ignition TOYOTA HIGHLANDER HYBRID 2020 Owners Manual (in English)

6
Automatic High Beam (AHB)
indicator
For details, refer to “Indicators and warning lights,” Section 2-1, 2020 Owner’s
Manual.
Front Fog light indicator
Constant speed cruise control
indicator/Constant speed
cruise control SET indicator
Electric power steering system
warning [red/Yellow]
Fuel tank door position
Anti-lock Brake (ABS) System
warning1
Airbag SRS warning1
Air Bag ON/OFF indicator1
Brake system warning1 [Yellow]
High coolant temperature warning
Hybrid system overheat warning
Eco drive mode indicator
EV indicator
EV drive mode indicator
Low engine oil pressure warning
Brake Override System/Drive-Start
Control warning
Charging system warning
Brake hold operated indicator1,2
Brake hold standby indicator1
Front and Rear Parking Assist
with Automated Braking OFF
indicator
1,2,4,5,6
Brake system warning1
BSM outside rear view mirror
indicator
Blind Spot Monitor (BSM) OFF
indicator
Driver’s and front passenger’s seat
belt reminder (alarm will sound when
the engine switch is in the ”IGNITION ON”)
Full-Speed Range Dynamic
Radar Cruise Control
indicator/DRCC SET
indicator
Malfunction/Check Engine indicator
1
Low tire pressure warning1
Intuitive parking assist OFF
indicator1,2,4,5
Headlight low/high beam
indicator
Low fuel level warning1
Low outside temperature indicator
Parking brake warning
1,2
Lane Tracing Assist (LTA)/
Lane Departure Alert (LDA) indicator
[white/green/orange
3]
Pre-Collison System (PCS) warning1,2
OVERVIEW Indicator symbols

26
Power supply switch
Charge area
Operation indicator light
Qi Wireless charger (if equipped)
A mobile device can be charged wirelessly on the tray. Push the tab and \�slide the
console box lid. (1) Press the power supply switch and the green operation
indicator light turns on. (2) Place a compatible mobile device on the tray as shown
in the illustration. An amber indicator illuminates while charging is in\� progress.
When charging is complete, the indicator illuminates green. Some phones,\� cases or
cover type wireless chargers may not cause the green indicator to illumi\�nate even
though it is fully charged.
The engine switch must be in the “ACCESSORY” or ”IGNITION ON”\� mode for use.
Refer to the Owner’s Manual for limitations and more details on this \�system before
attempting to use it.
Press (1)
When the engine is turned off, the last state (ON/
OFF) of the charger is memorized.
Place device nearest the center of charging area for
best results. Moving device may result in stopping
or restarting the charging process.
Place (2)
The engine switch must be in the “ACCESSORY” or “IGNITION ON”\� mode for use.
RearFront
USB charge-ports
(Charge only)
(Charge only)
FEATURES & OPERATIONS

27
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES
Power outlets- 12V DC
Power outlets- 120V AC (if equipped)
The engine switch must be in the “ACCESSORY” or “IGNITION ON”\� mode for use.
When the “READY” indicator is illuminated, the power outlet can be\� used.
FrontCenter console Luggage compartment
Luggage compartment
Console box
Console box
LOCATION
CONNECTING A DEVICE
AC120V SWITCH

32
Seat heaters/ventilators
* 12.3-inch display only
Driver and passenger seat heaters -
8-inch display
Seat heaters Driver and passenger seat heaters -
12.3-inch displayDriver and passenger seat ventilators -
8-inch display
VentilatorsDriver and passenger seat ventilators -
12.3-inch display
FRONT - FRONT A/C CONTROL PANEL (IF EQUIPPED)
FRONT - TOYOTA MULTI-OPERATION TOUCH* (IF EQUIPPED)
REAR (SEAT HEATERS ONLY) (IF EQUIPPED)
The engine switch must be in the “IGNITION ON” mode for use.
FEATURES & OPERATIONS

33
Steering wheel-Heater (if equipped)
The engine switch must be in the “IGNITION ON” mode for use.
* Premium Audio/12.3-inch display model
This feature utilizes the vehicle’s built-in microphone to amplify th\�e driver’s voice
through the rear speakers. The feature must be turned on every time you \�enter the
vehicle, and automatically turns off when any door (including the liftg\�ate) is opened.
There are 7 volume settings.
To activate:
(1) Select “MENU” on the Audio Multimedia System and then select\� “Setup”.
(2) Select “Driver Easy Speak” from “Audio” screen.
Driver Easy Speak*
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES
Use EV drive mode when driving short distances to reduce noise late at n\�ight in resi-
dential areas or to cut emissions when parking in a small garage or unde\�rground car
park.
EV drive mode

43
CHANGING PRE-COLLISION ALERT TIMING
DISABLING PRE-COLLISION SYSTEM (PCS)
FarMiddle
(default) Near
(1) Press “” or “” switches and select “” from the Multi-Information Display
(MID).
(2) Press “
” or “” switches and select “ PCS” and then press and hold “.”
(3) Press “
” or “” switches and select “Sensitivity” and then press and hold
“
” to select the desired setting. Each time it is pressed, the response to\� the PCS
alert timing changes as shown above.
(4) Press “
” to go back to the menu.
Note: PCS is enabled each time the engine switch is turned to Ignition O\�n.
The system can be disabled/enabled and the alert timing of the system ca\�n be
changed. (Alert timing only, brake operation remains the same).
(1) Press “
” or “” switches and select “” from the Multi-Information
Display (MID).
(2) Press “
” or “” switches and select “ PCS” and then press and hold “.”
(3) Press “
” or “” switches and select “PCS on/off” and then press “” to
select the desired setting.
(4) Press “
” to go back to the menu.
Note: The system is enabled each time the power switch is turned to ON m\�ode.
Refer to the Toyota Owner’s Manual for additional information on PCS \�operation,
settings adjustments, limitations, and precautions before attempting to \�use it.
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES

