radio controls SUZUKI ALTO 2013 7.G Owners Manual
[x] Cancel search | Manufacturer: SUZUKI, Model Year: 2013, Model line: ALTO, Model: SUZUKI ALTO 2013 7.GPages: 190, PDF Size: 8.76 MB
Page 106 of 190
5-13
OTHER CONTROLS AND EQUIPMENT
53MH0-74E
Audio System (if equipped)
ALTO 800
Refer supplementary manual for audio
system (if equipped), provided along with
the vehicle.
ALTO K10
53M-07-047
Notes on Discs
Precautions
When the inside of the vehicle is very
cold and the player is used soon after
switching on the heater, condensation
may form on the disc or the optical parts
of the player and proper playback may
not be possible. If condensation forms
on the disc, wipe it off with a soft cloth. If
condensation forms on the optical parts
of the player, do not use the player forabout one hour. This will allow the con-
densation to disappear normally.
Driving on extremely bumpy roads which
cause severe vibrations may cause
sound to skip.
This unit uses a precision mechanism.
Even in the event that trouble arises,
never open the case, disassemble the
unit, or lubricate the rotating parts.
Please bring the unit to an authorized
MARUTI SUZUKI dealer.
Cautions on Handling
53M-07-048
This unit has been designed specifically for
playback of compact discs bearing mark
(A) shown above.
53M-07-049
To remove the compact disc from its stor-
age case, press down on the center of the
EXAMPLE
If you pay extended attention to oper-
ating the audio system or viewing the
audio system display while driving,
an accident can occur. If you set the
sound volume too loud, it could pre-
vent you from being aware of road
and traffic conditions.
• Keep your eyes on the road and
your mind on the drive. Avoid pay-
ing extended attention to operating
the audio system or viewing the
audio system display.
• Familiarize yourself with the audio
system controls and operation of
the audio system before driving.
• Preset your favorite radio stations
before driving so that you can
quickly tune to them using the pre-
sets.
• Set the sound volume to a level
that will allow you to continue to be
aware of road and traffic conditions
while driving.
Page 109 of 190
5-16
OTHER CONTROLS AND EQUIPMENT
53MH0-74E
Turning power on/off
Press the VOL PUSH POWER knob (1).
The unit starts in the function mode it was
in when the power was turned off last.
Adjusting the volume
Turning it clockwise increases the volume;
turning it counterclockwise decreases the
volume.
Mute
Press the MUTE button (3) to mute the
sound. To cancel the mute, press the
MUTE button (3) again.
Adjusting bass/treble/balance /
fader
1) Press the SOUND button (2).
Each time the knob is pressed, sound
adjustment will change as follows:
2) Turn the VOL PUSH POWER knob (1)
to adjust the sound.
Beep tone
Each time SOUND button (2) is pressed
(more than 1 second) beep tone mode
switches as follows.
Preset-EQ
Preset-EQ calls up various sound types in
accordance with the listening music type.
1) Press the SOUND button (2) several
times until “FLAT” appears.
2) Turn the VOL PUSH POWER knob (2).
Each time the knob is turned, preset
EQ mode will change as follows:
NOTE:
Once the set is switched off and switched
on, the setting on EQ will be remained the
previous setting.
53M-07-058
You can also turn the power on by pressing the
desired source button
RADIO mode :
Last accessed media mode :Press the BAND
button (4)
Press the MODE
button (5)
Preset-EQ (FLAT)
Bass adjustment (BAS 0)
Treble adjustment (TRE 0)
Balance adjustment (BAL 0)
Fader adjustment (FAD 0)
Page 110 of 190
5-17
OTHER CONTROLS AND EQUIPMENT
53MH0-74E
Listening to Radio
53M-07-059
Display
53M-07-060
(1) BAND button
(2) Up button
(3) Down button
(4) Preset buttons ([1] to [6])
(5) AST button
(A) Band
(B) Stereo
(C) preset Channel Number
(D) Frequency
EXAMPLE
Page 111 of 190
5-18
OTHER CONTROLS AND EQUIPMENT
53MH0-74E
Selecting the reception BAND
Press the BAND button (1). Each time the
button is pressed, the reception band will
change as follows:
53M-07-061
Seek tuning
Hold down the seek Up button (2) or the
seek Down button (3) for 1 second or lon-
ger.
