SKODA YETI 2010 1.G / 5L Owner's Manual

Fuses and light bulbs
240
– Remove the rubber protective cap page 238, fig. 188 .
– Unplug plug .
– Take the faulty bulb out of the fixture by turning in direction of arrow and insert a new one in the reverse procedure.
– Insert the protective cap.Rear light unitFig. 194 Removing the rear light uni t / disconnecting the plug connection– Open the boot lid.
– Unscrew the light with the aid of the Torx wrench from the vehicle tool kit. The
shorter side of the wrench is used for loosening the screws and the longer side for
screwing the screws out completely fig. 194 .
– Grasp the light at the top and bottom pa rt and pull it slightly to the rear.
– Disconnect the plug connection by pressi ng the catches in direction of arrow
and by pulling them in direction of arrow fig. 194 .
Changing light bulbs in the rear light unitFig. 195 Remove the middle part of the light / rear light unit: Fitting position of the bulbs– Unscrew the securing screw with the aid of the Torx wrench and press the three
catches in direction of arrow fig. 195 .
– Remove the plastic lamp holder.
– Replace the defective light bulb.
– In order to replace a bulb for the brake light, reversing light, rear fog or turn signal
light, turn the fixture of the bulb to the left up to the stop and take the bulb out of
the housing or pull the bulb for the parking light out of the fixture fig. 195 .
– Change the bulb, install again the fixture with the bulb in the housing and turn it to
the right up to the stop or insert it.
– Insert the plastic lamp holder into the illumination unit until the interlocks are heard to engage and screw in the securing screw with the aid of the Torx wrench
fig. 195 .
– Reconnect the plug connector and insert the bulb in the original position.
– Screw on the bulb fig. 194 - left.
Fitting position of the light bulbs in the rear light unit fig. 195
- Brake lights
- Reversing light
- Rear fog light
- Turn signal lights
AA
A1
A2A1
A2
A3
AA
A1A2A3A4
s2ug.6.book Page 240 Friday, April 9, 2010 2:24 PM

Fuses and light bulbs241
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
- Parking lights
Licence plate light– Unscrew the glass cover of the light
fig. 196 .
– Take the defective bulb out of the holder and insert a new one.
– Replace the glass cover of the lamp and pre ss it down to the stop - ensure that the
glass cover is correctly installed.
– Screw the glass cover tight.A5
Fig. 196 Licence plate light
s2ug.6.book Page 241 Friday, April 9, 2010 2:24 PM

Fuses and light bulbs
242
s2ug.6.book Page 242 Friday, April 9, 2010 2:24 PM

Technical Data243
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
Te c h n i c a l D a t aTechnical DataGeneral informationThe details given in the official vehicle regi stration documents always take precedence
over the details in the Owner's Manual. Please refer to the official vehicle registration
documents or consult a specialist garage concerning the engine with which your
vehicle is equipped.Used abbreviations
PerformancesThe listed performance values were de termined without performance-reducing
equipment, e.g. air conditioning system.WeightThe loading capacity is reduced in line with the range of the special equipment. The
unloaden weight contains a fuel tank topped up to 90%. A driver with a weight of 75
kg is also includ ed in the value.Identification detailsVehicle data sticker
The vehicle data sticker fig. 197 is located on the floor of the luggage compartment
and is also stated in the Service schedule.
The vehicle data sticker co ntains the following data:
Vehicle identification number (VIN)
Vehicle type
Abbreviation
Importance
kW
Kilowatt, measuring unit for the engine output
rpm
Engine revolutions per minute
Nm
Newton meter, measuring unit for the engine torque
CO2 in g/km
discharged quantity of carbon dioxide in grams per driven
kilometer
TSI
Petrol engine with a turbocharger and a direct fuel injection
system
TDI CR
Diesel engine with turbocharger and injection system Com-
mon Rail
M5 / M6
5-speed/6-speed manual gearbox
DQ6/DQ7
6 speed-/7 speed automatic gearbox DSG
DPF
Diesel particle filter
Fig. 197 Vehicle data sticker
A1A2
s2ug.6.book Page 243 Friday, April 9, 2010 2:24 PM

