hood open SSANGYONG KORANDO 2013 Service Manual

2. INPUT SIGNALS
NO Input signal Logic
1 IGN1 ON = Battery voltage (IGN ON or START)
2 IGN2 ON = Battery voltage (IGN ON)
3 Alternator ON = Battery voltage (engine running)
4 Key reminder switch IN = Battery voltage (key inserted)
5 Driver door LOCK detecting switch LOCK = GND, UNLOCK = OPEN
6 Driver door UNLOCK detecting switch LOCK = OPEN, UNLOCK = GND
7 Passenger door LOCK detecting switch LOCK = GND, UNLOCK = OPEN
8 Passenger door UNLOCK detecting
switchLOCK = OPEN, UNLOCK = GND
9 Rear door LOCK detecting switch LOCK = OPEN, UNLOCK = GND
10 Puddle lamp ON = (-) OUTPUT
11 Driver door open switch OPEN = GND, CLOSE = OPEN
12 Passenger door open switch OPEN = GND, CLOSE = OPEN
13 Rear LH door open switch OPEN = GND, CLOSE = OPEN
14 Rear RH door open switch OPEN = GND, CLOSE = OPEN
15 Tailgate switch OPEN = GND, CLOSE = OPEN
16 Hood switch OPEN = GND, CLOSE = OPEN
17 Sunroof switch OPEN = GND, CLOSE = OPEN
18 headlamp switch ON = GND, OFF = OPEN
19 Folding/unfolding switch ON = GND, OFF = OPEN
20 Crash door LOCK/UNLOCK switch ON = GND, OFF = OPEN
21 Crash sensor (air bag) ON = 200 ms Low signal, OFF = OPEN
22 Front defogger (heated wire) switch ON = GND, OFF = OPEN
23 Rear defogger (heated wire) switch ON = GND, OFF = OPEN
24 Wiper switch 1 ON = GND, OFF = OPEN
25 Wiper switch 2 ON = GND, OFF = OPEN
26 Driver seat belt switch Unbuckled = GND, Fastened = OPEN
27 Passenger seat belt switch (only EU) Unbuckled = GND, Fastened = OPEN
28 Rain & AUTO light sensor LIN communication

All doors LOCK prevention function
When the LOCK signal is input with the doors (driver/passenger/rear) open and the ignition key
removed or IGN ON).
The UNLOCK signal is output for 0.5 seconds (T1) immediately after the LOCK signal output. A.
B. Operation 1.
All doors are closed during the UNLOCK output.
The UNLOCK output continues. C.
D. Operation 2.
When the ignition key is inserted, the ignition key reminder is operated. E. Operation 3.Except tailgate and hood -
Operating process
This function does not work if the vehicle speed is over 10 km/h.

8710-01
REKES key switch description
Door LOCK (locks the doors and tailgate when pressed briefly) 1.
All doors and the tailgate are locked and the theft deterrent mode is activated.
When the theft deterrent mode is activated, the hazard warning lamp flashes twice. When this
button is pressed once more within 4 seconds, the hazard warning lamp flashes twice and the
buzzer sounds once. -
-
Panic (Press and hold for 2 seconds or more) 3.
If this button is pressed for 2 seconds or more, the hazard warning lamp flashes while the buzzer
sounds for approx. 30 seconds.
If the door LOCK button or panic button is pressed, this function is deactivated. -
- Door UNLOCK (unlocks the doors and tailgate when pressed briefly) 2.
If this button is pressed briefly, all doors and the tailgate are unlocked and the theft deterrent
mode is deactivated.
When the theft deterrent mode is deactivated, the hazard warning lamp flashes once.
In theft deterrent mode, if a door, tailgate or engine hood is not opened within 30 seconds after
the door is unlocked by a remote controller, the doors are locked with the hazard warning lamp
and buzzer activated (lamp flashes twice and buzzer sounds once, the theft deterrent mode is
activated again). -
-
-
13. REMOTE KEYLESS ENTRY SYSTEM (REKES)
REKES key (Transmitter)
When the user operates the switch of the REKES key, the vehicle control message formatted by the
remote controller CPU is sent to the main part via radio transmission. The CPU of the main part controls
the vehicle and the main part controls the vehicle operations.
Door LOCK
Door UNLOCK
Panic
The escort function is activated with the headlamp ON for 20 seconds when the door LOCK button
is pressed for 0.5 seconds or more in the theft deterrent mode. If the door LOCK button is pressed
briefly or the ignition is turned ON during the escort operation, the escort is deactivated.

