parking brake SKODA FABIA 2011 2.G / 5J User Guide

–
Grip the rear light unit and remove it carefully with loosening movements at an
angle to the rear. Do not pull the grommet with the cables out of the body.
– Replace the defective light bulb ⇒ page 191.
– When re-installing, first insert the rear light unit with the screw A into the
opening of the body ⇒ fig. 165 .
– Carefully press the rear light unit into the body in such a way that the pins Bengage into the supports of the body.
– Hold the rear light unit tight with one hand, screw on the nut with the other
hand and tighten it ⇒ 
fig. 165. CAUTION
When removing and installing the rear light unit make sure not to damage the
paintwork of the vehicle and the rear light unit. Note
For slackening and tightening the plastic nut use a coin. 
Changing light bulbs in the rear light unit Fig. 166 Rear light unit: Fitting position
of the bulbs
– To replace a light bulb, turn the bulb connector of the light bulb to the left (in
the direction of the arrows on the housing) and take it out of the housing
⇒ fig. 166 right.
– Replace the light bulb, put the bulb connector back into the housing and turn
it to the right up to the stop (in the opposite direction of the arrows on the
housing).
Fitting position of the light bulbs in the rear light unit ⇒ fig. 1661 - Rear fog light/Reversing light
2 - Turn signal lights
3 - Brake lights
4 - parking lights
 191
Fuses and light bulbs Using the system Safety Driving Tips General Maintenance Breakdown assistance Technical data