ESP Seat Toledo 2006 COMMUNICATION SYSTEM

Foreword
This owner's manual and the corresponding supplements should be read carefully to familiarise yourself with
your vehicle.
Also, the regular care and maintenance and correct handling of the vehicle will contribute to preserve its value.
For safety reasons, note the information concerning accessories, modifications and parts exchange.
If selling the vehicle, give all of the onboard documentation to the new owner as this should be kept with the
vehicle.

General Information3
General Information
This manual contains information, recommendations, advice and warnings
related to your communication system equipment. In the other publications
of the onboard documentation there are other important instructions that the
driver and passengers should be aware of for their own safety.
Ensure that the onboard documentation is kept in the vehicle at all times.
This is especially important when lending or selling the vehicle to another
person
This manual describes the vehicle equipment at the time of publication.
Some of the equipment described here will not be available until a later date,
or is available only in certain markets.
Illustrations are intended as a general guide, and may vary from the equip-
ment fitted in your ve hicle in some details.
The locations indicated for the components are always from a forward-facing
point of view , unless otherwise stated.
The equipment marked with an asterisk * comes in series only in determined
model versions, is optional in some models, or is only offered in specific
countries.
® Registered trademarks are marked ®. However, the absence of this
symbol does not constitute a waiver of the rights concerning any propri-
etary name.
bThe section is continued on the following page.
žIndicates the end of a section .
WARNING
Texts with this symbol contain safety information. They warn you of serious
dangers, possibly involving accident or injury.
Caution
Texts with this symbol draw your attention to a possible risk of damage to
your vehicle.
For the sake of the environment
Texts with this symbol refer to points relevant to the protection of the environ-
ment.
Note
Texts with this symbol contain additional information of a more general
nature. In certain countries there may be different units of measurement than
the ones used in this manual. For example, miles and gallons may be used
instead of kilometres and litres.

Communication5
Basic functions
The speech control system can be activated via the “Talk”
button on the phone adapter or the button on the multi-func-
tion wheel.Talk button
The voice control system may be activated using the buttons “Talk” on the
phone adapter Ÿfig. 1 and on the multi-function steering wheel Ÿfig. 2 .
If one of these buttons is pressed while using the speech control system, the
function is cancelled.
After pushing the “Talk” button, wait some seconds for the sound signal
after which the vocal commands may be used. These commands may be used
to manage the functions of the hands-free telephone system as well as the
phone book.
Phone book
The speech control system offers the option of creating and using an phone
book belonging to the vehicle system and independent of the mobile tele-
phone. This phone book may contain 50 entries.
Also, in the moment that a connection is made between the telephone and
the hands-free system (if a compatible adapter or Bluetooth adapter is avail-
able), the numbers stored in the telephone SIM card are downloaded by the
hands-free system and can be displayed on the vehicle instrument panel.
These numbers may be selected using the multi-function lever, allowing calls
to be made by this or by the multi-function wheel.
WARNING
•Please concentrate on driving. As the driver, you have the responsibility
for your safety and that of others. For this reason, you should only use the
functions in a manner that allows you to maintain control of the vehicle in
all situations - otherwise you may create an accident risk!
•The speech system must not be used in cases of emergency, since the
voice changes in stressful situations. This could result in a failed or delayed
telephone connection. Always dial emergency numbers manually!
Fig. 1 Talk button on the
mobile phone adapter
Fig. 2 Talk button on the
multi-function steering
wheel

Communication
12
Dialogue
The speech control system can be activated via the “Talk”
button on the phone adapter or the button on the multi-func-
tion wheel.
In this manual, Dialogue is defined as the time in which the speech control
system may receive vocal commands and provide assistance for completion
of different functions in case the user is hesitant and unsure how to proceed.
The system also responds by vocal messages. The dialogue is activated and
deactivated by pressing the “talk button” .
If a call is received then the dialogue is interrupted immediately. The call may
be accepted by pressing the key “answer” on the multi -function steering
wheel.
Assistance from the system
If a command is not recognised by the system, it will answer with the cue
and the command can then be given once again clearly. After a
third failure the system will answer with and the dialogue will be
ended. Note the following to ensure that you are properly understood:
•Speak in a normal tone and without pauses or exaggerated pronuncia-
tion.
•Avoid poor articulation of words.
•Keep the doors, windows and sun roof closed if possible to avoid back-
ground noises that might affect the system.
•Keep the air vents directed away from the microphone (located on the
interior light).
•At high speeds, you might need to speak louder to drown out background
noises.
•Avoid other noises in the vehicle during a dialogue (e.g. other passengers
speaking in the vehicle).
•Avoid speaking when the system is saying a cue.
•The hands-free microphone is directed towards the driver, therefore, only
the driver should try to operate the system.
•To make a call when there is heavy background noise we recommend
using the speech controlled telephone book instead of speaking individual
digits. This will help avoid mistakes when specifying telephone numbers.
Controlling the hands-free unit by voice
The hands-free functions are also operated via voice commands.
Help commands
The system confirms acceptance of speech commands verbally and guides
you through the dialogue if necessary.


