belt TOYOTA AYGO 2011 Service Manual

OCCUPANT RESTRAINT SYSTEMS103
MS13059
CAUTION
Push and pull the child restraint sys-
tem in different directions to be sure
it is secure. Follow all the installation
instructions provided by its manufac-
turer.
MS13060
To remove the child seat:
Press the buckle release button and re-
move a locking clip in case of use and
allow the belt to retract completely. The
belt will move freely again and be ready
to work for an adult or older child passen-
ger.
AYGO WE 99E37E11 02.18

OCCUPANT RESTRAINT SYSTEMS105
MS13062a
To install the junior seat:
Sit the child on a junior seat. Run the lap
and shoulder belt through or around the
junior seat and across the child following
the instructions provided by its manufac-
turer and insert the tab into the buckle
taking care not to twist the belt.
Make sure the shoulder belt is correctly
across the child’s shoulder and that the
lap belt is positioned as low as possible
on the child’s hips. See “Seat belts” on
page 48 for details.
CAUTION
DAlways make sure the shoulder belt
is positioned across the center of
child’s shoulder. The belt should be
kept away from child’s neck, but
not falling off child’s shoulder.
Otherwise, the child may be killed
or seriously injured in the event of
sudden braking, sudden swerving or
an accident.
DBoth high−positioned lap belts and
loose−fitting belts could cause
death or serious injuries due to
sliding under the lap belt during a
collision or other unintendedevent.
Keep the lap belt positioned as low
on a child’s hips as possible.
DFor child’s safety, do not place the
shoulder belt under child’s arm.
DAfter inserting the tab, make sure
the tab and buckle are locked and
that the lap and shoulder portions
of the belt are not twisted.
DDo not insert coins, clips, etc. in
the buckle as this may prevent your
child from properly latching the tab
and buckle.
DIf the seat belt does not function
normally, it cannot protect your
child from death or serious injury.
Contact any authorized Toyota deal-
er or repairer, or another duly quali-
fied and equipped professional, im-
mediately. Do not install the child
restraint system on the seat until
the seat belt is fixed.
AYGO WE 99E37E11 02.18

106OCCUPANT RESTRAINT SYSTEMS
MS13063
To remove the junior seat:
Press the buckle release button and allow
the belt to retract.
MS13066c
Follow the procedure below for a child
restraint system that requires the use
of a top strap.
AYGO WE 99E37E11 02.18
—Using a top strap
(with rear seats)

108OCCUPANT RESTRAINT SYSTEMS
MS13068d
2. Fix the child restraint system with
the seat belt.
Latch the hook onto the anchor
bracket and tighten the top strap.
For instructions to install the child re-
straint system, see “Child restraint” on
page 80 in this Section.
CAUTION
DMake sure the top strap is securely
latched, and check that the child
restraint system is secure by push-
ing and pulling it in different direc-
tions.
DFollow all the installation instruc-
tions provided by its manufacturer.
MS13069a
3. Move down the head restraint.
AYGO WE 99E37E11 02.18

OCCUPANT RESTRAINT SYSTEMS109
MS13070
The rear seat is equipped with a fixing
bar for use exclusively with child re-
straint systems that conform to ISO
specifications.
The bars are installed in the clearance
between the seat cushion and seatback of
both rear seats.
Child restraint systems usingquasi−ISO
specifications can be fixed to these exclu-
sively with fixing bars. In this case, it is
not necessary to fix the child restraint
system with a seat belt on the vehicle.
NOTICE
Ask the manufacturer of the child re-
straint system if the child restraint
system is approved for this model.
MS13071b
CHILD RESTRAINT SYSTEM
INSTALLATION
1. Widen the gap between the seat
cushion and seatback slightly and
confirm the position of the exclusive
fixing bars below the tag on the
seatback.
2. Latch the buckles onto the exclusive
fixing bars. If necessary, also move
the front seats forward.
For installation details, refer to the instruc-
tion manual supplied with each product.
AYGO WE 99E37E11 02.18
—Installation with ISOFIX rigid
anchor (ISOFIX child restraint
system) (with rear seat)

11 0OCCUPANT RESTRAINT SYSTEMS
CAUTION
DWhen using the exclusive fixing bar
for the child restraint system, be
sure that there are no irregular ob-
jects around the bars or that the
seat belt is not caught.
DPush and pull the child restraint
system in different directions to be
sure it is secure. Follow all the
installation instructions provided by
its manufacturer.
DDo not install a child restraint sys-
tem on the rear seat if it interferes
with the lock mechanism of the
front seats. Otherwise, the child or
front seat occupant(s) may be killed
or seriously injured in the event of
sudden braking, sudden swerving or
an accident.
AYGO WE 99E37E11 02.18

