fog light TOYOTA AYGO 2021 User Guide
[x] Cancel search | Manufacturer: TOYOTA, Model Year: 2021, Model line: AYGO, Model: TOYOTA AYGO 2021Pages: 546, PDF Size: 81 MB
Page 238 of 546

2364-3. Operating the lights and wipers
AYGO_OM_Europe_OM9A012E
Rear fog light switch
Turns the rear fog lights off
Turns the rear fog lights on
On some models: Releasing the
switch ring returns it to  .
Operating the switch ring again
turns only the rear fog lights off.
■Fog lights can be used when
Vehicles with a front and rear fog light switch
Front fog lights: The headlights or the front position lights are turned on.
Rear fog lights: The front fog lights are turned on.
Vehicles with a rear fog light switch
The headlights are turned on.
1
2 
Page 251 of 546

2494-5. Toyota Safety Sense
4
Driving
AYGO_OM_Europe_OM9A012E
WARNING
■To avoid malfunction of the front sensor Observe the following precautions. 
Otherwise, the front sensor may not  operate properly, possibly leading to an 
accident resulting in death or serious injury. 
● Keep the windshield clean at all times. If the windshield is dirty or covered 
with an oily film, water droplets, snow, etc., clear the windshield. If the 
inner side of the windshield in front of  the front sensor is dirty, contact any 
authorized Toyota retailer or Toyota authorized repairer, or any reliable 
repairer. 
● If there is a large difference in temperature between the inside and outside 
of the vehicle, such as in winter, t he windshield is likely to fog up easily. If 
the part of the windshield in front of  the front sensor is fogged up or cov- 
ered with condensation or ice, the PCS warning light may illuminate and 
the system may be temporarily disabled.  In this case, use the windshield 
defogger to remove the fog, etc. ( P. 354, 360)
●Do not attach objects, such as stickers, 
transparent stickers, etc., and so forth,
to the outer side of the windshield in 
front of the front sensor (shaded area in 
the illustration). 
A: From the top of the windshield to 
approximately 10 cm (4.0 in.) below 
the bottom of the front sensor 
B: Approximately 20 cm (7.9 in.) 
(Approximately 10 cm [4.0 in.] to the 
right and left from the center of the
front sensor) 
● Do not install or attach anything to the 
inner side of the windshield under the 
front sensor (shaded area in the illustra-
tion). 
A: Approximately 10 cm (4.0 in.) (Start- 
ing from the bottom of the front sen-
sor) 
B: Approximately 20 cm (7.9 in.) 
(Approximately 10 cm [4.0 in.] to the
right and left from the center of the 
front sensor) 
Page 252 of 546

2504-5. Toyota Safety Sense
AYGO_OM_Europe_OM9A012E
WARNING
●If the area of the windshield in front of the front sensor is covered with 
water droplets, use the windshield wipers to remove them.  
If the water droplets are not sufficiently removed, the performance of the
front sensor may be reduced. 
● If water droplets cannot be properly removed from the area of the wind- 
shield in front of the front sensor  by the windshield wipers, replace the 
wiper insert or wiper blade.  
If the wiper inserts or wiper blades need to be replaced, contact any autho- 
rized Toyota retailer or Toyota authorized repairer, or any reliable repairer. 
● Do not attach window tinting to the windshield. 
● Replace the windshield if it is damaged or cracked.  
If the windshield needs to be replaced, contact any authorized Toyota 
retailer or Toyota authorized repairer, or any reliable repairer. 
● Do not install an antenna in front of the sensor. 
● Do not get the front sensor wet. 
● Do not allow bright lights to shine into the front sensor. 
● Do not dirty or damage the front sensor.  
When cleaning the inside of the windshi eld, do not allow glass cleaner to 
contact the lens. Also, do not touch the lens.  
If the lens is dirty or damaged, contact any authorized Toyota retailer or 
Toyota authorized repairer, or any reliable repairer. 
● Do not subject the front sensor to a strong impact. 
● Do not change the installation position or direction of the front sensor or 
remove it. 
● Do not disassemble the front sensor. 
● Do not install an electronic device or device that emits strong electric 
waves near the front sensor. 
● Do not modify any components of the vehicle around the front sensor 
(inside rear view mirror, sun visors, etc.) or ceiling. 
● Do not attach any accessories that may obstruct the front sensor to the 
hood, front grille or front bumper. C ontact any authorized Toyota retailer or 
Toyota authorized repairer, or any reliable repairer for details. 
● If a surfboard or other long object is to be mounted on the roof, make sure 
that it will not obstruct the front sensor. 
● Do not modify the headlights or other lights. 
● Do not attach anything to or place anything on the dashboard. 
■ Installation area of front sensor on windshield 
When the windshield is fogging up easily, the glass around the front sensor 
may be hot due to the heater running. If the glass is touched, it may result in 
burns. 
Page 263 of 546

