AUX SKODA SUPERB 2009 2.G / (B6/3T) Swing Car Radio Manual
[x] Cancel search | Manufacturer: SKODA, Model Year: 2009, Model line: SUPERB, Model: SKODA SUPERB 2009 2.G / (B6/3T)Pages: 15, PDF Size: 0.7 MB
Page 6 of 15
General information
4Audio settings– Press the button and then the station key and select the desired
parameter.
– Set the desired value by turning the menu control button .You can select between the following parameters:•
BASS
- bass setting;
•
MIDDLE
- midtone setting;
•
TREBLE
- treble setting;
•
BALANCE
- setting of the volume ratio between the left and right side;
•
FA D E R
- setting of the volume ratio between the front and the rear;
•
ON VOL
•
PDC VOL
•
GALA
•
LO U D
- in case of low volume level, this
function reinforces the range of bass
and treble frequencies. ON VOL Your radio stores the last volume set before switching off. If the value is higher, the volume is reduced to the value of the parameter
ON VOL
after switching on the
radio again. GALA Your radio increases automatically its volu
me with the increasing vehicle speed. A
higher setting value results in a stronger volume increase. PDC VOL* If your vehicle is
equipped with “parking aid”,
the volume is automatically
decreased to a pre-defined value, wh
en the “parking aid” is active.
Setting the special functions– Press the menu control button for a long period of time. – Select the individual functions of the menu with the help of the station
keys.
– Set the desired value using the menu control button or with the
help of the station keys.
AUX* Switching on or off the function
s of the external audio source.
Setting of the input sensitivity
AUX LEV
:
•
AUX LEV 1
- high level, used in particular for notebooks;
•
AUX LEV 2
- middle level, used for cassettes or CD player;
•
AUX LEV 3
- low level, used for MP3 player;
PHONE* If your vehicle is
equipped with a ha
ndsfree system, you can switch on or off the
monophone play function of the mobile
phone calls via the loudspeakers of the
vehicle. BEEP Switching on or off the tone signal when storing the radio stations. ILLUM Switch on (value
2) or switch off (value
1) the rear lighting of the control buttons.
AF The function alternative frequency (AF) ensures that the best receivable frequency of the selected station is automatically an
d precisely set. The replay of the broad-
cast can be muted briefly during the search process according to the best receiv-able frequency. If no alternative frequenc
y of the set station can be found and the
station no longer offers a satisfactory qu
ality, then please select another station.
A12
A2
A2
A2
sag.9.book Page 4 Wednesday, March 11, 2009 3:20 PM
Page 9 of 15
CD player
7
CD playerUsing the systemInserting the CD– Press the button , in order to select the audio source:
CD
(internal CD drive),
CDC
(external CD changer),
AUX
(external input)
and
BT-AUDIO
(wireless transfer of MP3 data from the telephone
preinstallation).
– Carefully insert a CD into the CD case until it is automatically
drawn in. The play function begins automatically.
Operating the CD playerSelect track – Briefly press the rocker switch
or during the play function of
the CD or turn the menu control button , in order to select the previous and/or the next title.
– Press the button or longer for
fast replay of the track (reverse
or forward). The play function is continued after releasing the button.
Function SCAN – Briefly press the menu control button , in order to scroll through
the CD. The first 10 seconds of each title are played.
– In order to call up the original replayed title, press the station key
CANCEL
.
– End the automatic finding
by pressing the button
OK
. The already
replayed title remains selected.
– If you wish to select another title, press the button
SKIP
.
End the play function of the CD – In order to end the play function of
the CD and to activate the radio,
press the button .
Ejecting CD – Press the button , the Cd is ejected.
Note
•
If the ejected CD is not removed, it is drawn in again for safety reasons.
•
If the radio is functioning in the TP mode before changing to the CD mode, the
play function of the CD is interrupted duri
ng the traffic reports and the unit switches
over to the radio mode. After the traffic reports have ended, the unit switches back once again to the CD mode.Play function of MP3 dataDisplay of additional information – Press the button , the additional
information for the current title
is displayed on the display.
– You can select the additional information with the station buttons ,
which is displayed on the display.
Selective functions in CD modeDuring the CD play function the followin
g functions are displayed on the display:
RPT Selection of the mode for repeating the title.•
OFF
- Play function in continuous order;
MEDIA
A10
A2
A2
A12
A12A12
RADIOA11INFO
A12
sag.9.book Page 7 Wednesday, March 11, 2009 3:20 PM
Page 11 of 15
CD player
9
Formation of condensation When it is cold and after rain showers, moisture can deposit in the CD drive (condensation). This can effect the CD ju
mp or impair the play function. In such
cases wait until the moisture has dissipated. Notes for the care of the CDs If a CD is soiled, please never clean the CD
in the direction of a circle but rather from
inside to outside with a soft lint-free cloth. In case of severe layers of dir t we recom- mend to clean the CD with a commercially available CD cleaner. Also in this case do not clean the CD in the direction of a circ
le but rather from inside to outside and
then let it dry off. Overheating protection If the temperature in the unit exceeds 85°C, the play function of the CD is ended for safety reasons.
