glove box SKODA YETI 2009 1.G / 5L Owner's Manual

Towing a trailer
192
Detachable towing device*The detachable ball head of the towing device is stowed in a box for the car tool kit in the luggage compartment. An instruction for correct installation and remo
val of the ball head of the towing device
is supplied with the ball head. Inspect the ball head to ensure that it is prop
erly locked each time before setting off.
The inspection is performed by turning th
e closed locking lever downwards. If the
locking lever can only be turned around a small angle (approx. 5°), the locking mecha- nism is O.K. After the inspection pull the locking lever back again to its stop. The towing device must not be used, if it does not wish to
close or if it can be turned freely in the
closed position.
WARNING
Do not use any aids or tools for installing or removing the ball head. This might result in damage to the locking mechanism to the extent that the safety of the towing device is no longer assured - risk of an accident.
Note
•
Do not carry out any modifications or re
pairs to the ball head or to any other
components on the towing device.•
Contact a specialist garage if you en
counter any problems
using the device.
•
Never unlock the ball head with a trailer coupled to it.
•
You should take off the ball head if yo
u drive without towing a trailer. Inspect
whether the end cover properly seals off the mounting shaft.•
Remove the ball head beforehand if you
wish to clean your vehicle using a steam
jet. Ensure that the end cover properly seals the mounting shaft.•
It is recommended to wear gloves when installing and removing.
Fig. 167 Detachable ball head
sgg.6.book Page 192 Thursday, September 24, 2009 2:32 PM