2614-5. Toyota Safety Sense
4
Driving
AYGO_OM_Europe_OM9A012E 
• When the vehicle is hit by water, snow, dust, etc. from a vehicle ahead 
• When driving through steam or smoke that may obscure vehicles ahead 
• When driving in a place where the surrounding brightness changes sud- 
denly, such as at the entrance or exit of a tunnel 
• While driving on a curve and for a certain amount of time after driving on 
a curve 
• When a vehicle ahead is not directly 
in front of your vehicle 
• When driving in inclement weather 
such as heavy rain, fog, snow or a 
sand storm 
• When a very bright light, such as the 
sun or the headlights of oncoming 
traffic, shines directly into the front
sensor 
• When the surrounding area is dim, 
such as at dawn or dusk, or while at 
night or in a tunnel 
Page 265 of 546

2634-5. Toyota Safety Sense
4
Driving
AYGO_OM_Europe_OM9A012E■If the PCS warning light flashes or illuminates
The pre-collision system may be temporarily unavailable or there may be a
malfunction in the system.
●In the following situations, the warning light will be cleared and the system
will become operational when normal operating conditions return:
• When the area around the front sensor is hot, such as after the vehicle
has been parked in the sun
• When the windshield is fogged up or covered with condensation or ice
(P. 354, 360)
• When driving in conditions where the front sensor cannot detect an
object, such as in the dark (at night on a road without street lights or other
lights, etc.), when bright light is shining into the sensor, or in snow or fog.
• When the front sensor or the area around either sensor is cold, such as in
an extremely cold environment
• If the area in front of the front sensor is obstructed, such as when the
hood is open
●If the PCS warning light continues to flash or illuminate, the system may be
malfunctioning. Have the vehicle inspected by any authorized Toyota retailer
or Toyota authorized repairer, or any reliable repairer immediately.
■If VSC is disabled
●If TRC and VSC are disabled (P. 280), the pre-collision brake assist and
pre-collision braking functions are also disabled. However, the pre-collision
warning function will still operate.
●The PCS warning light illuminates. 
Page 269 of 546

2674-5. Toyota Safety Sense
4
Driving
AYGO_OM_Europe_OM9A012E■Conditions in which the function may not operate correctly
In the following situations, the front sensor may be unable to recognize lane
markers causing the lane departure warning function to operate incorrectly.
However, this does not indicate a malfunction.
●When driving through an area, such as a tollbooth, a crossing or before a
ticket checkpoint
●When driving on a sharp curve
●When lane markers are extremely narrow or extremely wide
●When the vehicle leans to one side an unusual amount due to a heavy load
or improper tire inflation pressure
●When the following distance between your vehicle and the vehicle ahead is
extremely short
●When the lane markers are yellow (These may be more difficult for the sys-
tem to recognize compared to white markers.)
●When the lane markers are broken, Botts’ dots (raised pavement markers)
or stones
●When the lane markers are on a curb etc.
●When lane markers are obscured or partially obscured by sand, dirt, etc.
●When there are shadows on the road running parallel with lane markers, or
if a shadow covers the lane markers
●When driving on a particularly bright road surface, such as concrete
●When driving on a road surface that is bright due to reflected light
●When driving in a location where the light level changes rapidly, such as the
entrance to or exit from a tunnel
●When sunlight or the headlights of oncoming vehicles are shining directly
into the camera lens
●When driving on roads that are branching or merging
●When driving on a road surface that is wet due to rain, previous rainfall,
standing water, etc.
●When the vehicle experiences strong up-and-down motion such as when
driving on an extremely rough road or on a seam in the pavement
●When headlight brightness at nighttime is reduced due to dirt on the lenses,
or when the headlights are misaligned
●When driving on winding roads or roads that are uneven
●When driving on rough or unpaved roads
●When the windshield is dirty, or if raindrops, condensation or ice are adher-
ing to the windshield
●When the heater is blowing to the feet, the upper part of the windshield may
get fogged up and have a negative effect
●When cleaning the inside of the windshield, touching the lens or getting
glass cleaner on the lens may have a negative effect 
Page 353 of 546

