key SSANGYONG NEW ACTYON SPORTS 2012 User Guide

02-24
▶Ignition Key Reminder
The system outputs "UNLOCK" signal for 5 seconds after the driver's door is opened and
the door lock switch is changed to "LOCK" (while the ignition key is in ignition switch).
The system outputs "UNLOCK" signal for 5 seconds when the door lock switch is changed
to "LOCK" from "UNLOCK" and the driver's door is closed within 0.5 seconds (while the
ignition key is in the ignition switch).
If the "UNLOCK" conditions are met, the system outputs "UNLOCK" signal unconditionally.
However, if the ignition key is removed after the door lock switch is changed from
"UNLOCK" to "LOCK", the system does not output "UNLOCK" signal. -
-
-

02-258710-01
▶All Door Lock Prevention Function when a Door is Open
All doors, except the tailgate and hood, output "UNLOCK" signal for 5 seconds when the
"LOCK" signal is inputted (while the ignition key is removed and one of any doors is open).
When the door is closed during the UNLOCK output for approx. 5 seconds, the UNLOC
K
output stops immediately.
When the ignition key is inserted during the 5 seconds output, the output continues for
approx. 5 seconds.
If the ignition switch is in the "ON" position or the ignition switch is removed, the above
steps are performed. If the key is in the key cylinder, the ignition key reminder function is
activated.
This function does not work if the vehicle speed is over 10 km/h. -
-
-
-
-

02-26
▶Tail Lamp Left On Warning
The chime buzzer sounds with the interval of 0.8 second when opening the driver's door
while the tail lamp is turned on and the ignition key is removed.
The c/buzzer output stops when turning off the tail lamp and closing the driver's door.
The system outputs "UNLOCK" signal for 5 seconds when the driver's and passenger's door
lock switch is locked (while the tail lamp is turned on and the driver's door is open).
This function does not work when the IGN1 switch is in "ON" position. -
-
-
-

02-28
▶Seat Belt Warning
The seat belt warning light comes on and the chime buzzer sounds for 6 seconds when
turning the ignition key to "ON" from "OFF".
If the seat belt is fastened before turning the ignition key to the the "ON" position, the
warning light blinks, however, the chime buzzer does not sound.
The seat belt warning light goes off and the chime buzzer stops when turning the ignition
switch to the "OFF" position during the warning operation.
The chime buzzer stops and the seat belt warning light stays on for the remainig time when
fastening the seat belt.
The seat belt warning light comes on and the chime buzzer sounds for 6 seconds again
when unfastening the seat belt during fastening operation while the ignition key is "ON"
position. 1.
2.
3.
4.
The seat belt warning light blinks and the chime buzzer sounds for 6 seconds when turning the
ignition key to "ON" without fastening the seat belt. After fastening the seat belt, the chime buzzer
stops.
Seat Belt Warning LightChime Buzzer

02-298710-01
▶Parking Brake Warning
The parking brake warning light comes on for approx. 4 seconds when turning the ignition
key from the "OFF" to the "ON" position regardless of the vehicle speed and the parking
brake switch position. After this 4 seconds, the warning light comes on, goes off or blinks
according to the vehicle speed and the parking brake switch position.
The warning light comes on when the parking brake is applied and the vehicle speed is
below 10 km/h.
The warning light goes off when releasing the parking brake under step (2).
The warning light blinks and the chime buzzer sounds for 2.5 seconds and stops for 1.5
seconds when the vehicle speed is over 10 km/h for more than 2 seconds while the
parking brake is applied.
The warning light goes off and the chime buzzer stops when releasing the parking brake
under step (4).
The warning light comes on and the chime buzzer stops when the vehicle speed goes
down below 10 km/h under step (4).
This function does not work when the ignition switch is in "OFF" position. 1.
2.
3.
4.
5.
6.
7.

02-30
▶Center Room Lamp Control
The overhead console lamp (front room lamp) and the center room lamp come on at 100%
when opening the door (driver's/passenger's/rear) while the center room lamp switch is at the
door coupled/tailgate coupled operating position and the key reminder switch is "OFF".
When the door (driver's/passenger's/rear) is opened, the front and center room lamps
come on at 100% and automatically go off after 30 seconds.
The room lamp stays on for 2 seconds and then dims through 3 seconds when closing the
doors within 30 seconds.
The dimming operation must have greater than 32 steps per one second.
The room lamp output should stop immediately after turning on the ignition key during the
dimming operation.
The front room lamp and the center room lamp come on for 30 seconds when receiving
the unlock signal from the remote control key while the doors are closed.
The front room lamp and the center room lamp output period is extended by 30 seconds
when receiving the unlock signal from the remote control key again during output under
step (5). (The lamp stays on when unlocked by the remote control key.)
When a door is opened during its extended period, the lamp stays on. If closed, operates
as in step (2).
The room lamp output stops immediately after receiving the lock signal from door lock
switches while all doors are closed or entering into the anti-theft mode by pushing LOC
K
button on the remote control key. 1.
2.
3.
4.
5.
6.
7.
8.

02-32
▶Ignition Key Hole Illumination
The ignition key hole illumination comes on when opening the driver's door or passenger's
door while the ignition key is removed.
The ignition key hole illumination stays on for 10 seconds when closing the door after step
(1).
The output stops when the ignition key is turned to the "ON" position.
The output stops when receiving the lock signal from the remote control key and entering
armed mode. 1.
2.
3.
4.
▶Key cylinder with key hole illumination
With diesel and gasoline engine With diesel engine With gasoline engine
Without immobilizer
(rechargeable)
→With key hole
illumination With immobilizer
(rechargeable)
→With key hole
illumination With immobilizer
→Without key hole
illumination and
rechargeable function

02-338710-01
▶STICS Circuit for Tail Lamp Auto Cut (Battery Saver)
▶Tail Lamp Auto Cut (Battery Saver)
The tail lamp is turn on or off according to the operations of the tail lamp switch.
The tail lamp relay is turned off (auto cut) when opening and closing the driver's door after
removing the ignition key without turning off the tail lamp.
The tail lamp relay is turned on when inserting the ignition key into the ignition switch.
The tail lamp relay is turned off (auto cut) when opening and closing the driver's door
while the ignition key is removed and the tail lamp is turned on. 1.
2.
3.
4.

02-38
▶Headlamp Control (Escort)
The headlamp control supplies the power to headlamp relay for 20 seconds and turns off
when receiving the escort signal from the remote control key after receiving the lock signal
from the remote control key (armed) with the ignition switch off.
If the escort signal is received again during this time, the operation is extended once for
20 seconds.
However, only when the system is in armed mode when receiving the escort signal from
the remote control key, the power supply and output is turned on.
The headlamp relay output is turned off immediately after receiving the lock signal from
the remote control key during its operation.
However, signals other than lock or escort signal from the remote control key will be
overridden. 1.
2.

02-398710-01
▶Door Lock/Unlock Control by Door Lock Switch
The door lock system outputs "LOCK" signal for 0.5 seconds when positioning the driver's
or passenger's door lock knob to the lock from unlock position.
The door lock system outputs "UNLOCK" signal for 0.5 seconds when positioning the
driver's or passenger's door lock knob to the unlock from lock position.
"LOCK" or "UNLOCK" by the door lock switch is ignored when outputting the "LOCK" or
"UNLOCK" signal by other functions.
All door lock signals are "UNLOCK" for 0.5 seconds just for once when receiving the
"LOCK" signal within 0.5 seconds after closing the driver's or passenger's door while the
ignition key is removed. 1.
2.
3.
4.