GAUGES, METERS AND SERVICE REMINDER INDICATORS127
Service reminder indicators and warning buzzers
If the indicator or buzzer
comes on...Do this.
(a)If the parking brake is off stop vehicle immediately and
contact any authorized Toyota dealer or repairer, or
another duly qualified and equipped professional.
(b)Fasten driver ’s seat belt.
(c)(indicator and buzzer)Fasten front passenger ’s seat belt.
(d)Stop immediately and contact any authorized Toyota
dealer or repairer, or another duly qualified and equipped
professional.
(e)Stop and check.
(f)Take vehicle to any authorized Toyota dealer or repairer,
or another duly qualified and equipped professional.
(g)Stop and check.
(h)
(indicator and buzzer)
Fill up tank.
(i)Stop and check.
(j)
Take vehicle to any authorized Toyota dealer or repairer,
or another duly qualified and equipped professional, im-
mediately. If the vehicle cannot be driven, contact any
authorized Toyota dealer or repairer, or another duly qual-
ified and equipped professional.
(k)
Take vehicle to any authorized Toyota dealer or repairer,
or another duly qualified and equipped professional. If
brake system warning light is also on, stop immediately
and contact any authorized Toyota dealer or repairer, or
another duly qualified and equipped professional.
AYGO WE 99E37E11 02.18

GAUGES, METERS AND SERVICE REMINDER INDICATORS129
(a) Brake System Warning Light
This light comes on in the following cases
when the engine switch is in the “ON”
position.
DWhen the parking brake is applied...
This light comes on for a few seconds
when the engine switch is turned to the
“ON” position even after the parking brake
is released.
DWhen the brake fluid level is low...
CAUTION
It is dangerous to continue driving
normally when the brake fluid level is
low.
Have your vehicle checked at any au-
thorized Toyota dealer or repairer, or
another duly qualified and equipped
professional, in the following cases:
DThe light does not come on even if the
parking brake is applied when the en-
gine switch is in the “ON” position.
DThe light does not come on even if the
engine switch is turned on with the
parking brake released.
A warning light turning on briefly during
operation does not indicate a problem.
CAUTION
If either of the following conditions
occurs, immediately stop your vehicle
at a safe place and contact any au-
thorized Toyota dealer or repairer, or
another duly qualified and equipped
professional.
DThe light does not turn off even
after the parking brake is released
while the engine is running.
In this case, the brakes may not
work properly and your stopping
distance will become longer. De-
press the brake pedal firmly and
bring the vehicle to an immediate
stop.
DThe brake system warning light re-
mains on together with the “ABS”
warning light.
In this case, not only the anti−lock
brake system will fail but also the
vehicle will become extremely un-
stable during braking.
(b) Driver ’s Seat Belt Reminder Light
and Buzzer
The light and buzzer act as a reminder to
buckle up the driver ’s seat belt.
Once the engine switch is turned to “ON”
or “START”, the reminder light flashes if
the driver ’s seat belt is not fastened. Un-
less the driver fastens the belt, the light
continues flashing.
If the vehicle speed rises above 20 km/h
(12 mph) with the seat belt unfastened,
the buzzer will sound for 30 seconds.
Then, if the seat belt is still unfastened,
the buzzer will sound in a different tone
for 90 more seconds. Even if the vehicle
speed drops below 20 km/h (12 mph), the
buzzer will continue to sound. To stop the
buzzer, fasten the seat belt. If the buzzer
still sounds, make sure the front passen-
ger ’s seat belt is fastened.
AYGO WE 99E37E11 02.18

