warning Seat Mii electric 2019 Owner's Guide

Transport and practical equipment
of the roof carrier, the cross bars and the load
itself on the r oof
›
›› .
Al w
ays check the weight of the roof carrier
system, the cross bars and the weight of the
load to be transported and weigh them if
necessary. Never exceed the maximum au-
thorised roof load.
If you are using cross bars and a roof carrier
with a lower weight rating, you will not be
able to carry the maximum authorised roof
load. In this case, do not exceed the maxi-
mum weight limit for the roof carrier which is
listed in the fitting instructions.
Distributing a load
Distribute loads uniformly and secure them
correctly ››› .
Check att achments
Once the cr

oss bars and roof carrier system
have been installed, check the bolted con-
nections and attachments after a short jour-
ney and subsequently with a certain frequen-
cy. WARNING

Operation
Drinks holder of the centre console Fig. 104
In the front part of the centre console:
drink hol der
. Fig. 105
In the rear part of the centre console: There are drink holders in the front and rear
parts of the centr
e consol

e.
Securing the drink container in the front
drink holder
Fold the drink holder ››› Fig. 104 forward. Place the drink container in the drink holder
so that it is securely surr

ounded.
Power socket Po
wer socket and USB connection* Fig. 106
Front centre console: 12-volt power
outl et on the st

orage compartment and USB in-
terface. Electrical equipment can be connected to
the sock
et in the v

ehicle.
All connected appliances should be in per-
fect working order without any faults.
Maximum power consumption Power socket
Maximum power con-
sumption
12 Volts 120 Watts The maximum capacity of the socket must
not be e
x

ceeded. The power consumption is
indicated on the rating plate of each appli-
ance.
Where 2 or more appliances are connected
at the same time, the total rating of all the
connected devices must never exceed 190
Watts ››› .
12 v olt po

wer socket
The 12 volt socket is found in the storage
compartment at the front of the centre con-
sole ››› Fig. 106 and only works when the ig-
nition is switched on.
With the ignition switched on, the drive sys-
tem stopped and the electrical appliances
switched on, the vehicle's 12-volt battery is
discharged. Therefore, electrical devices
connected to the socket should only be used
when the drive system is operating.
To prevent voltage fluctuations from causing
damage, turn off the electrical device con-
nected to the 12-volt socket before connect-
ing and disconnecting the ignition, as well as
before starting the drive system. WARNING
Improper use of the socket or electrical de-
vices coul d l

ead to a fire and cause serious
injuries.

Air conditioning
Air conditioning
Heating, v entil
ation and
cooling
Introduction The Climatr
onic
cools and dehumidifies the
air. Its optimum performance is achieved with
the windows closed.
To switch a specific function on, press the ap-
propriate button. Press the button again to
switch off the function.
The LED on each control lights up to indicate
that the respective function of a control has
been switched on.
Dust and pollen filter
The dust and pollen filter with its activated
charcoal cartridge serves as a barrier
against impurities in the air taken into the ve-
hicle interior.
The dust and pollen filter must be changed
regularly so that air conditioner performance
is not adversely affected.
If the filter loses efficiency prematurely due to
use in areas with very high levels of air pollu-
tion, the filter must be changed more fre-
quently than stated in the Service Schedule. WARNING
Reduced visibility through the windows in-
cr eases the risk of serious accidents.

Infotainment System
Infotainment System
Intr oduction
Saf
ety warnings
Safety instructions relating to the
Infotainment system Only operate the infotainment system and its
v
arious functions when the tr

affic situation
really permits this. WARNING

Operating modes
You may still need to manually start playback
on the Bluet ooth®
sour
ce. When playback on
the Bluetooth ®
audio source is stopped, the
Infotainment system remains in Bluetooth ®
Audio mode.
Controlling playback
The extent to which the Bluetooth ®
audio
source can be controlled via the Infotainment
system depends on the connected Blue-
tooth ®
audio source.
With media players that support the AVRCP
Bluetooth ®
profile, playback on the Blue-
tooth ®
audio source can be automatically
started or stopped when the unit is switched
to Bluetooth ®
Audio mode or to a different au-
dio source. In addition, it is possible to view or
change the track via the Infotainment system. WARNING
Do not perform the pairing and connection
pr ocess whil

e driving. This may cause an
accident! Note

Operating modes
WARNING
General, mandatory, legal and country-
specific instructions and l aws f
or the use of
mobile phones inside the vehicle must al-
ways be considered. Note

Drive system and driving
display. Additionally, a warning acoustic sig-
nal may sound.
The purpose of the w arning is t
o remember to
switch off the ignition before leaving the vehi-
cle. WARNING
If the vehicle keys are used negligently or
without pr oper att

ention, accidents and se-
rious injuries can occur.

Drive system and driving
rear lid and the bonnet are completely
cl
osed and l
ocked. WARNING
Never disconnect the drive system when
the v ehicl

e is in motion. This could cause
loss of control of the vehicle, accidents and
serious injury.

Driving
A short sequence of acoustic signals indi-
cat es that the driv
e system has been recon-
nected.
If 30 seconds elapse without the drive system
being reconnected, the drive system can be
reconnected manually as described in
››› page 141. In this case, bear in mind the
messages shown on the instrument panel
display. WARNING
If the vehicle is left unattended with the
driv e syst

em connected, accidents and se-
rious injuries can occur.

Driving
When   or  profiles are selected, the
corr esponding inscription remains on in the
selection button of the driving profile
››› Fig. 139.
Characteristics of driving profiles This driving profile is always adjusted
when the drive system is connected. All
the power of the electric engine is avail-
able. The Climatronic works in normal
mode. When the Normal profile is selec-
ted, the Driving Mode Normal mes-
sage appears on the instrument panel
display.
In the ECO driving profile, the power of
the electric engine is limited to favour
lower energy consumption. The maxi-
mum speed is reduced. The Climatronic
switches to Eco mode, optimal for low
consumption, in which the fan and the
defrosting/demisting functions are still
available. When the ECO profile is selec-
ted, the Driving Mode Eco message
appears on the instrument panel dis-
play.
In the ECO+ driving profile, the power
of the electric engine is limited even
more to favour even lower energy con-
sumption. The maximum speed is re-
duced. The heating and cooling func-
tions of the Climatronic are disconnec-
ted; the fan and the defrosting/demisting
functions are still available. When the
Normal
ECO
ECO+
ECO+ profile is selected, the Driving
Mode Eco message appears on the in-
strument panel displ
ay. WARNING
The driving properties may change de-
pending on the sel ect

ed driving profile.
Never allow the selection of the driving pro-
file to induce you to take any risk that com-
promises safety.