transmission SKODA OCTAVIA TOUR 2010 1.G / (1U) Columbus Navigation System Manual

Communication
94
CommunicationMobile phone, handsfree-system*Universal preparation for the phoneOnly one telephone mount is factory-fitted. An adapter for the telephone can be
purchased from the range of the Škoda origin al accessories. The mount is attached to
the centre console.Insert mobile phone– Insert the mobile phone into the adapter (as specified in manufacturer's instructions).Inserting adapter with mobile phone into mount– First insert the adapter with the mobile phone into the mount in the direction
of arrow until the adapter is touching the stop.
– Press the adapter slightly in the directio n of arrow until it locks into position.Initialisation– Withdraw the ignition key.
– Insert the adapter without the mobile phone into the mount . – Plug the adapter cable into
the mobile phone socket. The socket is located on the
mobile phone mount below.
– Switch on the ignition.
– Wait approximately 20 seconds, switch off the ignition and pull the ignition key out
of the ignition lock.
– Insert the mobile phone into the adapter (as specified in manufacturer's instructions) and switch on the ignition.
Removing the mobile phone with the adapter– Press the button and remove the mobile telephone.
An initialisation mu st be carried out:
after the first connection of the adapter;

after reconnecting the battery;

after pulling out the adapter cable from the power socket for the mobile phone.
This enables you to make full use of the advantages of a normal carphone (“handsfree
system” using a microphone integrated in the vehicle, optimal transmission of signals
using an external aerial etc.). The battery of the mobile phone is also constantly
charged.
Should you have any questions, please contact a specialist garage.
Please refer to the following guidelines page 94.
Mobile phones and two-way radio systemsThe installation of a mobile phone and two- way radio system in a vehicle should be
carried out by a specialist garage.
Škoda Auto permits the operation of mobile phones and two-way radio systems with
a professionally installed external aerial and a maximum transmission power of up to
10 watts.
Fig. 105 Universal preparation
for the phone
AA
AB
A1
A2
AB
AA
AC
s2rc.book Page 94 Thursd ay, April 22, 2010 10:58 AM

Communication95
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
It is essential that you inform a specialist garage about the possibilites to assemble and
operate mobile phones and two-way radio sets which have a power output of more
than 10 W. They will inform you which technical possibilities exist for retrofitting
mobile telephones an
d radio transmitters.
Operation of mobile phones or two-way ra dio systems may interfere with functioning
of the electronic systems of your vehicle. The reasons for this may be:

no external aerial,

external aerial incorrectly installed,

transmission power greater than 10 watts.
You should therefore not operate a mobile phone or two-way radio system inside
the vehicle without the use of an external aerial, or with an external aerial which has
been incorrectly installed.
You should also be aware of the fact that only an external aerial makes it possible to
achieve the optimal range of such equipment.
WARNING

If a mobile phone or two-way radio system is operated inside the vehicle
without using an external aerial, or wi th an external aerial which has been
incorrectly installed, the result can be excessive electromagnetic fields which
may cause harm to your health.

Please concentrate fully at all times on your driving.

You must not install two-way radio systems, mobile phones or mounts on
the covers of the airbags or within the immediate deployment range of airbags.
This might result in injuries to the occupants in the event of an accident.Note
Please also refer to the operating instructions of the mobile phones and two-way radio
systems.
s2rc.book Page 95 Thursd ay, April 22, 2010 10:58 AM