climate control Seat Alhambra 2005 User Guide
[x] Cancel search | Manufacturer: SEAT, Model Year: 2005, Model line: Alhambra, Model: Seat Alhambra 2005Pages: 272, PDF Size: 6.35 MB
Page 143 of 272
Climate control139
Safety FirstControls and equipment Tips and Maintenance Technical Data
When the appropriate buttons are pressed, heated, unheated air or
cooled air flows from all vents in the front.
The vents are controlled automatically by the Climatronic in AUTO
mode.When the AUTO mode is switched off, the vents can be controlled
using buttons11, 15and 16.
V Ve
en
nt
ts
s
3and 4can be opened and closed separately. Moreover,
1
2
2
43
32
2
4
5 5
66
6 1
1
1
AL0-022
Air vents in driver’s compartment (front)
Fig. 134
Page 144 of 272
Climate control140
the air flow from these vents can be changed vertically and
horizontally
⇒fig. 135.
The rear footwell vents
6are supplied together with vents5.K
Opening/closing vents
Vents3and 4can be opened and closed individually:
Vent closed: knurled wheel to . . . . . . .0
Vent opened: knurled wheel to . . . .
A Ad
dj
ju
us
st
t ddi
ir
re
ec
ct
ti
io
on
n oof
f aai
ir
rf
fl
lo
ow
w
Vertical – move knurled wheel
1upwards or downwards.
Horizontal – move knurled wheel
2to the left or right.K
Air vents in passenger compartment (rear)
V Ve
en
nt
t iin
n ffl
lo
oo
or
r
The vents are in the side trim on the floor of the passenger
compartment at the rear left of the vehicle. Warm air will flow out of
these vents when the interior temperature has been set to the
highest level using button
21. ”HI” will appear in the Climatronic
display.
N No
ot
te
e
Please do not use the area around the vents as stowage space as the vent
openings will be blocked and the additional heat exchanger blower will turn
off due to overheating.
Fig. 135
Fig. 136AL0-116
1
2
AL0-023
Page 145 of 272
Climate control141
Safety FirstControls and equipment Tips and Maintenance Technical Data
Vent in roof*
O On
nl
ly
y wwh
he
en
n tth
he
e CCi
im
ma
at
tr
ro
on
ni
ic
c hha
as
s aa sse
ec
co
on
nd
d cco
oo
ol
li
in
ng
g ssy
ys
st
te
em
m
The air vents in the roof are situated above each seat in the rear –
only cooled air enters the vehicle.
The roof vents can be closed or opened separately and can also be
adjusted by pivoting the vent grilles
⇒fig. 138.N No
ot
te
e
When cooled air mode is switched on, at least one vent in the roof area
must be open or the cooling system may ice up.K
Opening/closing vents
To close vent – turn wheelAdown.
To open vent – turn wheel
Aup.
C Ch
ha
an
ng
gi
in
ng
g aai
ir
r ffl
lo
ow
w ddi
ir
re
ec
ct
ti
io
on
n:
:
Vertically – move grille up or down.
Horizontally – move lever
Bin the grille to the left or right. K
Fig. 137Fig. 138
W Wa
ar
rm
m aai
ir
r cco
om
mi
in
ng
g ffr
ro
om
m tth
he
e vve
en
nt
t cca
an
n dda
am
ma
ag
ge
e hhe
ea
at
t sse
en
ns
si
it
ti
iv
ve
e iit
te
em
ms
s.
.
K
W WA
AR
RN
NI
IN
NG
G
ABAL0-118AL0-117
Page 146 of 272
Climate control142
General notes
• Ensure that the sensor on the air grille next to the display is not
covered up.
• To ensure that the Climatroniccan work properly, the air inlet in
front of the windscreen should be kept free of ice, snow and
leaves.
• The heat output depends on the coolant temperature – the full
heat output is therefore available when the engine is warm.
• Odours caused by a build-up of natural deposits in the vaporiser
can occur if the AUTO system has not been used for some time. The
cooling system should be turned on at fullblast at least once a
month – even during cold spells – to clear or to prevent the
odours.
• The stale air escapes through openings in the luggage
compartment side panels. Therefore when loading the luggage
compartment ensure that the openings are not covered.
• When the ambient temperature is high and the air very humid,
condensed water can drip off the evaporator and form a puddle
under the vehicle. This is quite normal and does not indicate a
leak.
• To prevent the windows from misting up the blower should be
running slowly when driving at low speeds. To do this select ECON
or AUTO.
K
Using Climatronic economically
In cooling operation the Climatronic compressor places demands
on the engine and therefore influences the fuel consumption. Tokeep the period switched on as short as possible, the following
points should be noted:
• If the inside temperature is very high after the car has been
parked in the sun, it is recommended to open doors or windows
briefly to enable the hot air to escape.
• The compressor should not be switched on during a journey if
the windows or sliding roof* are open.
• ECON mode should be selected if the desired interior
temperature can be attained without switching on the air
conditioner.
K
Operating faults
• If all the symbols in the display area flash for some 15 seconds
after switching the ignition on, there is a fault in the system.
Contact a Technical Service Centre.
• Should the cooling system not work at any time, either:
– the ambient temperature is below about +5 °C,
– the Climatronic compressor has switched off due to coolant
temperature being too high.
– or the fuses have blown.
Check the fuse and if necessary replace
⇒"Fuses" chapter. If the
trouble is not due to a defective fuse, have Climatronic checked.
• If the cooling output drops off, switch the Climatronic off and
have the system checked.
K
Page 191 of 272
187 Checking and refilling
Safety FirstControls and equipment Tips and Maintenance Technical Data
P
Pe
et
tr
ro
ol
l een
ng
gi
in
ne
e
D Di
ie
es
se
el
l een
ng
gi
in
ne
eM Mo
on
no
o-
-g
gr
ra
ad
de
e ooi
il
l
Mono-grade oils cannot be used throughout the whole year due to
their limited range of viscosity
2).
These oils are only useful in a climate that is constantly very cold or
very warm.
E En
ng
gi
in
ne
e ooi
il
l aad
dd
di
it
ti
iv
ve
es
s
No type of additive should be mixed with the engine oil. The
deterioration caused by these additives is not covered by the
guarantee.
N No
ot
te
e
Before a long trip, we recommend finding an engine oil that conforms to the
corresponding VW specifications and keeping it in the vehicle. In this way
the required oil will be available if needed.
K
D De
en
no
om
mi
in
na
at
ti
io
on
nS
Sp
pe
ec
ci
if
fi
ic
ca
at
ti
io
on
nC
Co
om
mm
me
en
nt
ts
s
A – synthetic oilVW 502 00 /Dated after
VW 500 00 1-97
B –
mineral oilVW 501 01Dated after
1-97
A/B –
multi-grade oilACEA A2 or A3 or Dated after
even API SH/SJ 1-97
D De
en
no
om
mi
in
na
at
ti
io
on
nS
Sp
pe
ec
ci
if
fi
ic
ca
at
ti
io
on
nC
Co
om
mm
me
en
nt
ts
s
A – synthetic oilVW 505 011)Dated after
1-97
B –
mineral oilVW 505 00Dated after
1-97
A/B –
multi-grade oilACEA A2 or A3 or Dated after
even API CD/CF 1-97
1)Diesel engines that have fuel injection based on a fuel injector pump should use only
oil specification VW 505 01. Avoid the use of any other oil type than VW 505 01 for this
engine. Warning! Possible engine damage!
2)Viscosity: Oil density