audio TOYOTA HIGHLANDER 2011 XU40 / 2.G Navigation Manual

AUDIO/VIDEO SYSTEM
234
Push or select “Set Up” to dis-
play the initial setting screen.
The following initialization can be
changed here.
“Audio Language”
“Subtitle Language”
“DVD Language”
“Angle Mark”
“Parental Lock”
Changing the audio language
Select “Audio Language”. Select the
language you want to hear, and push
“ENT” to input it.
Select “Others” if you cannot find the
language you want to hear. Enter the
appropriate 4digit language code. Se-
lect a number, and push “ENT” to input
it.
Language code list
If a code that is not in the list is entered, “In-
correct Code” will appear on the screen.
(See page 201.)
— Changing the initial
setting

AUDIO/VIDEO SYSTEM
235

Changing the subtitle language
Select “Subtitle Language”. Select the
language you want to read, and push
“ENT” to input it.
Select “Others” if you cannot find the
language you want to read. Enter the
appropriate
4digit language code. Se-
lect a number, and push “ENT” to input
it.
Language code list
If a code that is not in the list is entered, “In-
correct Code” will appear on the screen.
(See page 201.)
Changing the DVD language
Select “DVD Language”. Select the lan-
guage you want to read and push
“ENT” to input it.
Select “Others” if you cannot find the
language you want to read. Enter the
appropriate 4digit language code. Se-
lect a number, and push “ENT” to input
it.
Language code list
If a code that is not in the list is entered, “In-
correct Code” will appear on the screen.
(See page 201.)

AUDIO/VIDEO SYSTEM
236

Turning on or off the angle mark
The angle mark can be turned on for
discs that are multiangle compatible.
Each time you push “ENT” when “Angle
Mark” is selected, the angle mark turns on
or off alternately.Setting viewer restriction levels
Setting a password allows the viewer
restriction to be effective.
Select “Parental Lock”. Enter the pass-
word and push “ENT”. The setting can-
not be changed unless the password is
entered.
When you forget the password, initialize
the password. (See page 237.)
Select a restriction level (18), and
push “ENT”. The smaller the level num-
ber, the stricter the age limit.

AUDIO/VIDEO SYSTEM
237

Setting the display mode
Pushing changes the display
modes sequentially as follows:
Normal → “Wide 1” →Wide 2
Returning to the previous screen
Select “BACK” , and push “ENT” .
To initialize the password
Push  on the remote controller or unit ten
times when the screen to enter the person-
al code is displayed.
Adjusting the screen
Push .
Select the brightness, contrast, tone or col-
or, and make adjustments. Push
or
“ENT” to input it.
Brightness, contrast, tone and color
adjustment
“Brightness” “+”:
Brightens the screen.
“Brightness” “”:
Darkens the screen.
“Contrast” “+”:
Strengthens the contrast of the screen.
“Contrast” “”:
Weakens the contrast of the screen.
“Tone” “+”: Strengthens the tone of the
screen.
“Tone” “”: Weakens the tone of the
screen.
“Color” “Red”:
Strengthens the red color of the screen.
“Color” “Green”:
Strengthens the green color of the screen.

AUDIO/VIDEO SYSTEM
238
Necessary item for replacing “3 AA bat-
teries”.
1. Remove the cover.
2. Remove the depleted batteries and
install new 3 AA batteries. If the batteries are discharged, the fol-
lowing symptoms may occur.
The rear seat entertainment system
control will not function properly.
The operational range is reduced.
When using 3 AA batteries
Batteries can be purchased at your
Toyota dealer, electric appliance shop,
or camera stores.
Replace only with the same or equiva-
lent type recommended by a Toyota
dealer.
Dispose of used batteries according to
the local laws.
CAUTION
Removed battery and other parts:
Keep away from children.
These parts are small and if swal-
lowed by a child they can cause
choking.
NOTICE
For normal operation after replacing
the battery. Observe the following
precautions to prevent accidents:
Always work with dry hands. Mois-
ture may cause the battery to rust.
Do not touch or move any other
components inside the remote
controller.
Do not bend either of the battery
terminals.
— Replacing the batteries

