ignition SKODA SUPERB 2005 1.G / (B5/3U) DX Navigation System Manual

RADIO NAVIGATION SYSTEM10
INTRODUCTION
Symbol display
During route guidance, you can use either the
symbol display with the directional arrows in-
dicating approaching turns or the map display.
What appears in this display depends on the
display mode used last during active route
guidance.
J
K
LM
NSwitching the system on/off
Press the rotary/pushbutton 00 00
0 to switch the
system on and off.
Note
If the system does not switch on and “SAFE”
appears in the display, please refer to the op-
erating instruction on page 64.
If the key is removed from the ignition when
the system is still switched on, it will switch off
automatically.
If the key has been removed from the igni-
tion , it is possible to switch the system on and
off by pressing the rotary/pushbutton
00 00
0. The
system will operate for approximately one hour
and then switch off automatically. This proc-
ess can be repeated as often as desired.
If the system has been switched off and the
key removed from the ignition, a flashing LED
indicates that the anti-theft coding has been
activated.
The symbol display indicates the number of
GPS satellites currently within reception range
and the status of the traffic congestion func-
tion
II II
I, the estimated time of arrival or the trav-
elling time and distance to your destination KK
KK
K,
the directional arrow LL
LL
L, the distance bar graph
to the next intersection/turn indicating the dis-
tance
MM MM
M and the name of the road you are
currently travelling on NN
NN
N. If a turn is approach-
ing, the directional arrow LL
LL
L will indicate the
direction in which you will be required to turn.
The name of the street you will turn onto will
also appear above the arrow.
You can easily switch from one display mode
to the other at any time. Press the menu knob
to activate the map when you are using the
symbol display mode. To return to the symbol
display mode, press
99 99
9.

RADIO NAVIGATION SYSTEM64
NAVIGATION
Cancelling the electronic block
Enter the correct code to cancel the electronic
block.
Enter this information exactly as described in
the following:
•Switch the system on.
After you see the opening screen with the
·koda logo, you will see the menu for entering
the code with the message: “Please enter your
numerical code.”
•To enter the number code, use the menu
knob to mark and confirm each number on the
number bar one after the other.
The numbers selected will appear in the 4
number fields at the bottom.
•To confirm the code you have entered, use
the menu knob to mark the “OK” menu field
and press the menu knob.
Note
You can also confirm the code by pressing the
menu knob (for longer than 2 seconds).
Now you can once again operate the sys-
tem! Entering an incorrect code number
If you confirm an incorrect code number,
“SAFE” will flash in the number fields and the
display will then show the incorrect code just
entered. The following message will appear
below the number fields “1st code entered is
wrong!”.
Now you can repeat the entire process
once.
If the next code entered is also incorrect,
“SAFE” will appear in the number fields. The
following message will appear below the
number fields: “Unit locked!”. The system will
be blocked for approx. 1 hour, i.e. it will not
be possible to use it. After 1 hour has elapsed
- the system must remain switched on with
the key in the ignition - the message will
disappear from the display and the electronic
block can be removed as described above.
The cycle of two attempts, one hour blocked
will remain in effect.
Note
If you lose the equipment card with the code
number, please contact a ·koda Auto service
centre.