battery TOYOTA AYGO 2011 Owners Manual

KEYS AND DOORS19
If the wireless remote control key does
not actuate the doors, or does not operate
from a normal distance:
DCheck for closeness to a radio trans-
mitter such as a radio station or an
airport which can interfere with normal
operation of the key.
DThe battery may have been consumed.
Check the battery in the key. To
replace the battery, see “—Replacing
battery” on page 20.
If you lose your wireless remote control
key, contact any authorized Toyota dealer
or repairer, or another duly qualified and
equipped professional, as soon as pos-
sible to avoid the possibility of theft, or an
accident. (See “If you lose your keys” on
page 243 in Section 4.)
MS12002a
Locking operation
MS12003a
Unlocking operation
To lock and unlock all the side doors
and back door, push the switches of
the key slowly and securely.
To lock: Push the “
”(LOCK)switch.All
the side doors and back door will be
locked simultaneously. At this time, the
turn signal lights flash once.
Check to see that the doors are securely
locked.
To unlock: Push the “
” (UNLOCK)
switch. All the side doors and back door
are unlocked simultaneously. At this time,
the turn signal lights flash twice.
AYGO WE 99E37E11 02.18
—Locking and unlocking
doors

20KEYS AND DOORS
If the “
”(LOCK)or“” (UNLOCK)
switch is kept pressed in, the locking or
unlocking operation is not repeated. Re-
lease the switch and then push again.
In the following cases, the battery in the
key may be discharged. If this is the
case, to replace the battery, see
“—Replacing battery” on page 20.
DThe remote control does not work.
DThe operational range of wireless re-
mote control becomes extremely short.
—Replacing battery
For replacement, use a CR2016 lithium
battery or equivalent.
CAUTION
DSpecial care should be taken to pre-
vent small children from swallowing
the removed battery or components.
Failure to do so could result in
death or serious injury.
DRisk of explosion if battery is re-
placed by an incorrect type.
DDispose of the used batteries ac-
cording to the instructions.
NOTICE
zWhen replacing the battery, be care-
ful not to lose the components.
zReplace only with the same or
equivalent type recommended by an
authorized Toyota dealer or repairer,
or another duly qualified and
equipped professional.
zDispose of used battery according
to the local laws.
Replace the battery by following these
procedures:
AYGO WE 99E37E11 02.18

22KEYS AND DOORS
MS12020a
3. Remove the discharged battery.
MS12021b
4. Put in a new battery with positive (+)
side up.
Close the cover securely.
NOTICE
zMake sure the positive side and
negative side of the battery are
faced correctly.
zDo not replace the battery with wet
hands. Water may cause unexpected
rust.
zDo not touch or move any compo-
nents inside the transmitter, or it
may interfere with proper operation.
zBe careful not to bend the electrode
when inserting the battery and that
dust or oils do not adhere to the
cover.
zTake care not to lose the screw.
zClose the cover securely.
After replacing the battery, check that the
key operates properly. If the key still does
not operate properly, contact any autho-
rized Toyota dealer or repairer, or another
duly qualified and equipped professional.
AYGO WE 99E37E11 02.18

11 6LIGHTS, WIPERS AND DEFOGGER
Headlights and turn signals
MS14001b
HEADLIGHTS
To turn on the following lights: Twist
the headlight/turn signal lever knob.
Position 1—Position, tail, license plate and
instrument panel lights
Position 2—Headlights and all of the
above
However, on some models, all the lights
above also turn on when the engine is
started with the headlight switch off.
The headlight low beam indicator light
(green light) on the instrument cluster will
tell you that the low beams are on.
Adjust the headlight beam level before
turning on the headlights. (See “Headlight
beam level control” on page 117.)
Light reminder buzzer
A buzzer will remind you to turn the lights
off when the driver ’s door is opened if the
engine switch is turned to the “LOCK”
position with the headlights switch on.
NOTICE
To prevent the battery from being dis-
charged, do not leave the lights on
for a long period when the engine is
not running.
MS14002b
High−Low beams—For high beams, turn
the headlights on and push the lever away
from you (position 1). Pull the lever to-
ward you (position 2) for low beams.
The headlight low beam indicator light
(green light) on the instrument cluster will
tell you that the low beams are on.
The headlight high beam indicator light
(blue light) on the instrument cluster will
tell you that the high beams are on.
Flashing the high beam headlights
(position 3)—Pull the lever all the way
back. The high beam headlights turn off
when you release the lever.
You can flash the high beam headlights
with the knob turned to “OFF”.
AYGO WE 99E37E11 02.18

