light TOYOTA AYGO 2011 Owner's Guide

LIGHTS, WIPERS AND DEFOGGER11 7
MS14003b
TURN SIGNALS
To signal a turn, push the headlight/
turn signal lever up or down to position
1.
The engine switch must be in the “ON”
position.
The lever automatically returns after you
make a turn, but you may have to return
it by hand after you change lanes.
To signal a lane change, move the lever
up or down to the pressure point (position
2) and hold it.
If the turn signal indicator lights (green
lights) on the instrument cluster flash fast-
er than normal, a front or rear turn signal
bulb has burned out.
Headlight beam level control
MS14004a
To adjust the headlight beam level, turn
the switch.
The following list shows examples of prop-
er switch settings. For loading conditions
other than those listed, adjust the dial
position so that the beam level is the
same as the one obtained according to
the list when only the driver is in the
vehicle. The higher the number of the dial
position, the lower the headlight beam lev-
el.
CAUTION
Always keep the headlight beam at
the proper level, or your headlights
may dazzle other road users, causing
unexpected accidents.
AYGO WE 99E37E11 02.18

11 8LIGHTS, WIPERS AND DEFOGGER
"Vehicle category M1
∗
Loading condition
Indication
figure of
control switch
Driver only or
Driver + one
passenger in the front
seat.
0
All passengers.1
All passengers and
Full luggage loading
to the luggage room.
2
Driver and
Full−luggage loading
to the luggage room.
3
"Vehicle category N1∗
Loading condition
Indication
figure of
control switch
Driver only0
Driver and
Full−luggage loading
to the luggage room
2
∗: To distinguish the vehicle category, ask
any authorized Toyota dealer or repair-
er, or another duly qualified and
equipped professional.
Emergency flashers
MS14005a
To turn on the emergency flashers,
push the switch.
All the turn signal lights will flash. To turn
them off, push the switch once again.
Turn on the emergency flashers to warn
other drivers if your vehicle must be
stopped where it might be a traffic hazard.
Always pull as far off the road as pos-
sible.
The turn signal light switch will not work
when the emergency flashers are operat-
ing.
NOTICE
To prevent the battery from being dis-
charged, do not leave the switch on
longer than necessary when the en-
gine is not running.
AYGO WE 99E37E11 02.18

LIGHTS, WIPERS AND DEFOGGER11 9
Rear fog light
MS14006a
To turn on the rear fog light, twist the
band of the headlight and turn signal
switch lever to the position of the rear
fog light. They will come on when the
headlights are on.
The rear fog light indicator on the instru-
ment cluster will light up when the rear
fog light is turned on.
The rear fog light will go off automatically
when all other lights are turned off.
After the headlight switch is turned off,
the rear fog light does not come on even
if you turn on the headlight switch again.
To turn on the rear fog light, twist the
band of the headlight and turn the signal
switch lever to the position of the rear fog
light again under the condition stated
above.
Interior light
MS14007
To turn on the interior light, slide the
switch.
The interior light switch has the following
positions:
“
” (ON)—Keeps the light on all the
time.
“
” (OFF)—Turns the light off.
“
” (DOOR)—Turns the light on when
the driver ’s door is opened.
AYGO WE 99E37E11 02.18

120LIGHTS, WIPERS AND DEFOGGER
Windshield wiper and washer
MS14008a
To turn on the windshield wiper, move
the lever to the desired setting.
The engine switch must be in the “ON”
position.
Lever position
Speed setting
Position 1Intermittent
Position 2Slow
Position 3Fast
For a single sweep of the windshield,
push the lever up and release it.
To squirt washer fluid, pull the lever
toward you.
For instructions on adding washer fluid,
see “Adding washer fluid” on page 282 in
Section 7−3.
In freezing weather, warm the windshield
with the defroster before using the washer.
This will help prevent the washer fluid
from freezing on your windshield, which
could block your vision.
NOTICE
Do not operate the wiper if the wind-
shield is dry. It may scratch the
glass.
MS14009a
To turn on the rear window wiper, twist
the lever knob upward. (Position 1)
The engine switch must be in the “ON”
position.
To squirt washer fluid on the rear window,
twist the knob upward or downward as far
as it will go (position 2 or 3). The knob
automatically returns from these positions
after you release it.
For instructions on adding washer fluid,
see “Adding washer fluid” on page 282 in
Section 7−3.
NOTICE
Do not operate the rear wiper if the
rear window is dry. It may scratch the
glass.
AYGO WE 99E37E11 02.18
Rear window wiper and
washer