Speech commandEffect
HELPFollowing this command the system announces possible orders

Communication15
Example for entering a PIN code
A running dialogue can be cancelled at any time with a press of the talk
button .
Note
•If the PIN code is more than 8 digits long, the system will decline and give
the cue .
•If the specified PIN code is incorrect, the system will decline and give the
cue .
•If the wrong PIN code is entered three times, the SIM card will be blocked.
The SIM card can be unblocked with the PUK (personal unblock key). The
personal unblock key (PUK) can only be entered via the phone keypad and
not via the speech control system .
Speech commandConditionSystem cueEffect
ENTER PIN CODEThe SIM card is installed, the tele-
phone is on and fitted to the adapter.Dialogue
for example, ZERO, ONE, TWO, THREEDialogue
If no command is specified, the system responds after about 5 seconds with the next cue.
No command back, delete, or specify additional
digits>Dialogue
STOREDialogue
End of dialogue

Communication
16
Dial number
A telephone number can be vocally specified to the system and then dialled.
– Press the talk button . Activation of the system is confirmed
with by a tone.
– After the tone, say the command DIAL NUMBER.
After this command the system will then request that you specify a telephone
number. A connection will then be established to the specified number. The
telephone number can be specified all at once, in blocks of digits (separated
by a brief pause), or as single digits. You can specify the digits from zero to nine
. After each block of digits you specify (separated by a brief pause) the
system will repeat the digits. The system can only recognise single digits
(two, three, etc.), and not combinations of digits (e.g. twenty-three).
Notes on specifying telephone numbers:•If the telephone number has more than 20 digits, the system will decline
and give the cue .
•A Plus (+) can also be placed ahead of the 20 digits.
Example for entering a telephone number:
A running dialogue can be cancelled at any time with a press of the talk
button .
.
Speech commandConditionSystem cueEffect
DIAL NUMBERPhone switched onDialogue
for example, ZERO, SEVEN, THREE,
ONEDialogue
If no command is specified, the system responds after about 5 seconds with the next cue.
No command correct or specify additional digits>Dialogue
THREE, NINE, TWODialogue
DIALDialogue -The telephone number
0731492 will be dialled
End of dialogue

Communication
18
A running dialogue can be cancelled at any time with a press of the talk
button .
Note
•If the telephone number has more than 20 digits, the system will decline
and give the cue .
•A Plus (+) can also be placed ahead of the 20 digits.
•Say the command Delete or Back to delete or correct the corresponding
block of digits.
•Say Repeat to have all the digits that have been recognised up to that
point repeated.
•If two or more names sound alike, it is better to save the names including
the first name or some other distinguishing entry.
•A running dialogue can be cancelled at any time with a press of the talk
button .
•The telephone book works only in conjunction with the hands-free speech
control system; the entries are not stored on the phone's SIM card.
COMPANY XYZDialogue
ZERO, ONE, TWO, THREEDialogue
FOUR, FIVE, SIXDialogue
If no command is specified, the system responds after about 5 seconds with the next cue.
No command back, delete, or specify additional
digits>Dialogue
STOREDialogue - The name COMPANY XYZ
with the telephone number 0123456
will be stored
End of dialogue

Communication19
Calling a name in the phone book
– Press the talk button
– After the tone, say the command SELECT NAMEAfter the system has recognised this command, you may select a stored entry
from the telephone book to call the required number. The system best recog-
nises names spoken by the person who stored the name.
Example for selecting a name from the internal telephone book
A running dialogue can be cancelled at any time with a press of the talk
button ..
Speech commandConditionSystem cueEffect
SELECT NAMEPhone is switched on, telephone book
contains entries.Dialogue
COMPANY XYZDialogue
If no command is specified, the system responds after about 5 seconds with the next cue.
No command back>Dialogue
DIALDialogue - The telephone number for
Company XYZ is being dialled
End of dialogue

Communication21
Example for deleting single names from the internal telephone book:
A running dialogue can be cancelled at any time with a press of the talk
button .
Note
•Say the command Repeat, if you would like to have the specified name
repeated by the system.
•If you then say No, the system will answer with and the dialogue
will be ended.
To erase the phone book
You can delete the entire phone book or single entries.
– Press the talk button .
– After the tone, say the command DELETE PHONE BOOK.
After giving this command you can delete the entire internal phone book or
single entries as desired.
Speech commandConditionSystem cueEffect
DELETE NAMEThe telephone book contains entries.Dialogue
COMPANY XYZ pany XYZ?>Dialogue
If no command is specified, the system responds after about 5 seconds with the next cue.Dialogue
No command back>Dialogue
YESDialogue
End of dialogue

.

Communication
22
Example for deleting the entire internal telephone book:
Example for deleting single names from the internal telephone book:
Speech commandConditionSystem cueEffect
DELETE PHONE BOOKThe telephone book contains entries. phone book?>Dialogue
If no command is specified, the system responds after about 5 seconds with the next cue.Dialogue
No commandDialogue
YESDialogue
If no command is specified, the system responds after about 5 seconds with the next cue.Dialogue
No commandDialogue
YESAll entries in the phone book will be
deleted.
End of dialogue
Speech commandConditionSystem cueEffect
DELETE PHONE BOOKThe telephone book contains entries. phone book?>Dialogue
If no command is specified, the system responds after about 5 seconds with the next cue.Dialogue
No commandDialogue
NOThe telephone book will then be read
out.
No commandTalk button pressed as the entry to
be deleted is read out. (name)?>Dialogue
If no command is specified, the system responds after about 5 seconds with the next cue.Dialogue