Theft deterrent mode entering by REKES key (for vehicles without SKM)
All doors (including hood and tailgate) are closed with the ignition key removed.
REKES LOCK signal is received.
The door LOCK relay is activated.
All doors (including hood and tailgate) are locked
The system enters the theft deterrent mode after operating the hazard warning lamp twice. A.
B.
C.
D.
E. Operation 1.
REKES LOCK signal is received again within 4 seconds of theft deterrent mode activation.
The hazard warning lamp flashes twice and the warning horn is operated once in the theft deterrent
mode. F.
G. Operation 2.
REKES LOCK signal is received with one or more doors open.
The LOCK relay is activated followed by activation of UNLOCK relay. H.
I. Operation 3.
REKES LOCK signal is received with the tailgate and hood open.
Only the LOCK relays of the closed doors except hood and tailgate are activated.
The system does not enter theft deterrent mode.
If the open tailgate and hood are closed.
The system enters the theft deterrent mode after operating the hazard warning lamp twice. J.
K.
L.
M.
N. Operation 4.
All doors are opened or the ignition key is not inserted within 30 seconds (T5) after the REKES
UNLOCK signal is received.
The LOCK relay is activated and the system enters the theft deterrent mode after operating the
hazard warning lamp twice. O.
P. Operation 5.
17. THEFT DETTERENT FUNCTION
The theft deterrent mode will not be activated when the door is locked by the door key. -

8710-01
Theft deterrent mode deactivation conditions (for vehicles without SKM)
The REKES UNLOCK signal is input with IGN ON.
When the REKES UNLOCK signal is input in the theft deterrent mode or with the theft deterrent mode
deactivated, the hazard warning lamp is operated once and the theft deterrent mode is deactivated
(without warning horn output). -
-
Theft deterrent mode (for vehicles without SKM)
Battery power
Front/rear door open
Tailgate open
4 doors LOCK/UNLOCK
Hood open -
-
-
-
- The BCM monitors the following conditions continuously in theft deterrent mode.
Theft deterrent alarm activation (for vehicles without SKM)
Any door including hood and tailgate is opened in theft deterrent mode.
The LOCK switch of any door including tailgate is set to UNLOCK in theft deterrent mode.
Any door except tailgate and hood is closed and then opened after 30 seconds of alarming.
The hazard warning lamp and warning horn are activated for 30 seconds at intervals of 0.5 sec.
ON/0.5 sec. OFF. -
-
-
-
Theft deterrent alarm deactivation conditions (for vehicles without SKM)
Any signal from the REKES (LOCK, UNLOCK, Panic, Escort) deactivates the theft deterrent
alarm.
The theft deterrent alarm remain on for up to 30 seconds.
When the theft deterrent alarm is activated in theft deterrent mode, turning the ignition ON
immediately deactivates the mode. The alarm is deactivated 30 seconds (time remaining) after that.
(For vehicles with immobilizer system, the alarm is deactivated once the key is verified after the
ignition is turned ON) -
-
-

Theft deterrent mode entering by smart key (for vehicles with SKM)
The ignition is turned OFF or ACC is turned ON with all doors (including hood and tailgate)
closed.
The door LOCK signal is received through B-CAN.
The door LOCK relay is activated.
(If ACC ON, the relay is activated after the power is turned OFF.)
All doors (including hood and tailgate) are locked
The system enters the theft deterrent mode after operating the hazard warning lamp twice and
external buzzer (SKM buzzer) once. A.
B.
C.
D.
E. Operation 1.
The door LOCK signal is received through B-CAN when one or more doors are open with driver
door unlocked.
The LOCK relay is activated followed by activation of UNLOCK relay.
The hazard warning lamp and external buzzer (SKM buzzer) are not operated and the system does
not enter the theft deterrent mode. F.
G.
H. Operation 2.
The tailgate and hood are open.
The door LOCK signal is received through B-CAN.
If all doors (including hood and tailgate) are closed, door LOCK relay is activated.
The system does not enter theft deterrent mode.
If the open tailgate and hood are closed.
The system enters the theft deterrent mode after operating the hazard warning lamp twice and
external buzzer (SKM buzzer) once. I.
J.
K.
L.
M.
N. Operation 3.
The door UNLOCK signal is received through B-CAN.
All doors (including hood and tailgate) are not opened or the ignition is not turned ON within 30
seconds (T5).
The door LOCK relay is activated.
The system enters the theft deterrent mode again after operating the hazard warning lamp twice and
external buzzer (SKM buzzer) once. O.
P.
Q.
R. Operation 4.
The procedure of entering theft deterrent mode by door handle switch LOCK is the same with the
operation 3.
Ex) The theft deterrent mode will not be activated when the door is locked by the door key.