LIGHTS, WIPERS AND DEFOGGER121
Rear window defogger
MS14010a
To defog or defrost the rear window,
push the switch.
The engine switch must be in the “ON”
position.
The thin heater wires on the inside of the
rear window will quickly clear the window
surface. An indicator light will illuminate to
indicate the defogger is operating.
Push the switch once again to turn the
defogger off.
Make sure you turn the defogger off when
the window surface is clear. Leaving the
defogger on for a long time could cause
the battery to discharge, especially during
stop−and−go driving. The defogger is not
designed for drying rain water or for melt-
ing snow.
NOTICE
zTo prevent the battery from being
discharged, turn the switch off
when the engine is not running.
zWhen cleaning the inside of the
rear window, be careful not to
scratch or damage the heater wires
or connectors.
AYGO WE 99E37E11 02.18

122LIGHTS, WIPERS AND DEFOGGER
AYGO WE 99E37E11 02.18

GAUGES, METERS AND SERVICE REMINDER INDICATORS123
Section 1−6
OPERATION OF INSTRUMENTS AND
CONTROLS
Gauges, Meters and Service reminder indicators
DFuel gauge 124............................................
DEngine coolant temperature warning lights 125...............
DTachometer 126...........................................
DOdometer and trip meter 126...............................
DService reminder indicators and warning buzzers 127.........
AYGO WE 99E37E11 02.18

124GAUGES, METERS AND SERVICE REMINDER INDICATORS
Fuel gauge
MS15001
The gauge indicates the approximate
quantity of fuel remaining in the tank
when the engine switch is on.
Nearly full—Indicator at “1/1”
Nearly empty—Indicator at “R”
It is a good idea to keep the tank over
1/3 full.
MS15002
If the low fuel level warning light blinks
and the warning buzzer comes on, fill the
fuel tank as soon as possible. Further fuel
reduction makes the light blink quicker.
On incline or curves, due to the move-
ment of fuel in the fuel tank, the warning
light may blinks and the warning buzzer
may come on earlier than usual.
On some models—
If the fuel tank is completely empty, the
malfunction indicator lamp comes on. Fill
the fuel tank immediately.
The indicator lamp goes off after driving
several times. If the indicator lamp does
not go off, contact any authorized Toyota
dealer or repairer, or another duly quali-
fied and equipped professional, as soon
as possible.
AYGO WE 99E37E11 02.18

GAUGES, METERS AND SERVICE REMINDER INDICATORS125
MS15003
The warning lights indicate the engine
coolant temperature when the engine
switch is on. The engine operating tem-
perature will vary with changes in
weather and engine load.
The engine coolant temperature warning
light will come on when the engine switch
is turned to the “ON” position. After a few
seconds, the light will go off.
Engine coolant temperature is high...
When the engine coolant temperature be-
comes high, the engine coolant tempera-
ture warning light blinks. If the tempera-
ture rises further, the engine coolant
temperature warning light remains on and
at the same time, the “STOP” warning
light blinks. In such cases, the engine is
too hot. If your vehicle overheats, stop the
vehicle and allow the engine to cool down.
Your vehicle may overheat during severe
operating conditions, such as:
DDriving up a long hill on a hot day.
DReducing speed or stopping after high
speed driving.
DIdling for a long period with the air
conditioning on in stop−and−go traffic.
NOTICE
zDo not remove the thermostat from
the engine cooling system as this
may cause the engine to overheat.
The thermostat is designed to con-
trol the flow of coolant to keep the
temperature of the engine within
the specified operating range.
zDo not continue driving with an
overheated engine. See “If your
vehicle overheats” on page 225 in
Section 4.
AYGO WE 99E37E11 02.18
Engine coolant temperature
warning lights

GAUGES, METERS AND SERVICE REMINDER INDICATORS127
Service reminder indicators and warning buzzers
If the indicator or buzzer
comes on...Do this.
(a)If the parking brake is off stop vehicle immediately and
contact any authorized Toyota dealer or repairer, or
another duly qualified and equipped professional.
(b)Fasten driver ’s seat belt.
(c)(indicator and buzzer)Fasten front passenger ’s seat belt.
(d)Stop immediately and contact any authorized Toyota
dealer or repairer, or another duly qualified and equipped
professional.
(e)Stop and check.
(f)Take vehicle to any authorized Toyota dealer or repairer,
or another duly qualified and equipped professional.
(g)Stop and check.
(h)
(indicator and buzzer)
Fill up tank.
(i)Stop and check.
(j)
Take vehicle to any authorized Toyota dealer or repairer,
or another duly qualified and equipped professional, im-
mediately. If the vehicle cannot be driven, contact any
authorized Toyota dealer or repairer, or another duly qual-
ified and equipped professional.
(k)
Take vehicle to any authorized Toyota dealer or repairer,
or another duly qualified and equipped professional. If
brake system warning light is also on, stop immediately
and contact any authorized Toyota dealer or repairer, or
another duly qualified and equipped professional.
AYGO WE 99E37E11 02.18