The unit stops searching for a station at a
frequency where a broadcast station is
available.
Manual tuning
Press seek Up button (2) or the seek Down
button (3).
The frequency being received is displayed.
Which receiving FM stereo broadcasting.
ST lights up.
Preset memory
1) Select the desired station.
2) Hold down a desired button ([1] to [6])
of the Preset buttons (4) to which you
want to store the station for 2 seconds
or longer.
Auto store
Hold down the AST button (5) for 1 second
or longer. Six stations in good reception
will automatically be stored to the Preset
buttons (4) in order, starting from a station
whose frequency is the lowest.
NOTE:
• Auto store can be released by pressing
AS button (5) while auto store is under
way.
• When the auto store is performed, the
station previously stored in the memory
at the position is over written.
• When there are fewer than 6 stations
that can be stored even if 2 rounds of
auto store operation is performed, no
station will be stored at the remaining
Preset buttons (4).
• 6 stations can be preset for FM1, FM2
and FM3 in common, and 6 stations for
AM in auto store mode.
Radio Reception
Radio reception can be affected by envi-
ronment, atmospheric conditions, or radio
signal’s power and distance from the sta-
tion. Nearby mountains and buildings may
interfere or deflect radio reception, causing
poor reception. Poor reception or radio
static can also be caused by electric cur-
rent from overhead wires or high voltage
power lines.
Page 113 of 190
5-20
OTHER CONTROLS AND EQUIPMENT
53MH0-74E
53M-07-064
CDs or CD-ROM carrying no mark (A)
cannot be used.
Some discs recorded in CD-R/CD-RW
format may sometimes be impossible to
use.
53M-07-065
A CD is to be inserted with its label side
up.
When there is a CD already in the unit, it
is impossible to insert another CD with-
out ejecting the CD in the unit. Do not
use force to insert a CD into the CD
insertion slot.Loading a CD
Insert a CD in the Insertion slot (2). With
the printed side up.
When a CD is loaded, play starts.
Ejecting a CD
Press the Eject button (1). (After ejecting,
the unit returns to the Radio mode.)NOTE:
• If a disc is inserted after the previous
disc is removed from the unit, the unit
starts playback from the beginning of the
first track.
• If you turn OFF the ACC and within few
second so of turning ON the ACC, the
unit starts playback from the position
from where it has accepted.
• If you press the EJECT button, and
leave the disc for roughly 15 seconds,
the disc is automatically reinserted into
the unit to protect the disc. In this case,
the unit doesn’t start playback automati-
cally.
Selecting a CD mode
Press the Media Source Mode button (3).
Each time the button is pressed, the mode
will change as follows.
53M-07066
CAUTION
• Never insert your finger or hand
into the CD insertion slot. Never
insert foreign objects.
• Never insert a CD with glue coming
out from adhesive tape or a rental
CD label or with a trace indicating
that adhesive tape or a rental CD
label has been removed. This may
cause the CD not to eject or result
in a malfunction.
CAUTION
If you forcefully try to push an
ejected CD inside the unit before auto
reloading, the disc surface might be
scratched.
• When reloading a CD, remove it
from the unit completely before
reloading.
Page 128 of 190
5-35
OTHER CONTROLS AND EQUIPMENT
53MH0-74E
Troubleshooting
FM/AM
SYMPTOM CAUSEREMEDY
The station cannot be received.The connection of the car antenna has
not been made correctly.Check the connection of the car antenna.
Automatic tuning is not possible.The broadcast signal is too weak. Perform manual setting.
The radio sensitivity is poor.Car antenna is not extended fully or
inclining.Check the car antenna.
No sound is coming out from front
speaker or rear speaker.Adjustment of the front and rear speakers
tilts towards either of the side.According to “Adjusting the audio”, adjust
the FAD level.
For the 2 speakers, adjust the FAD level
to “0”.