351
6Interior features
AYGO_OM_Europe_OM9A012E6-1. Using the air conditioning 
system and defogger
Manual air conditioning 
system ............................. 352
Automatic air conditioning 
system ............................. 358
Seat heaters ...................... 364
6-2. Using the interior lights
Interior lights list ................. 366
• Interior light.................... 366
6-3. Using the storage features
List of storage features ...... 367
• Glove box ...................... 368
• Card holders .................. 368
• Cup holders ................... 368
• Bottle holders ................ 369
Luggage compartment 
features............................ 371
6-4. Other interior features
Other interior features ........ 373
• Sun visors...................... 373
• Vanity mirrors ................ 373
• Clock ............................. 374
• Outside temperature 
display ........................... 375
• Power outlet .................. 376 
Page 366 of 546

3646-1. Using the air conditioning system and defogger
AYGO_OM_Europe_OM9A012E
Seat heaters
Turns seat heater on
The indicator light comes on.
■The seat heaters can be used when
Vehicles without a smart entry & start system
The engine switch is in the “ON” position.
Vehicles with a smart entry & start system
The engine switch is in IGNITION ON mode.
■When not in use
Turn the seat heater off by pressing the switch. The indicator light turns off.
: If equipped 
Page 386 of 546

3847-1. Maintenance and care
AYGO_OM_Europe_OM9A012E
NOTICE
■Cleaning detergents 
● Do not use the following types of detergent, as they may discolor the vehi- 
cle interior or cause streaks or damage to painted surfaces: 
• Non-seat portions: Organic substances such as benzene or gasoline, 
alkaline or acidic solutions, dye, and bleach
• Seats: Alkaline or acidic solutions, such as thinner, benzene, and alcohol 
● Do not use a polish wax or polish cleaner. The instrument panel’s or other 
interior part’s painted surface may be damaged. 
■ Preventing damage to leather surfaces 
Observe the following precautions to avoid damage to and deterioration of 
leather surfaces: 
● Remove any dust or dirt from leather surfaces immediately. 
● Do not expose the vehicle to direct sunlight for extended periods of time. 
Park the vehicle in the shade, especially during summer. 
● Do not place items made of vinyl, plastic, or containing wax on the uphol- 
stery, as they may stick to the leather surface if the vehicle interior heats 
up significantly. 
■ Water on the floor 
Do not wash the vehicle floor with water. 
Vehicle systems such as the audio system may be damaged if water comes 
into contact with electrical components such as the audio system above or 
under the floor of the vehicle. Water may also cause the body to rust. 
■ When cleaning the inside of the windshield (vehicles with front sensor) 
Be careful not to touch the front sensor ( P. 246). 
If the camera is accidentally scratched or hit, PCS and LDA may not oper-
ate properly or may cause a malfunction. 
■ Cleaning the inside of the rear window 
● Do not use glass cleaner to clean the rear window, as this may cause 
damage to the rear window defogger heater wires. Use a cloth dampened 
with lukewarm water to gently wipe the window clean. Wipe the window in
strokes running parallel to the heater wires. 
● Be careful not to scratch or damage the heater wires. 
Page 424 of 546

4227-3. Do-it-yourself maintenance
AYGO_OM_Europe_OM9A012E
*1: Vehicles with a multi-mode manual transmission
*2: Vehicles with a Stop & Start system
*3: Replace the fuse with one of the same ampere rating as the original
26EPS50Electric power steering system
27RDI NO.130*3
Electric cooling fan40*3
28ABS NO.150Anti-lock brake system, vehicle stability
control system
29SPARE10Spare fuse
30SPARE20Spare fuse
31SPARE30Spare fuse
32DEF20Rear window defogger, outside rear view
mirror defoggers
33ABS NO.230Anti-lock brake system, vehicle stability
control system
34FOG FR7.5Front fog lights, gauges and meters
35DRL7.5Daytime running lights
36S/HTR F/R15Seat heaters (right side)
37CANVAS TOP20Canvas top
38S/HTR F/L15Seat heaters (left side)
FuseAmpereCircuit