Technical Data
244Gearbox code, paint number, interior eq uipment number, engine output, engine
code
Partial description of the vehicle
7GG, 7MB, 7MG - vehicles with DPF page 170
Vehicle identification number (VIN)
The vehicle identification number - VIN (veh icle body number) is stamped into the
engine compartment on the right hand sh ock absorber dome. This number is also
located on a sign on the lower left hand edge below the windscreen.
Engine number
The engine number is stam ped into the engine block.
Type plate (production plate)
The type plate is located in the lowe r area of the left centre column.
Sticker on inside of fuel filler flap
The stickers are affixed to the inside of the fuel filler flap and contain the following
information:

The prescribed types of fuel,

Ty re s i z e ,

Tyre pressure.
Fuel consumption according to the ECE standards and EU guidelinesDepending on the range of the special equipment, style of driving, traffic situation,
weather influences and vehicl e condition, the consumption values which in practice
result when using the vehicle can deviate from the indicated values.
Urban traffic
The consumption measurement in urban traffic begins with starting of the cold engine.
Afterwards the normal ur ban traffic is simulated. Non-urban traffic
For the consumption measurement in non-ur
ban traffic the vehicle, as in daily
motoring, is accelerated and braked severa l times in all gears. The vehicle speed
changes within the range from 0 to 120 km/h.
Combined traffic
The consumption value in the combined traffic consists of 37% from the value for the
urban traffic and of 63% from th e value for the non-urban traffic.
Note

Please note that the information stated in the official vehicle registration docu-
ments always takes priority.
A3A4A5s2ug.6.book Page 244 Friday, April 9, 2010 2:24 PM

Technical Data245
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
DimensionsDimensions (mm)Other informationAngle (in degree)Length
4223
Width
1793
Width including exterior mirror
1956
Height
1691
Clearance
180
Wheel base
2578
Track gauge front / rear
1541/1537
Front embankment angle
19
Rear embankment angle
26,7
Ramp angle
19,4
Slope angle (°)/
climbing ability (%)
1.2 ltr./77 kW TSI - M6
24/45
1.8 ltr./118 kW TSI - M6 4x4
29/55
2.0 ltr./81 kW TDI CR - M5
29/55
2.0 ltr./81 kW TDI CR - M6 4x4
31/60
2.0 ltr./103 kW TDI CR - M6 4x4
31/60
2.0 ltr./125 kW TDI CR - M6 4x4
31/60
s2ug.6.book Page 245 Friday, April 9, 2010 2:24 PM

Technical Data
246
Engine oil specificationsThe grade of engine oil should be se lected in accordance with precise
specifications.The engine of your vehicle has been factory-filled with a high-grade oil which you can
use throughout the year - except in extreme climatic regions.
You can mix various oils together with each other when refilling with oil. This does not,
however, apply for models with flexible service intervals (QG1).
Engine oils are, of course, undergoing co ntinuous further development. Thus the
information stated in this Owner's Manual is only correct at the time of publication.
Specialist garages are informed by Škoda Auto about current changes. We recommend
having this oil change undertaken by a specialist garage.
The specifications (VW standards) stated in the following must be indicated separately
or together with other specifications on the bottle.
Engine oil specifications for models with flexible service intervals (QG1) Engine oil specifications for vehicles with fixed service intervals (QG2)
If the oils specified above are not available, oils according to ACEA A2 or ACEA A3 can
be used once for refilling. ACEA A3.
If the oils specified above are not available, oils according to ACEA B3 or ACEA B4 can
be used once for refilling.
Caution
Only the above-mentioned oils may be used on vehicles with flexible service intervals
(QG1). We recommend always refilling with oi
l of the same specification since this will
maintain the properties of the oil. In exce ptional cases, you must top up only once
engine oil complying with Specification VW 50 2 00 (only for petrol engines) or Specifi-
cation VW 505 01 (only for diesel engines) to maximum 0.5 litres. You must not use
other engine oils - risk of engine damage!
Note

Before a long drive we recommend that you purchase and carry with you engine
oil which complies with the specification for your vehicle. Consequently, you will
always have the correct engine oil for refilling.