Operating process
- IGN OFF/ACC ON
- All doors (including hood and tailgate) closed
Theft deterrent mode deactivation conditions (for vehicles with SKM)
When UNLOCK signal by the smart key with IGN OFF or by the door handle switch with the door
locked is received, the door UNLOCK signal is output and the theft deterrent mode is deactivated
after the hazard warning lamp (once) and external buzzer (SKM buzzer) (twice) operations.
If UNLOCK signal by the smart key is received after the deactivation of theft deterrent mode, the
hazard warning lamp relay and external buzzer (SKM buzzer) are turned ON.
When the tailgate open signal by the smart key or tailgate open switch is received, only the theft
deterrent for tailgate is deactivated.
The theft deterrent mode is deactivated when the ignition is turned ON. -
-
-
-

8710-01
Theft deterrent mode (for vehicles with SKM)
Battery power
Front/rear door open
Tailgate open
4 doors LOCK/UNLOCK
Hood open -
-
-
-
- The BCM monitors the following conditions continuously in theft deterrent mode.
Theft deterrent alarm activation (for vehicles with SKM)
Any door including hood and tailgate is opened in theft deterrent mode.
The LOCK switch of any door including tailgate is set to UNLOCK in theft deterrent mode.
Any door including tailgate and hood is closed and then opened after 30 seconds of alarming.
The hazard warning lamp and warning horn are activated for 30 seconds at intervals of 0.5 sec.
ON/0.5 sec. OFF. -
-
-
-
Theft deterrent alarm deactivation conditions (for vehicles with SKM)
The theft deterrent alarm is deactivated in the following conditions. The theft deterrent mode is kept
ON.
a. Door LOCK/UNLOCK signal by smart key is received.
b. Tailgate open signal by smart key is received.
c. UNLOCK signal by door switch is received.
d. Tailgate open switch signal is received.
e. IGN ON signal is received.
f. Panic function is activated.
When the ignition is turned ON while the theft deterrent alarm is activated, the alarm is deactivated
immediately.
When the theft deterrent alarm is activated in theft deterrent mode, turning the ignition ON
immediately deactivates the mode. The alarm is deactivated 30 seconds (time remaining) after that.
If no deactivation command is received, the system enter the theft deterrent mode after the 30
seconds. -

-
-
-
Theft deterrent mode re-activation after tailgate open (for vehicles with SKM)
All doors except the tailgate are in theft deterrent mode, the system searches for the smart key inside the
vehicle 1 second after the tailgate is closed. If no smart key is found, the system enters the theft
deterrent mode again.
The hazard warning lamp and warning horn are activated when the system enters the mode.

8010-01
Pin No. Message Operating condition
Domestic Export
Smart key
warningLCD display shows this message for 10 seconds
when the ignition switch or Smart key system is
defective.
This message comes on for approx. 10 seconds if
the low smart key battery is detected when the
ignition switch is pressed or the engine is started.
Door/PASLCD display shows this message when the door,
engine hood or tailgate is open.
Parking aid
systemIf any obstacle is detected in the rear of the vehicle
when the shift lever is moved to "R" position with IGN
ON, each sensor shows its position and distance.
If any error is detected during initial diagnosis, it is
displayed as "?". Other than that is operated in the
same way as the PAS distance measurement mode.
Cruise
controlThis message comes on when the cruise control
system is activated.
This message comes on when the cruise control
system is deactivated.
This message comes on when the cruise switch is
moved to the ECO position.Pin No. Message Operating condition
TailgateIf the tailgate is open, open status messages are
displayed in 4-step graphics.