Caution
•
Never use liquids such as gasoline, paint thinner or disk cleaner, otherwise the
surface of the CD could get damaged!•
Never expose the CD to direct sun rays!
•
Please never write or affix the CD!Note
Dirt or damage of a CD can lead to diffic
ulties when “reading” the information. The
difficulty in reading the error depends on th
e dirt or on the severity of the mechan-
ical damage. Severe scratches cause reading errors which can make the CD jump or “ get stuck
”. All CDs must be treated carefully an
d always be stored in a protective
case.
External sources*Input AUX-IN – Activate the AUX-IN input by pressing the button and by
subsequently pressing the function key .
– The input for external audio sources AUX-IN is located under the
armrest of the front seats.
– External audio sources, which are connected to the AUX-IN input,
cannot
be operated via the radio.
Input MDI - Multimedia socket – Activate the MDI input by pressing the button and by subse-
quently pressing the function key .
– The input for the external audio sources MDI is located under the
armrest of the front seats, in th
e storage compartm
ent of the front
passenger side or in a storage compartment of the centre console (according to vehicle model).
– Audio data in MP3, WMA, OGG Vorbis and AAC format from the
external data stickers, connected to the MDI input, can be played via the radio.
Fig. 1 Input MDI
MEDIA
AUX
MEDIA
PD
sag.9.book Page 9 Wednesday, March 11, 2009 3:20 PM
Page 12 of 15
CD player
10
– External audio sources, which ar
e connected to the MDI input,
can
be
operated via the radio
⇒
page 7.
It is possible to play back external audi
o sources via the loudspeakers of the radio
in the vehicle. You can select another audio source on the ra
dio at any time. As long as the external
audio source is not switched off, it re
mains always active in the background.
Please refer to the Owner's manual of th
e respective manufacturer for the opera-
tion of the external audio source. Adjust the play function volume of the external audio source The play function volume of the extern
al audio source can be changed via the
volume control on the radio. Depending on the connected audio source, the output volume on the external audio source can be changed. You can also change the input sensitivity of the external audio source
⇒page 4, in
order for the play function volume of the
external audio source to adapt to other
audio sources or to avoid distortions of the play function volume. Adapter A 3.5 mm jack plug is required to connect external audio sources via the AUX-IN input. If the external audio source does
not have this jack plug, you must use an
adapter. A special adapter is required to connect audio sources via the input MDI.We recommend that you purchase an adapter for connecting the USB devices, the devices with Mini USB output or an iPod, at an authorised Škoda Service Partner. Conditions for proper connection•
Only USB devices with the specification 2.0 can be connected.
•
The version of the file allocation tabl
e FAT (File Allocation Table) of the
connected device must be FAT16 (< 2 GB) or FAT32 (> 2 GB).•
In order to replay from a unit with a hard
disk (HDD) which includes a large data
volume, it can lead to a time delay when reading in the overview of the music data.
•
In order to replay from a unit, which incl
udes a complicated folder structure, it
can lead to a time delay when readin
g in the overview of the music data.
•
The folder structure in the connected unit must not exceed a depth of 8 levels.
One folder must not contain more than 1000°data.•
A USB extension cable or USB distributo
r (HUB) must not be used to connect
the unit.
WARNING
•
On no account place an external au
dio source on the dash panel. You
could make sudden manoeuvres in th
e passenger compartment and injure
the occupants.•
On no account place an external audio source close to the airbags. You
could be thrown back in the passen
ger compartment by the airbags being
deployed and injure the occupants.•
You must not hold the external audio source in the hand or on the knees
while driving. You could make su
dden manoeuvres in the passenger
compartment and injure the occupants.•
Always guide the connection cable of
the external audio source in such a
way that is does not restrict you when driving.
Caution
The AUX-IN input must only be used for audio sources!
Note
•
The external audio source, which is conne
cted via AUX-IN, can only be used if
no unit is connected via MDI at the same time.•
If an external audio source is connecte
d via AUX-IN, which is equipped with an
adapter for external power supply, it can o
ccur that the audio signal is interrupted.
This depends on the quality of the adapter which is used.•
The loudspeakers in the vehicle are matc
hed to a power output of the radio of
4x20 W.
sag.9.book Page 10 Wednesd
ay, March 11, 2009 3:20 PM