check oil Seat Toledo 2006 Maintenance programme

SEAT maintenance program
8SEAT maintenance programUsing these instructionsThis programme will indicate the work that should be pe riodically carried out
on your vehicle in order to maintain the safety, reliability and lifetime condi-
tions required.
Using the “vehicle identification” data or the data in this document, the
correct spare parts for your vehicle will be specified in ca se of repairs; even
many years following the initial purchase.
We recommend that you keep this maintenance programme with the vehicle
documents. The Proof of service is one of the fundamental r equirements for
warranty rights.
The maintenance programme shows the date of delive ry and this indicates
the beginning of the vehicle guarantee.Maintenance ProgramThe SEAT maintenance programme is composed of di fferent inspection serv-
ices carried out according to the time since the vehi cle purchase or the
mileage.
Each Inspection Service as well as an y required additional operation already
has a pre-established work time. This will allow you to know the total cost of
the service beforehand.
. The SEAT Service Centre network is equipped with modern technology and
well-trained specialists. Many SEAT Service Centres offer different value
service packages
Adverse weather conditionsThe Service Centre “service consultant” will inform you of any necessary addi-
tional work within the intervals defined by the Inspection Ser vice depending
on the conditions and the environment in which the vehicle is used. For
example, for an oil change where the vehicle is use d only for frequent short
journeys or is subject to extreme temperatures. Likewis e, when the vehicle is
used in dusty conditions the air, dust and pollen filter cartridges must be
changed more often and the timing belt checked.Diesel fuelThe Service Centre “service consultant” can provide inf ormation about which
countries use fuel with a high sulphur content. In th ese cases, the oil must be
changed every 7,500 km.
Caution
•
Vehicles with the label “UNSUITABLE FOR BIODIESEL” on th e fuel cover
cannot be driven using biodiesel.
•
To be certain if your vehicle can be used with biodiesel according to the
DIN EN 14214 (FAME) standard consult your Serv ice Centre.
•
DIN is a German abbreviation for “Deutsches Institut für Normug e.V.”, the
German standards institute.
•
EN means European Norm.
•
FAME is the English abbreviation “F atty Acid Methyl Ester”
PM_ALTOLE_ingles Seite 8 Donnerstag, 4. Mai 200 6 4:59 16

Inspection Service general programme11
There may be different specific “additional work” dependin g on the vehicle
use or the time since the first delivery date. For example:•
Distribution belt change (depending on the mileage).
•
Brake fluid change (every 2 years).
Inspection Service every 15,000 km or once a yearOperations to be completed on your vehicle•
Label “Next Service”: Note the date, mileage and atta ch it to the door
frame.
•
Engine oil and oil filter: Replacement.
•
Front and rear brake pads: Inspection.
•
Service interval indicator on the instrument panel: Re set.
•
Tyres, including the spare wheel: Check the profile, tread wear indicator
and pressure.
•
Interior and glove compartment lighti ng, lighter/socket, warning lights
and horn: Check operation.
•
Front/rear boot lights, indicators and hazard lights: Check operation.
•
Windscreen and headlights washer system: Check oper ation and for
possible damage, top up.
•
Exhaust gases installation: Verify attachments and ch eck for leaks and
damage.
Inspection Service every 30,000 km or every 2 yearsOperations to be completed on your vehicle:•
Label “Next Service”: Note the date, mileage and atta ch it to the door
frame.
•
Engine oil and oil filter: Replacement.
•
Front and rear brake pads: Inspection.
•
Service interval indicator on the instrument panel: Res et.
•
Tyres, including the spare wheel: Check the profile, tread wear indicator
and pressure.
•
Interior and glove compartment lighti ng, lighter/socket, warning lights
and horn: Check operation.
•
Front/rear boot lights, indicators and hazard lights: Che ck operation.
•
Windscreen and headlights washer system: Check operation and for
possible damage, top up.
•
Exhaust gases installation: Verify attachments and ch eck for leaks and
damage.
•
Battery: Inspection.
•
Self-diagnosis: Check fault memory in all systems.
•
Poly-V belt: Check condition.
PM_ALTOLE_ingles Seite 11 Donnerstag, 4. Mai 20 06 4:59 16