AUDIO/VIDEO SYSTEM
239
NOTICE
To ensure correct audio/video sys-
tem operations:
Be careful not to spill beverages
over the audio/video system.
Do not put anything other than a
compact disc into the slot.
Do not put anything other than an
appropriate disc into the CD
changer or DVD player.
The use of a cellular phone inside
or near the vehicle may cause a
noise from the speakers of the au-
dio system which you are listening
to. However, this does not indicate
a malfunction.
RADIO RECEPTION
Usually, a problem with radio reception
does not mean there is a problem with your
radio — it is just the normal result of condi-
tions outside the vehicle.
For example, nearby buildings and terrain
can interfere with FM reception. Power
lines or telephone wires can interfere with
AM signals. And of course, radio signals
have a limited range. The farther you are
from a station, the weaker its signal will be.
In addition, reception conditions change
constantly as your vehicle moves.
Here are some common reception prob-
lems that probably do not indicate a prob-
lem with your radio: FM
Fading and drifting stations — Generally,
the effective range of FM is about 25 miles
(40 km). Once
outside this range, you may
notice fading and drifting, which increase
with the distance from the radio transmit-
ter. They are often accompanied by distor-
tion.
Multi−path — FM signals are reflective,
making it possible for two signals to reach
your antenna at the same time. If this hap-
pens, the signals will cancel each other
out, causing a momentary flutter or loss of
reception.
Static and fluttering — These occur when
signals are blocked by buildings, trees, or
other large objects. Increasing the bass
level may reduce static and fluttering.
Station swapping — If the FM signal you
are listening to is interrupted or weakened,
and there is another strong station nearby
on the FM band, your radio may tune in the
second station until the original signal can
be picked up again.
AM
Fading — AM broadcasts are reflected by
the upper atmosphere — especially at
night. These reflected signals can inter-
fere with those received directly from the
radio station, causing the radio station to
sound alternately strong and weak.
Station interference — When a reflected
signal and a signal received directly from
a radio station are very nearly the same
frequency, they can interfere with each
other, making it difficult to hear the broad-
cast.
Static — AM is easily affected by external
sources of electrical noise, such as high
tension power lines, lightening, or electri-
cal motors. This results in static.
Audio/video system
operating hints

AUDIO/VIDEO SYSTEM
240
XM
Cargo loaded on the roof luggage carrier,
especially metal objects, may adversely
affect the reception of XM  Satellite Radio.
Alternation or modifications carried out
without appropriate authorization may in-
validate the user’s right to operate the
equipment.
iPod
About iPod —
Apple is not responsible for the opera-
tion of this device or its compliance with
safety and regulatory standards.
iPod is a trademark of Apple Inc., regis-
tered in the U.S. and other countries.
Compatible models —
Model
GenerationSoftware version
iPod5th
generationVer. 1.2.0 or
higher
iPod
nano1st
generationVer. 1.3.0 or
higher
2nd
generationVer. 1.1.2 or
higher
3rd
generationVer. 1.0.0 or
higher
iPod
touch1st
generationVer. 1.1.0 or
higher
iPod
classic1st
generationVer. 1.0.0 or
higher
Depending on differences between mod-
els or software versions etc., some models
listed above might be incompatible with
this system.
iPod 4th generation and earlier models are
not compatible with this system.
iPhone, iPod mini, iPod shuffle and iPod
photo are not compatible with this system. USB memory
USB memories that can be used for MP3
and WMA playback.
USB communication formats: USB 2.0
FS (12 MBPS)
File formats: FAT 16/32 (Windows)
Correspondence class: Mass storage
class

AUDIO/VIDEO SYSTEM
241
CARING FOR YOUR CD CHANGER,
DVD PLAYER AND DISCS
Your CD changer is intended for use
with 4.7 in. (12 cm) discs only.
Extremely high temperatures can keep
your CD changer and DVD player from
working. On hot days, use the air
conditioning to cool the vehicle interior
before you use the changer and player.
Bumpy roads or other vibrations may
make your CD changer and DVD play-
er skip.
If moisture gets into your CD changer
and DVD player, you may not play even
though they appear to be working. Re-
move the disc from the changer and
player and wait until it dries.
CAUTION
CD changer and DVD player use an
invisible laser beam which could
cause hazardous radiation exposure
if directed outside the unit. Be sure to
operate the changers and players
correctly.
XS18016
CD changer
Use only discs marked as shown abo-
ve. The following products may not be
playable on your changer.
Copy− protected CD
CD−ROM

AUDIO/VIDEO SYSTEM
242
Audio CDs
DVD video
discs
Video CDs
DVD player
Use only discs marked as shown abo-
ve. The following products may not be
playable on your player.
SACD
Copy−protected CD
CD−ROM
DVD−R
DVD+R
DVD−RW
DVD+RW
DVD−ROM
DVD−RAM
DVD−Audio
6U5B93X
 Special shaped discs
6U5B95X
Transparent/translucent discs
6U5B94X
Low quality discs

AUDIO/VIDEO SYSTEM
243
6U5B96X
Labeled discs
NOTICE
Do not use special shaped, trans-
parent/translucent, low quality or
labeled discs such as those shown
in the illustrations. The use of such
discs may damage the player or
changer, or it may be impossible to
eject the disc.
This system is not designed for use
of Dual Disc. Do not use Dual Disc
because it may cause damage to
the player or changer.
Do not use a disc with protection
ring. The use of such disc may
damage the player or changer, or it
may be impossible to eject the
disc.
If a disc cannot be ejected, do not
forcibly take out the disc. Keep
pushing the “LOAD· /CLOSE”
button for approximately 5 sec-
onds and release it. At this time,
the audio disc and the map DVD
ROM will be ejected.
6U5B97X
Correct Wrong
Handle discs carefully, especially
when you are inserting them. Hold
them on the edge and do not bend the-
m. Avoid getting fingerprints on them,
particularly on the shiny side.
Dirt, scratches, warping, pin holes, or
other disc damage could cause the
player to skip or to repeat a section of
a track. (To see a pin hole, hold the disc
up to the light.)
Remove discs from the players when
you are not using them. Store them in
their plastic cases away from moisture,
heat, and direct sunlight.