master cylinder TOYOTA AVALON 2001 Service Repair Manual
[x] Cancel search | Manufacturer: TOYOTA, Model Year: 2001, Model line: AVALON, Model: TOYOTA AVALON 2001Pages: 1897, PDF Size: 26.61 MB
Page 214 of 1897
BE0IE-03
I12531
Brake Master Cylinder
Brake Fluid Level
Warning Switch
Engine Room
Junction Block
SRS WRN Fuse
Washer Tank
Washer Fluid Level
Warning Switch
Combination Meter
Meter Circuit
Light Control
Rheostat
Driver Side Junction Block
GAUGE No.1 Fuse
PANEL Fuse
ECU-B No.1, 2 Fuss
ECU-IG No.2 Fuse
RAD No.1 Fuse
DOME Fuse
ECU ACC Fuse Parking Brake
Switch
Ignition Switch
Multi Information Display
- BODY ELECTRICALCOMBINATION METER
BE-41
1645 Author: Date:
2001 AVALON (RM808U)
COMBINATION METER
LOCATION
Page 227 of 1897
1.8 Sec.
0.2 Sec.
0.25 Sec. 0.5 Sec.0.25 Sec.
1 Sec. Blinks Code 2-1 Code2-2
0.25 Sec.
0.25 Sec.0.5 Sec. 1 Sec.
- BODY ELECTRICALENGINE IMMOBILISER SYSTEM
BE-173
1777 Author: Date:
2001 AVALON (RM808U)
HINT:
When a key is not inserted in the key cylinder in the automatic registration mode, the security indicator
always lights on.
When the immobiliser system operations normally and the key is pull out, the security indicator blinks.
When key code registration could not be performed in the automatic registration mode, code 2-1 is
output from the security indicator and when inserting the already registered key, code 2-2 is output.
(b) Automatic registration mode completion
If completing the mode forcibly when more than 1 key code have been registered in the automatic reg-
istration mode, perform the following procedures.
After 1 more key code have been registered with master key, perform step (1) or (2) without pulling
the key out or inserting the already registered key.
(1) Depress and release brake pedal 5 times or more within 15 secs.
(2) With the hand-held tester, require automatic registration mode completion.
Page 228 of 1897
Will you register the
next key?
No Ye s
Insert already registered master key in the key
cylinder
Depress and release the acceleration pedal 5
times.
Depress and release the brake pedal 6 times,
and remove the master key.
Insert key to be registered in key cylinder.
Depress and release the acceleration pedal 1
time. (Security indicator blinks)
The registration mode completes when pulling
out the key within 10 secs. and the brake pedal
is depressed or after indicator is off 10 secs.
pass. Within 10 secs.Within 15 secs.
Within 20 secs.
Within 10 secs.
Within 10 secs.
After 60 secs. additional master key is regis-
tered. (Security indicator is OFF)
BE-174
- BODY ELECTRICALENGINE IMMOBILISER SYSTEM
1778 Author: Date:
2001 AVALON (RM808U)
2. REGISTRATION OF ADDITIONAL MASTER KEY
There are 2 ways for registration of additional master key, one is depressing brake pedal and acceleration
pedal and the other is using hand-held tester.
HINT:
It is possible to register up to 7 master key codes including the already registered key code.
When any operation time described below is over, registration mode completes.
When the next procedure is performed while the timer is working, the timer completes counting time,
then next timer starts.
(1) Depressing brake pedal and acceleration pedal:
Page 229 of 1897
Insert already registered master key in the key cylinder
and turn the ignition switch ON.
Listing hand-held tester select master key registration.
Remove the master key.
Insert key to be registered in key cylinder.
(Security indicator blinks)
After 60 secs., additional master key is registered.
(Security indicator OFF)
The registration mode completes when pulling out the key
within 10 secs. and the brake pedal is depressed or after
indicator is off 10 secs. pass.Within 20 secs.
Within 10 secs.
HINT:
Please follow the screen of the hand-held tester for more detailed procedure.
- BODY ELECTRICALENGINE IMMOBILISER SYSTEM
BE-175
1779 Author: Date:
2001 AVALON (RM808U)
(2) Using hand-held tester:
Page 230 of 1897
Will you register the
next key?
No Ye s
Insert already registered master key in the key
cylinder
Depress and release the acceleration pedal 4
times.
Depress and release the brake pedal 5 times,
and remove the master key.
Insert key to be registered in key cylinder.
Depress and release the acceleration pedal 1
time. (Security indicator blinks)
The registration mode completes when pulling
out the key within 10 secs. and the brake pedal
is depressed or after indicator is off 10 secs.
pass. Within 10 secs.Within 15 secs.
Within 20 secs.
Within 10 secs.
Within 10 secs.
After 60 secs. additional sub-key is registered.
(Security indicator is OFF)
BE-176
- BODY ELECTRICALENGINE IMMOBILISER SYSTEM
1780 Author: Date:
2001 AVALON (RM808U)
3. REGISTRATION OF ADDITIONAL SUB-KEY
There are 2 ways for registration of additional sub-key, one is depressing brake pedal and acceleration ped-
al and the other is using hand-held tester.
