Turbo SSANGYONG NEW REXTON 2012 Owner's Guide

D. E-VGT system control
Turbocharger system operates the E-VGT actuator according to the signals for engine epm, accelerator
pedal position, atmospheric pressure, T-MAP, coolant temperature and intake air temperature.
Turbocharger actuator is performed PWM control by ECU.
In general, the boost pressure feedbacks the turbocharger operation and the boost temperature is used
for calculating the precise density.
E-VGT provides higher engine power with faster reaction speed compared to conventional VGT.
Operating wave Vane Control
Low
speed
rangeIn low speed range:
retract the vane to
increase boost
pressure. The vane
has low (-) duty, and
the unison ring
moves to retract the
vane in weak PWM
signal.
High
speed
rangeThe unison ring
moves to extend the
vane in strong PWM
signal. Maximum
pressure is 3 bar and
the system controls it
according to the input
signals.

Engine Compartment Layout
Engine assembly
Engine oil dipstick
Vacuum pump
Oil filter and cooler
Fuel filter and priming pump
Brake booster
Brake oil tank
AQGS unit
Washer fluid filler cap
Engine compartment fuse box
PTC relay box
Battery
Vacuum modulator (for VGT turbo charger) 1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.FFH Assembly (Only for vehicle with FFH)
Power steering oil tank
Engine oil filler cap
Fan shroud
E-EGR Valve
High-capacity PCV oil separator
HFM sensor (6.0)
VGT turbo charger
Air cleaner housing
2Coolant surge tank
ABS/ESP HECU (Including TPMS function:
optional)
Exhaust gas FRT Temp. sensor (T3) 14.
15.
16.
17.
18.
19.
20.
21.
22.
23.
24.
25.

1212-01
1. D27DT ENGINE STRUCTURE
1) Major Components in Engine and Engine Compartment
The advanced electronically controlled D27DT engine that has high pressure fuel system has
been introduced to this vehicle. It satisfies the strict emission regulation and provides improved
output and maximum torque.
1. Coolant reservoir
2. FFH device
3. Brake fluid reservoir
4. Washer fluid reservoir
5. Common rail6. Fuse box
7. Battery
8. Fuel filter
9. Power steering pump
10. Priming pump11. EGR valve
12. Air cleaner assembly
13. Turbo charger
14. Oil dipstick

Left Side View
33. Cylinder head
34. Cylinder block
35. Oil pan
36. Drain plug
37. Turbo charger38. EGR-RH (#3) pipe
39. PCV valve and oil separator
40. Oil dipstick
41. High pressure pump42. Turbo charger booster vacuum
modulator
43. EGR valve vacuum modulator
44. EGR valve
45. Exhaust manifold
Right Side View

1792-01
1. COMPONENTS
The components of the exhaust system for the D27DTP (POWER UP) engine have been changed
as follows:
1. E-EGR valve: Controlling the EGR valve electrically and sends the valve location signal to
ECU (vacuum modulator control has been deleted)
2. EGR cooler: Decreasing EGR gas (NOx) efficiently by cooling the EGR gas and let it flow to
the intake pipe
3. VGT turbocharger: Increase in capacity and performance compared to D27DTP & D20DT
engine
The EGR system has been changed to control NOx more efficiently and the VGT turbo charger
has been changed to increase the engine power. For more details, refer to the next description.
The exhaust system for D27DTP (POWER UP) engine is as follows:

2. CDPF(EURO IV) SYSTEM
The CDPF system is only installed to the D27DT engine, and the major changes comparing to the
previous D27DT engine is as follows:
CDPF (Catalyst & Diesel Particulate Filter) and sensors
Under air cleaner in righ
side of engine
compartment
As the soot is filtered in the CDPF, the pressure between the front side and the rear side of the
filter is different from each other. If the amount of soot is over 28 g, the soot is burnt in the
CDPF. The combustion is determined depending on the pressure difference, temperature of
exhaust gas and EGR ratio. According to these, the soot filtered by post injection of injector is
burnt at
CDPF Exhaust Gas Temperature Sensor
The two temperature
sensors inside the CDPF
are installed in exhaust
manifold (front exhaust
gas temperature sensor)
and in DOC (rear exhaust
gas temperature sensor),
and perform the following
functions.Front Exhaust Gas Temperatur
e
Sensor:Rear Exhaust Gas
Temperature Sensor:
Measures the exhaust gas
temperature of the exhaust manifold.
As it is installed in front of the VGT
turbocharger, it also monitors the
exhaust gas temperature coming to
the turbocharger. If the temperature
of the exhaust gas flowing to the
turbocharger is higher than the
specification, the engine lowers the
exhaust gas temperature.Measures the increased
exhaust gas temperature
after the oxidation process
of DOC. If the temperature
injection amount is
increased to increase the
temperature.
Front exhaust gas
temperature sensor

1725-12
Throttle Body
CDPF system controls the amount of intake air by
controlling the electronic throttle body. The electronic
throttle body has the following main functions.
CDPF control - added a function that increases the
exhaust gas temperature by closing the throttle valve
flap to minimize the intake air amount by the fuel
injection amount during the CDPF regeneration range
with the low engine load range.
ON/OFF control - prevents the engine from turning off
with vibration and noise by closing the throttle body flap
to block the intake air when the engine is stopped.
Duty control - controls the valve inside the throttle body
to burn more EGR gas in the EGR valve operating range.
VGT Turbocharger and Front Exhaust Gas Temperature Sensor
Front exhaust gas
temperature sensorTurbocharger may become weaker if high
temperature exhaust gas passes through the
turbocharger for DPF regeneration process.
The front exhaust gas temperature sensor monitors
the temperature of the exhaust gas that flows into
the turbocharger.
If the temperature of the exhaust gas that passes
through the exhaust manifold is higher than the
specification, the ECU decreases the fuel injection
amount and increases the EGR gas intake amount
to decrease the exhaust gas temperature.

Engine Compartment Layout
Engine assembly
Engine oil dipstick
Vacuum pump
Oil filter and cooler
Fuel filter and priming pump
Brake booster
Brake oil tank
AQGS unit
Washer fluid filler cap
Engine compartment fuse box
PTC relay box
Battery
Vacuum modulator (for VGT turbo charger) 1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.FFH Assembly (Only for vehicle with FFH)
Power steering oil tank
Engine oil filler cap
Fan shroud
E-EGR Valve
High-capacity PCV oil separator
HFM sensor (6.0)
VGT turbo charger
Air cleaner housing
2Coolant surge tank
ABS/ESP HECU (Including TPMS function:
optional)
Exhaust gas FRT Temp. sensor (T3) 14.
15.
16.
17.
18.
19.
20.
21.
22.
23.
24.
25.