reset RENAULT TWINGO RS 2009 2.G Electrical Equipment - Radio Workshop Manual

86A-7
MR-413-X44-86A000$378_eng.mif
V1
86A
RADIO
General Information
For repairs or fault finding, the receiver is fitted with a test menu (see radio self-test procedure).
The radio will operate for approximately 20 minutes without the ignition being switched to the accessories position.
The radio bleeps then switches off.
Notes:
●All radios are designed to control a CD changer.
●There is a special procedure for replacing the CD changer located in the dashboard front panel.
RADIO FUNCTION
The tuner has three selection modes displayed on the screen and accessible from the radio front panel:
–manual mode (MANU),
–preset mode (PRESET),
–alphabetical mode (LIST).
CD FUNCTION
The CD player can play conventional discs and any audio tracks on a CD-ROM.
CDs can be played in order or tracks can be chosen at random.
If a CD changer is being used, random play is possible on only one of the possible 6 compact discs.
THERMAL PROTECTION
If the radio temperature is too high for it to function properly, the volume is automatically reduced (without changing
the volume shown in the display).
Should one of the speaker tracks short circuit, the supply to the amplifier will be cut off.
VOLUME CONTROL
The volume can be increased according to the vehicle speed. To activate the function, select the desired volume
adjustment curve in expert mode (press and hold the source button until you hear a bleep): SPEED 5 for maximum
increase, 0 to switch off the increase function.
*RDS: Radio Data System
MR-413-X44-86A000$378_eng.mif

86A-31
MR-413-X44-86A000$819_eng.mif
V1
RADIO
Fault finding chart86A
*SDVC: Speed-dependent volume control.
ALP 7 The volume does not increase with the vehicle speed.
The SDVC* function does not work.
Check the radio configuration (Expert mode).
Set the “SPEED” curve to 5 and run a test when
driving at a speed greater than 48 mph (80 km/h).
Does the volume vary?
YES
The fault has been rectified.
Reset the control to: CURVE 2.
NOCheck the signal on connection 47F
(See Wiring Diagrams Technical Note New
Twingo, code 261) with a multimeter in the
frequency meter position or with an
oscilloscope.
The frequency should change with the speed.
Does the signal frequency change with the
speed?
NO YES
Replace the radio.
The fault is linked to the speed signal
(see 38C, Anti-lock braking system,
conformity check).

86A-35
MR-413-X44-86A000$819_eng.mif
V1
RADIO
Fault finding chart86A
ALP 11 The radio reads CDs randomly
CDs are read, but randomly.
Do CDs jump while an audio track is playing?
NO
Is the CD player configured in Random mode?
YES
Reset the CD player configuration to
continuous mode.
YESCheck the condition of the CD.
NOReplace the radio.