belt SUZUKI JIMNY 2021 User Guide

(1)
(1) Correct (2) Wrong
78RB02085
A WARNING
When fastening the rear seat belt, always use the closest buckle to you. If you use the buckle for your next rear seat position by mistake, the rear seat belt may not function prop­erly.
FOR SAFE DRIVING
Unfastening To unfasten the seat belt, push the button on the buckle (3) and retract the belt slowly while attaching a hand to the belt or/and the latch plate.
61MM0A061
61MM0A062
1-12

FOR SAFE DRIVING
A WARNING
To minimize risk of severe injury or death in the event of a collision, always fasten seat belt with both latches buckled.
1-13
Unlatching and latching detachable connector
Unlatching To unlatch the connector: 1) Insert a key into the slot (1) on the con­nector and allow the belt to retract. 2) Once the belt has completely retracted. stow the belt in the holder. Refer to "Stowing rear lap-shoulder belt"" for
details in this section.
Latching To latch the connector: 1) Pull the belt out from the holder.
78RB02017
2) Insert the connector latch plate (2) into the connector (3).
A WARNING
Check that the detachable connector is securely latched and the webbing is not twisted.

Stowing rear lap-shoulder belt Stow the belt after it is retracted com­
pletely.
(
(5) (4)
78RB02018
Bind the seat belt (4) with band (5).
FOR SAFE DRIVING
1-14

FOR SAFE DRIVING
Seat belt reminder
Instrument cluster (Type A)
L 00[]
Instrument cluster (Type B)
1-15
R
78RB02019
(1) Driver's seat belt reminder light/ front passenger's seat belt reminder light (2) Rear passenger's seat belt reminder light (rear left)*1
(3) Rear passenger's seat belt reminder light (rear right)'2
•1 This symbol represents that the seat belt is unfastened. •2This symbol represents that the seat belt is fastened.
When the driver and/or passenger(s) do not fasten their seat belts, the seat belt reminder lights will come on or blink and a buzzer will sound to remind the driver and/ or passenger(s) to fasten their seat belts. For more details, refer to the explanation below.
A. WARNING
It is absolutely essential that the driver and passengers fasten their seat belts at all times. Persons who are not fastening seat belts have a much greater risk of injury if an acci­dent occurs. Make a regular habit of buckling your seat belt before putting the key in the ignition.

Driver's seat belt reminder If the driver's seat belt remains unbuckled when the ignition switch is turned to "ON" position, the reminder works as follows: 1) The driver's seat belt reminder light will come on. The front passenger's seat
belt reminder light will also come on if a front passenger does not fasten his/her seat belt. 2) After the vehicle's speed has reached about 15 km/h, the driver's seat belt reminder light will blink and a buzzer will sound for about 95 seconds. 3) The reminder light will remain on until the driver's seat belt is buckled. If the driver has buckled his or her seat belt and later unbuckles the seat belt, the reminder system will be activated from Step 1) or 2) according to the vehicle's speed. When the vehicle's speed is less than 15 km/h, the reminder will start from Step 1 ). When the vehicle's speed is more than 15 km/h, the reminder will start from Step 2). The reminder will be automatically can­celed when the driver's seat belt is buckled or the ignition switch is turned off.
Front passenger's seat belt reminder (if equipped) If there is a person sitting in the front pas­senger seat and the front passenger seat belt is unbuckled when the ignition switch is turned to "ON" position, the front pas­senger's seat belt reminder will activate. The front passenger's seat belt reminder works in the same manner as the driver's seat belt reminder.
NOTICE
The sensor of the front passenger's
seat belt reminder is located in the seat cushion. Therefore, if you spill liquid such as liquid aromatics1 soft drinks or juice on the front passen­ger's seat cushion, immediately wipe it dry with a soft cloth. Otherwise, the sensor of the front passenger's seat belt reminder can be damaged.
NOTE: If you put an object on the passenger's seat, the weight of the object will be sensed by the sensor and the front pas­senger's seat belt reminder light (if
equipped) will come on and then the interior buzzer may beep. ff a child or a sma/1 sized person sit on the front passenger's seat or the cushion is put on the front passenger's seat, the weight wi/1 not be sensed by the sensor and the interior buzzer may not beep.
FOR SAFE DRIVING
Rear passenger's seat belt reminder (if equipped) If there is a person sitting in the rear pas­senger seat and the rear passenger seat belt is unbuckled when the ignition switch is turned to "ON" position, the rear passen­ger's seat belt reminder will activate. The rear passenger's seat belt reminder works in the same manner as the driver's seat belt reminder.
NOTICE
The sensor of the rear passenger's seat belt reminder is located in the seat cushion. Therefore, if you spill liquid such as liquid aromatics, soft drinks or juice on the rear passen­ger's seat cushion, immediately wipe it dry with a soft cloth. Otherwise, the sensor of the rear passenger's seat belt reminder can be damaged.
NOTE: ff you put an object on the rear passen­ger's seat, the weight of the object will be sensed by the sensor and the rear pas­senger's seat belt reminder light (if equipped} wi/1 come on and then the interior buzzer may beep. ff a child or a small sized person sit on the rear passenger's seat or the cushion is put on the rear passenger's seat, the weight will not be sensed by the sensor and the interior buzzer may not beep.
1-16

FOR SAFE DRIVING
Seat belt hanger
NOTICE
When you move a seatback, make sure the belt webbing is hooked in the seat belt hangers so the seat belts are not caught by the seatback, seat hinge, or seat latch. This helps prevent damage to the belt system.
1-17
Seat belt inspection
65D209S
Periodically check if the seat belts work properly and are not damaged. Check the webbing, buckles, latch plates, retractors, anchorages and guide loops. Replace any seat belts which do not work properly ·or
are damaged.
A WARNING
Inspect all seat belt assemblies after any collision. Any seat belt assembly which was in use during a collision (other than a very minor one) should be replaced, even if damage to the assembly is not obvious. Any seat belt assembly which was not in use during a collision must be replaced if the airbags and the seat belt preten­sioners activated. The airbags, the pretensioners and the load limitter will only function once. In case they did not activate, consult with Suzuki dealer.