Inspection Service general programme
12Inspection Service every 60,000 km or every 4 yearsOperations to be completed on your vehicle:•
Exhaust gases installation: Verify attachments and ch eck for leaks and
damage.
•
Steering ball joints: Verify attachments and check for le aks and damage.
Check for play.
•
Label “Next Service”: Note the date, mileage and atta ch it to the door
frame.
•
Automatic gearbox (differential): Chec k the oil level, top-up if necessary.
•
Automatic gearbox (Gearbox): Check the ATF level.
•
Manual gearbox: Check the oil level (for cases of permeability issues).
•
Battery: Inspection.
•
Brake system: Check for leaks and damage.
•
Front and rear brake pads: Inspection.
•
Brake fluid level, according to brake pad wear: Inspecti on.
•
Self-diagnosis: Check fault memory in all systems.
•
Front/rear boot lights, indicators and hazard lights: Chec k operation.
•
Poly-V belt: Check condition.
•
Poly-V belt: Check tension (only engines without automatic tension
device).
•
Cooling system: Check the coolant level and the anti-fr eeze protection.
•
Engine and engine compartment components: Check for leaks and
damage (from above).
•
Engine and engine compartment comp onents, gearbox and steering ball
joints: Check for leaks and damage (from bellow) .
•
Engine oil and oil filter: Replacement.
•
Test drive: Check brake operation, handbrake, gearbo x operation,
steering system operation, kick-down (for automatic gearbox), air condi-
tioning and sliding roof.
•
Interior and glove compartment ligh ting, lighter/socket, warning lights
and horn: Check operation.
•
Tyres, including the spare wheel: Check the profile, tre ad wear indicator
and pressure.
•
Headlights: Check adjustment.
•
Windscreen and headlights washer system: Check op eration and for
possible damage, top up.
•
Sun roof: Check operation, clean drains and grease gu ides.
•
Service interval indicator on the instrument panel: Reset.
•
Door and tailgate hinges: Lubricate.
•
Undercarriage protection: Visual damage inspection.
Additional workIn addition to the Inspection Service, additional main tenance jobs may have
to be carried out, depending on the conditions in which y our vehicle is used
and depending on the equipment level of your vehicle. T his additional work
should be carried out in accordance with time/dista nce travelled to ensure
your vehicle remains reliable. Your Service Centre will pro vide detailed infor-
mation about the additional work that may be necessary. These can be done
independently of the obligatory services, taking in to account the notes in the
PM_ALTOLE_ingles Seite 12 Donnerstag, 4. Mai 20 06 4:59 16

Inspection Service general programme13
Maintenance Programme (or the label: Next service). Your SEAT Service
Centre will be happy to advise you and quote the prices f or this additional
work. Additional jobs completed are marked on the wo rkshop sheet with the
receipt.Every 7,500 km•
Engine oil and oil filter: Replacemen t (engines using high sulphur content
diesel).
•
Fuel filter: Replacement (only TDI engines using high sulphur content
diesel).
Every 30,000 km•
Fuel filter: Replacement (only diesel engines using biodie sel, or using fuel
that does not comply to the DIN EN 590 standard)
Every 60,000 km•
Air filter: Clean the housing and replace the filter element (only diesel
engine 125 kW).
•
DSG gear: Replace the oil and filter.
•
Dust and pollen filter for the passenger compartment: Replacement.
•
Spark plugs: Replacement (except for the 2.0 TFSI engine).
Every 90,000 km•
Air filter: Clean the housing and replace the filter element (only di esel
engine 125 kW).
•
Fuel filter: Replacement (only diesel engines using fuel c onforming to the
DIN EN 590 standard)
•
Spark plugs: Replacement (2.0 litre TFSI engine).
After 90,000 km (the fi rst time around) then, every 30,000 km•
Camshaft timing belt: Check condition and replace if nec essary (petrol
engines only).
Every 120,000 km•
Particle filter: Verify (only 125 kW diesel engine)
•
Camshaft timing belt: Replacement (only diesel engine s with injector
pump).
Every 150,000 km•
Particle filter: Verify (except 125 kW diesel engine)
PM_ALTOLE_ingles Seite 13 Donnerstag, 4. Mai 20 06 4:59 16