wheel SUZUKI ALTO 2012 7.G CNG Manual

3
FOR VEHICLES FITTED WITH CNG FUEL SYSTEM
68PH0-74E
FUEL MODES
There are three fuel modes in the vehicle
(Petrol, Auto and Forced CNG) which are
selectable by pressing the selector
switch(1) located on the right side of the
steering wheel on the dashboard.
NOTE:
• Do not press the accelerator pedal tochange-over from petrol to CNG mode.
• With ignition switch "ON" and engine not
running, blinking of CNG malfunction
warning lamp indicates that fuel lid is
open. Vehicle will not start in this condi-
tion.
SELECTOR SWITCH POSITION
53MHMC002
PETROL MODE
53MHMC003
In this mode vehicle starts in petrol and
continue running in petrol mode. In this
mode, petrol indicator is continuously dis-
played and CNG indicator will remain
“OFF”.
AUTO MODE
53MHMC004
In this mode engine starts in petrol mode
and then automatically changes to CNG
after reaching programmed warming up
condition. With ignition switch ON and
vehicle started in “AUTO MODE”, CNG
indicator blinks on the display and PET-
ROL indicator is displayed. After change-
over to CNG, CNG indicator will be
displayed and Petrol indicator will switch
OFF automatically.
NOTE:
• It is always recommended to start thevehicle in AUTO MODE or PETROL
MODE to enhance the engine life.
• The fuel changeover to CNG may not
happen if the vehicle is started when the
ambient / engine temperature is below
Zero Degree Celsius. In such a case,
run the engine in PETROL MODE till it
warms up and then try restarting the
engine to changeover to CNG.
WA R N I N G
Make sure that the parking brake is
applied fully and the transmission is
in Neutral before attempting to start
the engine.
CAUTION
• Stop turning the starter immedi- ately after the engine has started or
the starter system can be damaged.
• Do not crank the engine for more
than 15 seconds at a time. If the
engine doesn’t start on the first try,
wait about 15 seconds before try-
ing again.

7
FOR VEHICLES FITTED WITH CNG FUEL SYSTEM
68PH0-74E
LIST OF APPROVED CNG CYLIN-
DERSTESTING STATIONS
To obtain testing stations information visit
the following internet website address
“www.peso.gov.in”
TYRE AND JACK REMOVAL
(For CNG vehicles)
53MHMC012
• Fold the rear seat by pulling the knob (1)and (2) together as shown, in order to
access the spare wheel.
53MHMC013
• Unscrew spare wheel screw in anticlock-wise direction.
• Remove spare wheel (3) from the front
side of vehicle as shown in the figure.
• Unscrew the jack from its holder and remove.
• Reverse the above procedure for fitting the spare wheel and jack.
NOTE:
• Spare wheel can only be removed from the front side of the vehicle.
• It is recommended to remove the spare wheel first before removing the jack.
( )
( )
( )