We recommend using a preservative from the Škoda original accessories offered
by your Škoda dealer.

For further information - see Service shedule.
Petrol engines
Specification
Content
a)
a)Oil capacity with oil filter change. Inspect oil leve l when filling; do not fill up too much. The oil
level must be between the markings page 205, “Check engine oil level”.1.2 ltr./77 kW TSI - EU5
VW 504 00
3,6
1.8 ltr./118 (112) kW TSI - EU5 / EU2
VW 504 00
4,6
Diesel engines
Specification
Content
2.0 ltr./81 kW TDI CR DPF - EU5
VW 507 00
4,3
2.0 ltr./103 kW TDI CR DPF - EU5 / EU4
VW 507 00
4,3
2.0 ltr./125 kW TDI CR DPF - EU5
VW 507 00
4,3
Petrol engines
Specification
Content
1.2 ltr./77 kW TSI - EU5
VW 502 00
3,6
1.8 ltr./118 (112) kW TSI - EU5 / EU2
VW 502 00
4,6
Diesel engines
Specification
Content
2.0 ltr./81 kW TDI CR DPF - EU5
VW 507 00
4,3
2.0 ltr./103 kW TDI CR DPF - EU5 / EU4
VW 507 00
4,3
2.0 ltr./125 kW TDI CR DPF - EU5
VW 507 00
4,3
s2ug.6.book Page 246 Friday, April 9, 2010 2:24 PM

Technical Data247
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
1.2 ltr./77 kW TSI - EU5Engine
Performances
Fuel consumption (in ltr./100 km) and CO
2 emission (in g/km)
Power output
kW per rpm
77/5000
Maximum torque
Nm per rpm
175/1550-4100
Number of cylinders/Displacement (cm
3)
4/1197
M6
DQ7
Maximum speed
km/h
175
173
Acceleration 0 - 100 km/h
s
11,8
12,0
M6
DQ7
Urban
7,6
7,8a)/8,0
b)
a)Unloaden weight with special equipment up to 1 505 kg.b)Unloaden weight with special equipment more than 1 505 kg.Non-urban
5,9
5,7a)/5,8
b)
Combination
6,4
6,4a)/6,6
b)
CO2 emission - combination
149
149
a)/154
b)
s2ug.6.book Page 247 Friday, April 9, 2010 2:24 PM

Technical Data
248
Weight (in kg)
M6
DQ7
Permissible gross weight
1885
1915
Unloaden weight ready for work
1340
1370
Loading capacity
620
620
Loading capacity when using the TLC
540
540
Permissible front axle load
1100
1100
Permissible rear axle load
1160
1160
Permissible trailer loads, trailer braked
1200
1200
Permissible trailer loads, trailer unbraked
600
600
s2ug.6.book Page 248 Friday, April 9, 2010 2:24 PM

Technical Data249
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
1.8 ltr./118 (112) kW TSI - EU5, EU2Engine
Performances
Fuel consumption (in ltr./100 km) and CO
2 emission (in g/km)
Power output
kW per rpm
118/4500-6200
Maximum torque
Nm per rpm
250/1500-4500
Number of cylinders/Displacement (cm
3)
4/1798M6 4x4
Maximum speed
km/h
200 (196)
Acceleration 0 - 100 km/h
s
8,4 (8,7)M6 4x4
Urban
10,1
Non-urban
6,9
Combination
8,0
CO2 emission - combination
189
s2ug.6.book Page 249 Friday, April 9, 2010 2:24 PM