heater Seat Arona 2020 Owner's Manual
[x] Cancel search | Manufacturer: SEAT, Model Year: 2020, Model line: Arona, Model: Seat Arona 2020Pages: 372, PDF Size: 7.8 MB
Page 50 of 372
Emergencies
Connect the other end of the black
jump
l ead X to a solid metal component bol-
t ed t
o the engine bl ock or t
o the engine
bl
ock itself of the vehicle with the flat
battery. Do not connect it to a point near
the battery A .
P osition the l
eads in such a w ay that
they cannot come int o cont
act with any
moving parts in the engine compart-
ment.
Starting Start the engine of the vehicle with the
boosting battery and let it run at idling
speed.
Start the engine of the vehicle with the
flat battery and wait for 2 or 3 minutes
until the engine is running.
Removing the jump leads Before you remove the jump leads,
switch off the dipped beam headlights if
they are switched on.
Turn on the heater blower and heated
rear window in the vehicle with the flat
battery. This helps minimise voltage
peaks which are generated when the
leads are disconnected.
When the engine is running, disconnect
the leads in reverse order to the details
given above.
5.
6.
7.
8.
9.
10.
11.
Make sure the battery clamps have sufficient
metal-to-metal cont
act with the battery ter-
minals.
If the engine fails to start after about 10 sec-
onds, switch off the starter and try again after
about 1 minute. WARNING