warning light TOYOTA CAMRY 2020 Owners Manual (in English)

4
For details, refer to “Indicators and warning lights,” Section 2, \�2020 Owner’s
Manual.
Airbag SRS warning1
OVERVIEWInstrument cluster
Automatic High Beam (AHB)
indicator1
Blind Spot Monitor (BSM)
indicator4
Anti-lock Brake System (ABS)
warning1
AIRBAG ON/OFF indicator Type A1
AIRBAG ON/OFF indicator Type B1
Indicator symbols
TachometerTachometer
Outside temperature
Outside temperature Speedometer
Speedometer
Odometer/trip meter
Odometer/trip meter
Shift position
Shift position Fuel gauge
Fuel gauge
Multi-information display
Multi-information display
Engine coolant temperature display
Engine coolant temperature display Instrument panel light control
Instrument panel light control
Service indicators and reminders
4.2-inch display
7-inch display

5
Full-Speed Dynamic Radar Cruise
Control (DRCC) indicator/DRCC
SET indicator
Brake system warning1
Malfunction/
Check Engine indicator1
Driver’s and front passenger’s seat belt
reminder (alarm will sound when the
engine switch is “ON” position*/
”IGNITION ON”** mode)
Low Tire Pressure Warning1
Low fuel level warning
Security indicator
Fuel tank door position Master warning
1,2
Headlight low/high
beam indicators
Turn signal indicator
Pre-Collision System (PCS)
warning light1,2
Slip indicator1,3
Vehicle Stability Control (VSC)
OFF indicator1
Eco driving indicator1
Parking brake indicator2
Rear passenger seat belt reminder
indicator Type A
Rear passenger seat belt reminder
indicator Type B
Brake hold operated indicator1,2,4
Brake hold standby indicator1
BSM w/Rear Cross Traffic Alert
(RCTA) Indicator4
BSM outside rear view mirror
indicators4
Brake system warning
(yellow indicator)1,4
Lane Departure Alert (LDA) indicator
(white/green/yellow3)
Electric power steering warning1
(red/yellow indicator)
Sport mode driving indicator4
ECO MODE indicator4
Low outside temperature indicator
Constant speed cruise control
indicator/Constant speed
cruise control SET indicator
1 If the indicator does not turn off within a few seconds of starting the \�engine, there may be a
malfunction. Have the vehicle inspected by your Toyota dealer.
2 If the indicator flashes, there may be a malfunction. Refer to the Owner\�’s Manual.3 If the indicator flashes, it indicates that the system is operating.4 If equipped.
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES
* Vehicles without a Smart Key system
** Vehicles with a Smart Key system

38
TOYOTA SAFETY SENSE™
ADJUSTING DISTANCE
To change the vehicle-to-
vehicle distance

Push the “
” button
to cycle through the
settings, which will change
progressively.
This mode employs a radar sensor to detect the presence of a preceding v\�ehicle
up to approximately 328 ft (100 m) ahead, determines the current vehicle-to-vehicle
following distance and operates to maintain a preset following distance \�from the
vehicle ahead. These distances vary based on vehicle speed.
(1) (2) (3)
(1) Constant speed cruising when there are no vehicles ahead
The vehicle travels at the speed set by the driver. The desired vehicle-\�to-

vehicle distance can also be set by operating the vehicle-to-vehicle dis\�tance
control.
(2) Deceleration cruising and follow-up cruising when a preceding vehicle

driving slower than the set speed appears
When a vehicle is detected running ahead of you, the system automaticall\�y
decelerates your vehicle. When a greater reduction in vehicle speed is
necessary, the system applies the brakes (the brake lights will come on at this
time). The system will respond to changes in the speed of the vehicle ahead
in order to maintain the vehicle-to-vehicle distance set by the driver. \�A warning
tone warns you when the system cannot decelerate sufficiently to prevent\� your
vehicle from closing in on the vehicle ahead.
Note: Vehicle-to-vehicle distance will close in when traveling on long downhill
slopes.
LONG
(default setting)MIDDLE SHORT
Preceding
vehicle mark

45
Tire Pressure Monitoring (warning) System (TPMS)
The tire pressure detected by the tire pressure warning system can
be displayed on the multi-information display (MID).
Refer to the load label on the door jamb or the Owner’s Manual for ti\�re inflation
specifications.

If the tire pressure indicator flashes for more than 60 seconds and then\� remains on,
take the vehicle to your local Toyota dealer.
NOTE:
The warning light may come on due to temperature changes or
changes in tire pressure from natural air leakage. If the system has not been
initialized recently, setting the tire pressures to factory specifications should
turn off the light.
The tire pressure warning system can be selected on “” of the multi-
information display (MID).
System rest initialization
(1) Select “Vehicle Settings” and then push “” (4.2-inch display)/“” and then
push and hold “
” (7-inch display.)
(2) Select “TPWS” and then push “
”.
(3) Select “Set Pressure” then push and hold “
” until the warning light blinks
three times.
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES
4.2-inch display 7-inch display