Child restraint systems
60G332S
The following types of child restraint sys­tem are available generally.
Infant restraint
Child restraint
Booster seat
80JC008
SUZUKI highly recommends that you use a child restraint system to restrain infants and small children. Many different types of child restraint systems are available; check
FOR SAFE DRIVING
that the restraint system you select meets applicable safety standards.
All child restraint systems are designed to be secured in vehicle seats either by seat belts (lap belts or the lap portion of lap­shoulder belts) or by special rigid lower anchor bars built onto the floor. Whenever possible, SUZUKI recommends that child restraint systems be installed on the rear seat. According to accident statistics, chil­dren are safer when properly restrained in rear seating positions than in front seating positions.
(For countries applied for UN Regula­tion No.16) When purchasing a child restraint and install it to your SUZUKI vehicle, refer to the information about suitability for child restraints shown in "Child restraint system for countries applied for UN Regulation No.16" in this section.
NOTE: Observe any statutory regulation about child restraints.
1-18

Child restraint system for
countries applied for UN
Regulation No.16
.A. CAUTION
Adjust the height of the head restraint or remove it for fitting the child restraint, as necessary. How­ever, if a booster cushion not equipped with the head restraint is fitted, the head restraint should not be removed. If the head restraint is removed for fitting the child restraint, you need to install it again after removing the child restraint. If the child restraint is fitted improp­erly, a child sitting in it could be injured in a collision. (Refer to "Installation with lap-shoulder seat belts" section, 11lnstallation with ISO­FIX type anchorages" section and "Installation of child restraint with top tether11 section in this section for details.)
Child restraint
The suitability of each passenger's seat position for carriage of children and fitting of child restraint system is shown in the table.
Child restraint systems suitability for each seat position (for the vehicle with airbag deactivation switch)
The above illustration shows Left hand drive vehicle.
NOTE: Seat position number of G), @ and @ is same as Left hand drive vehicle for Right hand drive vehicle.
G) Front passenger's seat @ Rear seat right side @ Rear seat left side
G) (ID@ (#1. #2. #3)
(2) (ID~J,~ (#2, #3)
® (ID~J,~ (#2. #3)
FOR SAFE DRIVING
It is suitable for univer­sal category of child restraint system fixed with the vehicle seat belt.
It is suitable for i-Size and ISOFIX child restraint system.
This seat is equipped with Top tether anchor­age point.
Never use a rear-fac­ing child restraint sys­tem on the passenger seat when the front passenger airbag is activated.
#1: Move the front seat fully rearward. #2: When you install a forward-facing child restraint, if there is a gap or space between the child restraint and the seatback, adjust the seat­back angle in order to install the child restraint system properly. #3: If the head restraint interferes with the child restratint system, adjust the height of the head restraint or remove it, as necessary.
NOTE: For the Installation suitability of child restraint systems of Taiwan models, refer to "For Taiwan" in the "SUPPLE­MENT" section.
1-20

FOR SAFE DRIVING
Detailed information for child restraint system (for the vehicle with airbag deactivation switch)
Seating position
Seat position number
Seating position suitable for universal belted (YES/NO)
i-Size seating position (YES/NO)
Seating position suitable for lateral fixture (L 1/L2)
Suitable rear-facing fixture (R1/R2/R3)
Suitable front-facing fixture (F2X/F2/F3)
Key of letters to be inserted in the above table YES =Suitable for this seating position NO = Not suitable for this seating position
Front Passenger airbag is activated
NO
NO
NO
NO
NO
X =ISOFIX position is not suitable for ISOFIX child restraint systems in this fixture.
G)
ISOFIX child restraint systems are divided into different mass group, size class and fixture.
Front Passenger airbag is deactivated
YES
NO
NO
NO
NO
The child restraint system can be used in the seating positions for fixture shown in the above table. For mass group, size class and fixture, confirm the table of next page.
NOTE:
(2)
YES
YES
X
R1, R2
F2X, F2, F3
@
YES
YES·
X
R1, R2
F2X, F2, F3
For the Installation suitability of child restraint systems of Taiwan models, refer to "For Taiwan" in the "SUPPLEMENT' section.
1-21

FOR SAFE DRIVING
Installation suitability of SUZUKI recommendation child restraint systems (for the vehicle with airbag deactivation switch)
Recommendation of Mass group Child restraint system (#A)
0,0+ Britax Romer Baby-Safe i-Size (up to 13kg)
I Britax Romer Duo Plus (9kg to 18kg)
11, Ill Britax Romer Kid Fix XP (15kg to 36kg)
Key of letters to be inserted in the above table YES =It is suitable for this seating position NO = II is not suitable for this seating position
#1: Only belted.
Seating position
G)
Front Front (2) Passenger Passenger airbag is airbag is activated deactivated
NO YES (#1) YES (#1)
NO YES (#1) YES
NO YES (#1) YES
#A: These child restraint systems are SUZUKI Genuine Accessory, refer to the accessories catalog. However, there are countries which do not sell this child restraint system.
1-23
@
YES (#1)
YES
YES