte
Engine coolant
LEVELS (2/3)
Coolant
With the engine switched off and on
level ground, the level when cold
must be between the “MIN” and “MAX”
marks on reservoir 2.
Top this level up when cold before the
“MIN” mark is reached. Replacement intervals
Refer to the Maintenance Document for
your vehicle.
Checking intervals
Check the coolant level regularly
(very severe damage is likely to be
caused to the engine if it runs out of
coolant).
If the level needs to be topped up, only
use products approved by our Technical
Department which ensure:
–
protection against freezing;
– anticorrosion protection of the cool -
ing system.
No operations should be
carried out on the cooling
circuit when the engine is
hot.
Risk of burns.When working in the engine
compartment, ensure that
the windscreen wiper stalk
is in the park position.
Risk of injury.
Consult your approved dealer at
once if you notice an abnormal or
repeated drop in any of the fluid
levels.
2

tanks and reservoirs:windscreen washer .......................................... (current page)
filter passenger compartment filter .......................... (current page)
filter air filter ............................................................. (current page)
filter diesel filter ........................................................ (current page)
JauneNoirNoir texte
4.9
ENG_UD24738_5
Niveaux / Filtres (X44 - Renault)
ENG_NU_952-4_X44_Renault_4
Jets
To adjust the angle of the jets, pivot the
little ball using a pin.
Windscreen washer reservoir
Filling
With the engine switched off, open
cap 3 , fill until you can see the fluid,
then refit the cap.
Fluid
Water + special windscreen washer
fluid (antifreeze product in winter).
Windscreen washer reservoir
Filters
LEVELS (3/3)/FILTERS
When working in the engine
compartment, ensure that
the windscreen wiper stalk
is in the park position.
Risk of injury.
Filters
The replacement of filter elements (air
filter, passenger compartment filter,
diesel filter, etc.) is scheduled in the
maintenance operations for your vehi -
cle.
Replacement intervals for filter el -
ements: refer to the maintenance
Document for your vehicle.
Consult an approved Dealer at once
if you notice an abnormal drop in
any of the fluid levels.
NOTE
Depending on the vehicle, to find
out the fluid level, open cap 3 and
pull out the dipstick.
The engine may be hot
when carrying out opera -
tions in close proximity. In
addition, the engine cooling
fan can come on at any moment.
Risk of injury.
3

lights:indicator lights .................................................. (current page)
side indicator lights changing bulbs ................................................. (current page)
5.21
ENG_UD1405_1
Répétiteurs latéraux : remplacement des lampes (X44 - Renault)\
ENG_NU_952-4_X44_Renault_5
Répétiteurs latéraux
InDIcA tOr LIgHtS: changing bulbs
Unclip indicator light 1 (using a flatb -
lade screwdriver or similar) with care.Turn bulb holder 2 a quarter of a turn
and take out the bulb.
Bulb type: WY 5 W.
The bulbs are under pres -
sure and can break when
replaced.
Risk of injury.
12