tire pressure reset TOYOTA HIGHLANDER 2019 Owners Manual (in English)

2
Steering wheel controls
Audio remote
control switches2Meter control switches
Dynamic Radar Cruise
Control
(DRCC)
Dynamic Radar
Cruise Control
(DRCC) vehicle-
to-vehicle distance
button
Lane Departure
Alert with Steering
Assist (LDA w/SA)
switch
Tilt and telescopic steering
lock release lever
(below the steering wheel)
Headlight, turn signal and front fog light
1 controls
Windshield wiper and
washer controls
Meter/Multi-information display (MID)
“ENGINE START
STOP” button
(Smart Key)
1
Ignition (Standard Key)1
Hood lock release leverFuel tank door release lever
Tire pressure warning reset switch
Windshield wiper de-icer switch
Heated steering wheel switch
1
Intelligent parking assist switch1,2
Automatic High Beam (AHB) switch
Stop & Start Engine System cancel switch
1
Birds Eye View Camera switch1,2
Power back door switch1
Voice command switch2
Telephone
switches2
OVERVIEWInstrument panel
114709_MY19_Highlander_QRG_V3_ML_0809_R1.indd 28/14/18 1:22 AM

44
SAFETY AND EMERGENCY FEATURES
Unlock
Lock
Rear door child safey locks
Tire Pressure Monitoring (warning) System (TPMS)
Moving the lever to the lock position will allow the door to be opened o\�nly from the
outside.
Rear door
System reset initialization
1. Push and hold “
SET” button
until the indicator blinks three times.
2. Wait a few minutes to allow initialization to complete.
After adjusting tire pressures, or after tires have been rotated or repl\�aced, turn the
ignition switch to “ON” and press and hold the
“ SET” button until indicator blinks
three times. Let the vehicle sit for a few minutes to allow initializati\�on to complete.
Refer to the load label on the door jamb or the Owner’s Manual for ti\�re inflation
specifications.
If the tire pressure indicator flashes for more than 60 seconds and then\� remains on,
take the vehicle to your local Toyota dealer.
NOTE: The warning light may come on due to temperature changes or changes
in tire pressure from natural air leakage. If the system has not been initialized
recently, setting the tire pressures to factory specifications should turn off the
light.
114709_MY19_Highlander_QRG_V3_ML_0809_R1.indd 448/14/18 1:22 AM