11 8LIGHTS, WIPERS AND DEFOGGER
"Vehicle category M1
∗
Loading condition
Indication
figure of
control switch
Driver only or
Driver + one
passenger in the front
seat.
0
All passengers.1
All passengers and
Full luggage loading
to the luggage room.
2
Driver and
Full−luggage loading
to the luggage room.
3
"Vehicle category N1∗
Loading condition
Indication
figure of
control switch
Driver only0
Driver and
Full−luggage loading
to the luggage room
2
∗: To distinguish the vehicle category, ask
any authorized Toyota dealer or repair-
er, or another duly qualified and
equipped professional.
Emergency flashers
MS14005a
To turn on the emergency flashers,
push the switch.
All the turn signal lights will flash. To turn
them off, push the switch once again.
Turn on the emergency flashers to warn
other drivers if your vehicle must be
stopped where it might be a traffic hazard.
Always pull as far off the road as pos-
sible.
The turn signal light switch will not work
when the emergency flashers are operat-
ing.
NOTICE
To prevent the battery from being dis-
charged, do not leave the switch on
longer than necessary when the en-
gine is not running.
AYGO WE 99E37E11 02.18

LIGHTS, WIPERS AND DEFOGGER121
Rear window defogger
MS14010a
To defog or defrost the rear window,
push the switch.
The engine switch must be in the “ON”
position.
The thin heater wires on the inside of the
rear window will quickly clear the window
surface. An indicator light will illuminate to
indicate the defogger is operating.
Push the switch once again to turn the
defogger off.
Make sure you turn the defogger off when
the window surface is clear. Leaving the
defogger on for a long time could cause
the battery to discharge, especially during
stop−and−go driving. The defogger is not
designed for drying rain water or for melt-
ing snow.
NOTICE
zTo prevent the battery from being
discharged, turn the switch off
when the engine is not running.
zWhen cleaning the inside of the
rear window, be careful not to
scratch or damage the heater wires
or connectors.
AYGO WE 99E37E11 02.18

138ENGINE (IGNITION) SWITCH, TRANSMISSION AND PARKING BRAKE
Engine (ignition) switch
MS16003c
“START”—Starter motor on. The key
will return to the “ON” position when
released.
For starting tips, see page 209 in Section
3.
“ON”
—Engine on and all accessories on.
This is the normal driving position.“ACC”—Accessories such as the radio
operate, but the engine is off.
“LOCK”—Engine is off and the steering
wheel is locked. The key can be re-
moved only at this position.
When the engine switch is turned from the
“ACC” to the “LOCK” position or 20 sec-
onds have elapsed since the engine
switch is turned from the “ON” to the
“ACC” position, the engine immobilizer
system is automatically set. (See “Engine
immobilizer system” onpage 13 in Section
1−2.)
When starting the engine, the engine
switch may seem stuck at the “LOCK”
position. To free it, first be sure the key
is pushed all the way in, and then rock
the steering wheel slightly while turning
the key gently.
It is not a malfunction if the needles on
all meters and gauges move slightly when
the engine switch is turned to the “ACC”,
“ON” or “START” position.
CAUTION
Never remove the key when the ve-
hicle is moving, as this will lock the
steering wheel and result in loss of
steering control.
NOTICE
Do not leave the engine switch in the
“ON” position if the engine is not
running. The battery will discharge
and the ignition could be damaged.
11 02.18
AYGO WE 99E37E