130GAUGES, METERS AND SERVICE REMINDER INDICATORS
(c) Front Passenger ’s Seat Belt
Reminder Light and Buzzer
The light and buzzer act as a reminder to
have the front passenger buckle up the
seat belt.
Once the engine switch is turned to “ON”
or “START”, the reminder light flashes if
a passenger sits in the front passenger
seat and does not fasten the seat belt.
Unless the front passenger fastens the
belt, the light continues flashing.
If the vehicle speed rises above 20 km/h
(12 mph) with the seat belt unfastened,
the buzzer will sound for 30 seconds.
Then, if the seat belt is still unfastened,
the buzzer will sound in a different tone
for 90 more seconds. Even if the vehicle
speed drops below 20 km/h (12 mph), the
buzzer will continue to sound. To stop the
buzzer, fasten the seat belt. If the buzzer
still sounds, make sure the driver ’s seat
belt is fastened.
If luggage or other load is placed on the
front passenger seat, depending on its
weight and how it is placed on the seat,
built−in sensors in the seat cushion may
detect the pressure, causing the reminder
light to flash and buzzer to sound.
(d) Charging System Warning Light
This warning light comes on when the
engine switch is turned to the “ON” posi-
tion, and goes off when the engine is
started.
When there are problems in the charging
system while theengine is running, the
warning light comes on.
NOTICE
When the charging system warning
light comes on while the engine is
running, malfunctions such as the en-
gine drive belt being broken may have
occurred. If the warning light comes
on, immediately stop the vehicle in a
safe place and contact any authorized
Toyota dealer or repairer, or another
duly qualified and equipped profes-
sional.
(e) Low Engine Oil Pressure Warning
Light
This light warns that the engine oil pres-
sure is too low.
If the engine oil pressure warning light
comes on, pull off the road to a safe
place and stop the engine immediately.
Call any authorized Toyota dealer or re-
pairer, or another duly qualified and
equipped professional, for assistance. The
“STOP” warning light also comes on at
thesametime.
The light may occasionally flicker when
the engine is idling or it may come on
briefly after a hard stop. There is no
cause for concern if it then goes out when
the engine is accelerated slightly.
The light may come on when the engine
oil level is extremely low. It is not de-
signed to indicate low engine oil level, and
the engine oil level must be checked us-
ing the level dipstick.
NOTICE
Do not drive the vehicle with the
warning light on—even for one block.
It may ruin the engine.
AYGO WE 99E37E11 02.18

134GAUGES, METERS AND SERVICE REMINDER INDICATORS
If the light comes on while driving, the
systemdoes not work. However, as con-
ventional braking operates when applied,
there is no problem to continue your driv-
ing.
In the following cases, contact any autho-
rized Toyota dealer or repairer, or another
duly qualified and equipped professional:
DThe warning light does not come on
after the engine switch is turned to the
“ON” position.
DThe warning light remains on after the
engine switch is turned to the “ON”
position.
DThe warning light comes on while driv-
ing.
(m) SRS Warning Light
This light will come on when the engine
switch is turned to the “ON” position.
It goes off after about 6 seconds or
remains on when the airbag manual on−
off switch is in the “OFF” position.
This means the airbag system is operat-
ing properly.
This warning light system monitors the
airbag sensor assembly, side airbag sen-
sors, side and curtain shield airbag sen-
sors, front seat belt pretensioner assem-
blies, inflators, warning light,
interconnecting wiring and power sources.
If either of the following conditions occurs,
this indicates a malfunction somewhere in
the components monitored by the warning
light system. Contact any authorized
Toyota dealer or repairer, or another duly
qualified and equipped professional, as
soon as possible to service the vehicle.
DThe key cylinder cannot be turned.
The airbag manual on−offswitchisinthe
“ON” position:
DWhen the engine switch is turned to
the “ON” position, the light comes on
for more than 6 seconds and then
flashes.
DWhen the engine switch is turned to
the “ON” position, the light either re-
mains off or flashes.
DWhile driving the vehicle, the light
flashes.
The airbag manual on−offswitchisinthe
“OFF” position.
DWhen the engine switch is turned to
the “ON” position, the light comes on
for more than 6 seconds and then goes
off or flashes.
DWhen the engine switch is turned to
the “ON” position, the light remains off
or flashes without illuminating for more
than 6 seconds.
DWhile driving the vehicle, the light goes
off or flashes.
(n) Electric Power Steering System
Warning Light
The light comes on when the engine
switch is turned to the “ON” position. If
the electric power steering system warning
light works properly, the light turns off
after a few seconds. If thesystem has
malfunctions, the light comes on again.
If the following conditions occur, this
indicates a malfunction somewhere in
the parts monitored by the warning
light system. Contact any authorized
Toyota dealer or repairer, or another
duly qualified and equipped profession-
al, as soon as possible to service the
vehicle.
DThe light does not come on when the
engine switch is turned to the “ON”
position or remains on.
DThe light stays on while you are driv-
ing.
The warning light turning on while racing
the engine for a long time may not indi-
cate malfunction. To turn off the light, re-
start the engine and start driving.
AYGO WE 99E37E11 02.18