wheel Seat Toledo 2012 BLUETOOTH SYSTEM

4Introduction to the Bluetooth systemIntroduction to the Bluetooth systemGeneral information
This system allows you to connect your mobile phone via
Bluetooth connection and to use the hands-free mode.
The hands-free device means that the telephone can be used inside the ve-hicle; the driver will not have to remove their hands from the steering wheelnor will be distracted from traffic.
Available functions include making calls in hands-free mode, access to themobile phone address book, access to the call list and control of the voicerecognition system.
Before using the Bluetooth system, the mobile phone should be connectedto the vehicle installation via Bluetooth ⇒ page 7.
Switching on/off
The Bluetooth system is activated when the ignition is turned on and it isdeactivated when the key is removed from the ignition.
With the system activated, if the “PTT” is pressed the voice control activatesand if there is no telephone connected, Bluetooth visible is turned on and asearch for a telephone is begun.
If there is a call in process when the system is deactivated, the active call isnot cancelled, but transferred to the mobile phone.
Bluetooth
Bluetooth technology permits the connection of a mobile phone to the vehi-cle hands free system. In order to use the system with a mobile phone withBluetooth technology, the process of pairing them must be performed in ad-vance.
Use compatible Bluetooth devices only. For more information about compat-ible Bluetooth products, consult your dealership or the SEAT website.
Some Bluetooth mobile phones are detected and connected automaticallywhen the ignition is switched on. For this to take place the telephone mustbe switched on and its Bluetooth function activated, and there must be noactive Bluetooth connection from other devices.
Bluetooth connections are free.
Bluetooth® is a registered trademark of Bluetooth® SIG, Inc.
Declaration of conformity
S1nn GmbH & Co. KG certifies that the UHV High unit complies with the ba-sic requirements and the rest of the relevant provisions of the Directive1999/5/CE. A copy of the declaration of conformity can be found at http://www.s1nn.de/certifications/uhv-high-manual .
Exchange of information between the mobile phone and the Bluetoothsystem
The mobile phone system sends the data and the requests via Bluetooth tothe mobile phone that is connected. If the connected mobile phone is tem-porarily “overloaded”, it may not respond to the requests from the Blue-tooth system. The following message is shown in the instrument panel dis-play: “Mobile phone does not respond”.
In this case, wait for the mobile phone to react or make a new call.

9OperationOperationOperation via controls
Multifunction control
The mobile phone system can be controlled from the multi-
function control or by using the voice control system.
Fig. 2
Multifunction con-trol buttons.
Controls on the multifunction control
ButtonFunction“Push to talk button” or “PTT” button.Short press: start or cancel the speech control system, interruptmessage in process in order to talk promptly, turn on Bluetoothvisible for 3 minutes.
 /Short press: adjust volume of telephone function.Short press: Answer, Start, End a call.Long press: Decline an incoming call, transfer active call to pri-vate mode.

Operation via voice control
Introduction
The voice control system can be activated with the “Push to
talk” or “PTT” button .
Thanks to the voice control you can use many telephone functions withouthaving to take your eyes off the road or your hands off the steering wheel.
Dialogue is the time during which the voice control system transmits mes-sages and can receive spoken orders (commands).
If a call is received, then the dialogue is immediately interrupted.
You can use the HELP in any part of the menu. If you have any doubts orcannot decide the Command to use, the system will provide you with theavailable options.
You can CANCEL in any part of the menu.


10OperationBasic functions available with the voice controls
Volume adjustment
You can change the sound volume at any time with the radio button or withthe buttons on the multifunction control.
The volume transmitted by the speaker depends, among other aspects, onthe volume transmitted by the mobile. If the volume of the mobile is low, oron silent, it is possible that no sound will be heard through the car speaker.
Adjust the volume of your Bluetooth device to the maximum.
Do not leave headphones connected to the Bluetooth device when you wishto use the hands free system.
Complying with these requirements, if the speaker volume is very high, ad-just it using the controls on the steering wheel or the volume control on theradio.
Voice control connection (Dialogue)
You can start the dialogue at any time by briefly pressing the PTT button on the multifunction control.
If the system does not recognise your command, there is a first help optionwhich allows a new input. After a second failed try the system repeats thesecond part of the help. After a third failure the system will answer with“Operation cancelled” and the dialogue will be ended.
Disconnection of the voice control (Dialogue)
You can end the dialogue at any time by briefly pressing the PTT button on the multifunction control. If the system is waiting for a command, youcan end the dialogue with the “CANCEL” command.
Interruption of the current message
By pressing the PTT button  during the message, only the current mes-sage is ended and it is possible to give another command.

Correct use of the voice control
Note the following to ensure that you are properly understood:
●
Speak in a normal tone and without pauses or exaggerated pronuncia-tion.
●
Avoid poor articulation of words.
●
Keep the doors, windows and sun roof closed if possible to avoid back-ground noises that might affect the system.
●
Keep the air vents directed away from the microphone (located on theinterior light).
●
At high speeds, you might need to speak louder to drown out back-ground noises.
●
Avoid other noises in the vehicle during a dialogue (e.g. other passen-gers speaking in the vehicle).
●
Avoid speaking when the system is saying a cue.
●
The hands-free microphone is directed towards the driver, therefore, on-ly the driver should try to operate the system.
●
To make a call when there is heavy background noise we recommend us-ing the speech controlled telephone book instead of speaking individualdigits. This will help avoid mistakes when specifying telephone numbers.

Voice control orders (commands)
The voice control can be used in the following languages:
Spanish, Mexican Spanish, German, English, US English, French, CanadianFrench, Italian, Portuguese, Czech, Russian and Dutch.
Basic commands valid in any part of the menu
HELPAfter this command the system repeats all the possible com-mandsCANCELThe dialogue ends