AUDIO SYSTEM165
123456(Preset buttons)
These buttons are used to preset and
tune in radio stations.
To preset a station to a button: Tune in
the desired station. (See “TUNE/TRACK”
button). Push and hold down the button
until you hear a beep—this will set the
station to the button. The button number
will appear on the display.
To recall a preset station: Push the button
for the station you want. The button num-
ber and station frequency will appear on
the display.
These systems can store one AM and
three FM station for each button. (The
display will show “AM”, “FM1”, “FM2” or
“FM3” when you push “AM/FM”.) The pre-
set station memory will be canceled out
if the power source is interrupted. (Battery
disconnected or fuse blown.)
(Eject button)
Push this button to eject a compact disc.
After you turn the engine switch to
“LOCK”, you will be able to eject a com-
pact disc but you will not be able to rein-
sert it.
TUNE/TRACK (Tuning/Track up/down)
Radio
Tuning:
Quickly push and release the “”or“”
button. Each time you push the button,
the radio will step up or down to another
frequency. If you hear a beep, you held
the button too long and the radio will go
into the seek mode.Seeking:
Push and hold the “”or“” until you
hear a beep. The radio will begin seeking
up or down for a station of the nearest
frequency and will stop on reception. Each
time you push the button, the stations will
be searched automatically one after anoth-
er.
Compact disc player
By using this button, you can either skip
up/down to a different track or fast for-
ward/reverse the track you are listening
to.
Skip up/down tracks:
Quickly push and release the “”or“”
button. The track number will appear on
the display. If you hear a beep, you held
the button too long, and the player will
fast forward or reverse a track.
Fast forward/reverse tracks:
Push and hold the “
”or“” until
you hear a beep. While you are holding
the button, the player will fast forward/re-
verse the track. When you release the
button, the player will resume playing.
“
”(Power)
Push “
” to turn the audiosystem on
and off. The audio power can be turned
on only once even when the key is not
in the engine switch. The power, however,
will automatically turn off when 30 minutes
have elapsed.
VOL (Volume)
The volume can be adjusted by pushing
the “”or“” button.
AYGO WE 99E37E11 02.18

AIR CONDITIONING SYSTEM181
CAUTION
To prevent the windshield from fog-
ging up, do not select the windshield
air outlets during cool air operation
in extremely humid weather. The dif-
ference between the temperature of
the outside air and that of the wind-
shield can cause the outer surface of
the windshield to fog up, blocking
your vision.
NOTICE
To prevent battery discharge, do not
leave the air conditioning system on
longer than necessary when the en-
gine is stopped.
Heating
For best results, set controls to:
With air conditioning—
Fan speed—Any setting except
“”(OFF)
Temperature—To w a r d sWARM
(red zone)
Air intake—FRESH(outside air)
Air flow—FLOOR
Air conditioning—OFF
Without air conditioning—
Fan speed—Any setting except
“”(OFF)
Temperature—To w a r d sWARM
(red zone)
Air flow—FLOOR
DWith air conditioning:For quick heat-
ing, select recirculated air for a few
minutes. To keep the windows from
fogging, select fresh after the vehicle
interior has been warmed.
DWith air conditioning:Press the “A/C”
button on for dehumidified heating.
DWith air conditioning:Choose floor/
windshield air flow to heat the vehicle
interior while defrosting or defogging
the windshield.
Air conditioning (with air conditioning)
For best results, set controls to:
Fan speed—Any setting except
“”(OFF)
Temperature—To w a r d sCOLD
(blue zone)
Air intake—FRESH(outside air)
Air flow—PANEL
Air conditioning—ON
DFor quick cooling, move the air intake
selector to recirculate for a few min-
utes.
AYGO WE 99E37E11 02.18

188OTHER EQUIPMENT
Clock
MS19005a
Before adjusting the clock.
Push the “CLOCK” button until you hear
a beep.
To reset the hour: Push the “” button.
To reset the minutes: Push the “” but-
ton.
The engine switch must be in the “ACC”
or “ON” position.
If the electrical power source has been
disconnected from the clock, the time dis-
play will automatically be set to 1:00.
When the instrument panel lights are
turned on, the brightness of the time in-
dication will be reduced.
Turning the system on and off
Push “
” (Power) to turn the audio sys-
tem on and off. The audio power can be
turned on only once even when the key
is not in the engine switch. The power,
however, will automatically turn off when
30 minutes have elapsed.
Power outlet
MS19006a
The power outlet is designed as a pow-
er supply for car accessories. To use
the power outlet, open it as shown in
the illustration.
The engine switch must be in the “ACC”
or “ON” position to be used.
NOTICE
zTo prevent the fuse from being
blown, do not use more electricity
than the total vehicle capacity of
12V/120W.
zTo prevent the battery from being
discharged, do not use the power
outlet for longer than necessary
when the engine is not running.
zClose the power outlet lid when the
power outlet is not in use. Inserting
anything other than an appropriate
plug that fits the outlet, or allowing
any liquid to get into the outlet may
cause electrical failure or short cir-
cuits.
zDo not turn car accessory plugs
when they are inserted into the
power outlet. Doing so may damage
the power outlet, depending on the
plug shape.
AYGO WE 99E37E11 02.18