HINT:
It is possible top register up to 3 sub-key codes including the already registered key code.
When any operation time described below is over, registration mode completes.
When the next procedure is performed while the timer is working, the timer completes counting time,
then next timer starts.
(1) Depressing brake pedal and acceleration pedal:
Page 231 of 1897
Listing TOYOTA hand-held tester select sub-key regis-
tration.
Remove the master key.
Insert key to be registered in key cylinder.
(Security indicator blinks)
After 60 secs., additional sub-key is registered.
(Security indicator OFF)
The registration mode completes when pulling out the key
within 10 secs. and the brake pedal is depressed or after
indicator is off 10 secs. pass.Within 20 secs.
Within 10 secs.
Insert already registered master key in the key cylinder
and turn the ignition switch ON.
HINT:
Please follow the screen of the hand-held tester for more detailed procedure.
- BODY ELECTRICALENGINE IMMOBILISER SYSTEM
BE-177
1781 Author: Date:
2001 AVALON (RM808U)
(2) Using hand-held tester:
Page 232 of 1897
1. Insert master key in the key cylinder.
2. Depress and release the acceleration pedal 6 times.
3. Depress and release the brake pedal 7 times.
4. Remove the master key.
HINT:
If the key cannot be pulled out within 30 sec. from the first brake
depression in the step 3, the key code deletion is canceled.(Key code erased)
Within 15 sec.
Within 20 sec.
Within 10 sec.
END
5. Leave the vehicle more than 20 sec. without any
operation.
BE-178
- BODY ELECTRICALENGINE IMMOBILISER SYSTEM
1782 Author: Date:
2001 AVALON (RM808U)
4. ERASURE OF TRANSPONDER KEY CODE
There are 2 ways for erasure of transponder key code, one is depressing brake pedal and acceleration pedal
and the other is using hand-held tester.
NOTICE:
All other master and sub-key codes are deleted leaving the master key code to use the operation.
When using the key which was used before deleting, it is necessary to register the code again.
HINT:
When any operation time described below is over, registration mode completes.
When the next procedure is performed while the timer is working, the timer completes counting time,
then next timer starts.
(1) Depressing brake pedal and acceleration pedal:
Page 233 of 1897
2. Require key code deletion from hand-held tester.
(Security indicator blinks)
3. Remove the master key.
HINT: END
Within 10 secs.
(Key code erased) 1. Insert already registered master key in the key cylinder
and turn the ignition switch ON.
When the key cannot be pulled out in the step 3, key code deletion is canceled.
(Security indicator is OFF)
Please follow the screen of the hand-held tester for more detailed procedure.
- BODY ELECTRICALENGINE IMMOBILISER SYSTEM
BE-179
1783 Author: Date:
2001 AVALON (RM808U)
(2) Using hand-held tester:
Page 258 of 1897
BE212-01
BE-88
- BODY ELECTRICALPOWER DOOR LOCK CONTROL SYSTEM
1692 Author: Date:
ADJUSTMENT
ENABLING/DISABLING AUTO DOOR LOCK FUNCTION
(a) To disable auto door lock:
(1) Enter the vehicle and shut all doors.
(2) Insert the key into the ignition cylinder and turn it to
the ON position (not ACC).
(3) Open the driver's door and keep it open.
(4) Turn the key to the LOCK position and remove it
from the ignition cylinder.
(5) Insert the key into the ignition cylinder and remove
it. Repeat this operation three more times. (End this
step with the key out of the ignition cylinder.)
(6) Push the ºUNLOCKº button on the driver's door
master switch 5 times within 10 seconds. Wait at
least 10 seconds and shut the driver's door.
(7) Verify auto lock operation has been disabled by
starting the engine, putting the vehicle into a gear
and releasing the brake pedal.
(b) To enable auto door lock:
Follow the same sequence as above, except step 6. In step 6,
push the ºLOCKº button on the driver's door master switch 5
times within 10 seconds. Wait at least 10 seconds and shut the
driver 's door.
Page 494 of 1897
BR0KX-04
F09719
Air Cleaner with Air Cleaner Hose
Vacuum Hose
Master Cylinder
Brake Booster AssemblyReturn Spring
Lower LH Instrument
Panel Insert
Lower No. 1 Instrument
Panel
No. 2 Heater to Register DuctCleviseClip Wave Washer
Gasket 2-way
w/ VSC:
15 (155, 11)
13 (130, 9)
13 (130, 9)
13 (130, 9)15 (155, 11)
19 (195, 14)
N´m (kgf´cm, ft´lbf) : Specified torque
Non-reusable part
19 (195, 14)
Precharge Pump Assembly
Level Warning Switch
Connetor
Pin
12 (260, 19)
BR-22
- BRAKEBRAKE BOOSTER ASSEMBLY
1421 Author: Date:
2001 AVALON (RM808U)
COMPONENTS