44
TOYOTA SAFETY SENSE™
LDA in TSS 2.0 uses an in-vehicle camera designed to detect visible whit\�e and
yellow lane markers or road edge in front of the vehicle and the vehicle\�’s position
on the road. If the system determines that the vehicle is starting to un\�intentionally
deviate from its lane, the system alerts the driver with an audio and vi\�sual alert.
When the alerts occur, the driver must check the surrounding road situat\�ion and
carefully operate the steering wheel to move the vehicle back to the cen\�ter part of
their lane.
LDA is designed to function at speeds of approximately 32 mph (50 km/h)\� or higher
on relatively straight roadways.
In addition to the alert function, LDA w/SA also features a steering ass\�ist
function. When enabled, if the system determines that the vehicle is on \�a path to
unintentionally depart from its lane, the system may provide small corrective steering
inputs to the steering wheel for a short period of time to help keep the\� vehicle in its
lane.
If the vehicle repeatedly deviates from the lane, the vehicle drifts wit\�hin the lane due
to inattention, or the driver abruptly operates the steering wheel after\� an inattentive
period, when enabled, the vehicle sway warning function alerts the drive\�r with an
audio and visual alert, urging them to take a break.
Lane Departure Alert with Steering Assist
(LDA w/SA)
TURNING THE LDA SYSTEM ON/OFF
Press the LDA switch to turn the LDA system on. Depress again to turn it\� off.
Note: Operation of the LDA system and setting adjustments continues in t\�he
same condition regardless of Ignition cycle until changed by the driver \�or the
system is reset.

46
ADJUSTING LDA ALERT SENSITIVITY
DISABLING STEERING ASSIST
TOYOTA SAFETY SENSE™
(1) Press “” or “” switches and select “” from the Multi-Information Display
(MID).
(2) Press “
” or “” switches and select “ LDA” and then press and hold “.”
(3) Press “
” or “” switches and select “Steering Assist” and then press and
hold “
” to select the desired setting.
(4) Press “
” to go back to the menu.
Note: Operation of the LDA system and setting adjustments continues in t\�he
same condition regardless of Ignition cycle until changed by the driver \�or the
system is reset.
The driver can adjust the sensitivity of the LDA (warning) function fr\�om the
Multi-Information Display (MID) customization screen. High - Is designed to warn approximately before the front
tire crosses the lane marker.
Normal - Is designed to warn approximately when the front
tire crosses the lane marker.
(1) Press “
” or “” switches and select “” from the Multi-Information Display
(MID).
(2) Press “
” or “” switches and select “ LDA” and then press and hold “.”
(3) Press “
” or “” switches and select “Sensitivity” and then press and hold
“
” to select the desired setting.
(4) Press “
” to go back to the menu.

47
SWAY WARNING SYSTEM
ADJUSTING SWAY ALERT SENSITIVITY
DISABLING LDA SWAY WARNING ALERT
SWS is a function of LDA and is designed to detect swaying based on the \�vehicle
location in the lane and the driver’s steering wheel operation. To he\�lp prevent
swaying, the system alerts the driver using a buzzer sound and a warning\� displays
in the MID.
Continuous lane deviations from
swaying.
Gentle swaying from driver’s
inattentiveness.
Acute steering wheel operation after the
number of operations decrease due to driver’s
inattentiveness.
(1) Press “” or “” switches and select “” from the Multi-Information Display
(MID).
(2) Press “
” or “” switches and select “ LDA” and then press and hold “.”
(3) Press “
” or “” switches and select “Sway Sensitivity” and then press and
hold “
” to select the desired setting.
(4) Press “
” to go back to the menu.
Refer to the Toyota Owner’s Manual for additional information on LDA \�operation,
settings adjustments, limitations, and precautions before attempting to \�use it. (1) Press “
” or “” switches and select “” from the Multi-Information Display
(MID).
(2) Press “
” or “” switches and select “ LDA” and then press and hold “.”
(3) Press “
” or “” switches and select “Sway Warning” and then press and
hold “
” to select the desired setting.
(4) Press “
” to go back to the menu.
Note: Operation of the LDA system and setting adjustments continues in t\�he
same condition regardless of Ignition cycle until changed by the driver \�or the
system is reset.
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES

48
When enabled, the LTA system’s lane centering function is designed to\�
automatically provide assistance to help keep the vehicle in the center \�of the lane
with Full-Speed Range DRCC set.
TOYOTA SAFETY SENSE™
TURNING THE LTA SYSTEM ON/OFF
Press the LTA switch to turn the LTA system on. Depress again to turn it\� off.
Note: Operation of the LTA system and setting adjustments continues in t\�he
same condition regardless of Ignition cycle until changed by the driver \�or the
system is reset.
Refer to the Toyota Owner’s Manual for additional information on LTA \�operation,
settings adjustments, limitations, and precautions before attempting to \�use it.
Lane Tracing Assist (LTA)